- 您现在的位置：买卖IC网 > PDF目录17644 > ZL2004ALNFT1 (Intersil)IC REG CTRLR BUCK SYNC ADJ 32QFN PDF资料下载
参数资料
| 型号： | ZL2004ALNFT1 |
| 厂商： | Intersil |
| 文件页数： | 20/42页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK SYNC ADJ 32QFN |
| 标准包装： | 1,000 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | * |
| 占空比： | 95% |
| 电源电压： | 4.5 V ~ 14 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | * |
| 包装： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
ZL2004
Once an inductor is selected, the DCR and core losses
in the inductor are calculated. Use the DCR specified
in the inductor manufacturer’s datasheet .
As a starting point, apportion one-half of the output
ripple voltage to the capacitor ESR and the other half
to capacitance, as shown in the following equations:
P LDCR
DCR I Lrms
I opp
I Lrms
I OUT
2
I Lrms is given by
2
2
12
where I OUT is the maximum output current. Next,
calculate the core loss of the selected inductor. Since
C OUT
ESR
I opp
V orip
8 f sw
2
V orip
2 I opp
this calculation is specific to each inductor and
manufacturer, refer to the chosen inductor datasheet.
Add the core loss and the ESR loss and compare the
total loss to the maximum power dissipation
recommendation in the inductor datasheet.
5.7.4 Output Capacitor Selection
Use these values to make an initial capacitor selection,
using a single capacitor or several capacitors in
parallel.
After a capacitor has been selected, the resulting output
voltage ripple can be calculated using the following
equation:
Several trade-offs must also be considered when
selecting an output capacitor. Low ESR values are
needed to have a small output deviation during
V orip
I opp ESR
8
I opp
f sw C OUT
transient load steps (V osag ) and low output voltage
ripple (V orip ). However, capacitors with low ESR, such
as semi-stable (X5R and X7R) dielectric ceramic
capacitors, also have relatively low capacitance values.
Many designs can use a combination of high
capacitance devices and low ESR devices in parallel.
For high ripple currents, a low capacitance value can
cause a significant amount of output voltage ripple.
Likewise, in high transient load steps, a relatively large
amount of capacitance is needed to minimize the
output voltage deviation while the inductor current
ramps up or down to the new steady state output
current value.
Because each part of this equation was made to be less
than or equal to half of the allowed output ripple
voltage, the V orip should be less than the desired
maximum output ripple.
5.7.5 Input Capacitor
It is highly recommended that dedicated input
capacitors be used in any point-of-load design, even
when the supply is powered from a heavily filtered 5 or
12 V “bulk” supply from an off-line power supply.
This is because of the high RMS ripple current that is
drawn by the buck converter topology. This ripple
(I CINrms ) can be determined from the following
equation:
I CINrms
I OUT
D ( 1 D )
Without capacitive filtering near the power supply
circuit, this current would flow through the supply bus
and return planes, coupling noise into other system
circuitry. The input capacitors should be rated at 1.2X
the ripple current calculated above to avoid
overheating of the capacitors due to the high ripple
current, which can cause premature failure. Ceramic
capacitors with X7R or X5R dielectric with low ESR
and 1.1X the maximum expected input voltage are
recommended.
20
FN6846.3
February 15, 2011
相关PDF资料 |
PDF描述 |
|---|---|
| SBG3030CT-T | DIODE SCHOTTKY CC 30V 30A D2-PAK |
| FOXSDLF/115-20 | CRYSTAL 11.0592 MHZ 20PF SMD |
| ISL62392CIRTZ-T | IC PWR SUPPLY CTRLR 28TQFN |
| ISL62391CIRTZ-T | IC PWR SUPPLY CTRLR 28TQFN |
| FOXSDLF/036S | CRYSTAL 3.579545 MHZ 18PF SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ZL2004ALNFT1-01 | 功能描述:IC REG CTRLR BUCK SYNC ADJ 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:75 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.3 V ~ 13.5 V 降压:是 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:0°C ~ 70°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:管件 产品目录页面:1051 (CN2011-ZH PDF) 其它名称:296-2543-5 |
| ZL2004ALNN | 功能描述:IC REG CTRLR BUCK SYNC ADJ 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
| ZL2004ALNN-01 | 功能描述:IC REG CTRLR BUCK SYNC ADJ 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
| ZL2004ALNNT | 功能描述:IC REG CTRLR BUCK SYNC ADJ 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
| ZL2004ALNNT-01 | 功能描述:IC REG CTRLR BUCK SYNC ADJ 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
发布紧急采购，3分钟左右您将得到回复。