- 您现在的位置：买卖IC网 > PDF目录18840 > 12217 (NVE Corp/Sensor Products)MAGNET 3.5MM DIA X 4MM THICK PDF资料下载
参数资料
| 型号： | 12217 |
| 厂商： | NVE Corp/Sensor Products |
| 文件页数： | 121/145页 |
| 文件大小： | 0K |
| 描述： | MAGNET 3.5MM DIA X 4MM THICK |
| 标准包装： | 10 |
| 系列： | * |
| 其它名称： | Q7078272A |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页当前第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页
Application Notes
Another magnetic contribution to the error can be overcome by an initialization current. Often,
depending on the magnetic history (hysteresis) of the sensor, the initial outputs are different from
subsequent outputs as seen in the figure below:
Initialization of AA003-02
300
250
200
150
100
50
Initial sweep
Series2
Series3
Series4
Series5
Series6
0
0
2
4
6
8
10
Current (A)
The initial sweep data has deviated from the other series of current sweeps. After the first sweep was
completed, the subsequent five sweeps fell right on each other. This shows that a lower error can be
obtained by “initializing” the sensor. After initialization, the error will be much lower until the
working current range is exceeded in either direction. Saturation of the device (currents in the 20A
range) as well as changing the applied current direction will increase the hysteresis/error.
For currents of approximately 2 Amps and smaller, the output repeatability is nominally 2% while
higher currents produce output repeatability errors of less than 1%. Low current measurements of an
initial current sweep may exceed 15% error in repeatability.
DATA ANALYSIS- Low Current Sensing
The low current analysis is handled here separately from the higher current analysis due to special
considerations that must be made, although much of the same hysteresis and resolution considerations
from high field sensing apply here. For low current sensing, two configurations of 0.010" wide traces
were used. The first analysis will be with an AA003-02 sensor over a single 10-mil trace and the
second analysis will consist of an AA003-02 sensor over seven 10-mil traces. With these traces,
milliamp and sub-milliamp currents are of interest. Due to the hysteresis at low currents as discussed
above, a biasing magnet was used to set the parts to approximately half of their linear range, or
approximately 20 mV/V. This bias point can be seen as the Y intercept in the figures below. In this
way, the output will not be near the natural zero current range, and thus, repeatability is increased.
With this configuration an alternating sense current will produce a bipolar output with a DC offset in
an AC application.
- 121 -
www.nve.com phone: 952-829-9217 fax: 952-829-9189
相关PDF资料 |
PDF描述 |
|---|---|
| B512-2T-YDA | MOD DIODE SCR 25A 240VAC .250"QC |
| HAL 200-S | CURRENT TRANSDUCERS 200A 15V |
| B553-2 | MOD DIODE SCR 25A 280VAC ISO QC |
| B511F-2 | MOD DIODE SCR 25A 120VAC ISO QC |
| HAL 50-S | CURRENT TRANSDUCERS 50A 15V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 122170 | 制造商:Amphenol Connex 功能描述:TNC BLKHD CRMP JCK RG59-50--TF - Bag |
| 1-22170-6 | 制造商:TE Connectivity 功能描述:PIN,COTTER - Bulk 制造商:TE CONNECTIVITY 功能描述:PIN,COTTER |
| 1-22170-8 | 制造商:TE Connectivity 功能描述:PIN,COTTER - Bulk 制造商:TE CONNECTIVITY 功能描述:PIN,COTTER |
| 1-2217206-0 | 功能描述:BLADE, SLUG 制造商:te connectivity amp connectors 系列:* 零件状态:有效 标准包装:1 |
| 1-2217206-1 | 功能描述:BLADE, SLUG 制造商:te connectivity amp connectors 系列:* 零件状态:有效 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。