参数资料
| 型号： | 24AA1025-I/SN |
| 厂商： | Microchip Technology |
| 文件页数： | 7/28页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 1MBIT 400KHZ 8SOIC |
| 标准包装： | 100 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 1M (128K x 8) |
| 速度： | 100kHz，400kHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 1.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOICN |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
24AA1025/24LC1025/24FC1025
4.0
BUS CHARACTERISTICS
The data on the line must be changed during the low
period of the clock signal. There is one bit of data per
The following bus protocol has been defined:
? Data transfer may be initiated only when the bus
is not busy.
? During data transfer, the data line must remain
stable whenever the clock line is high. Changes in
the data line while the clock line is high will be
clock pulse.
Each data transfer is initiated with a Start condition and
terminated with a Stop condition. The number of the
data bytes transferred between the Start and Stop
conditions is determined by the master device.
interpreted as a Start or Stop condition.
4.5
Acknowledge
Accordingly, the following bus conditions have been
defined ( Figure 4-1 ).
Each receiving device, when addressed, is obliged to
generate an Acknowledge signal after the reception of
4.1
Bus Not Busy (A)
each byte. The master device must generate an extra
clock pulse which is associated with this Acknowledge
Both data and clock lines remain high.
bit.
Note:
The 24XX1025 does not generate any
4.2
Start Data Transfer (B)
Acknowledge bits if an internal program-
A high-to-low transition of the SDA line while the clock
(SCL) is high determines a Start condition. All
commands must be preceded by a Start condition.
ming cycle is in progress, however, the
control byte that is being polled must
match the control byte used to initiate the
write cycle.
4.3
Stop Data Transfer (C)
A device that acknowledges must pull-down the SDA
line during the Acknowledge clock pulse in such a way
A low-to-high transition of the SDA line while the clock
(SCL) is high determines a Stop condition. All
operations must end with a Stop condition.
that the SDA line is stable low during the high period of
the acknowledge related clock pulse. Of course, setup
and hold times must be taken into account. During
reads, a master must signal an end of data to the slave
4.4
Data Valid (D)
by NOT generating an Acknowledge bit on the last byte
that has been clocked out of the slave. In this case, the
The state of the data line represents valid data when,
after a Start condition, the data line is stable for the
duration of the high period of the clock signal.
slave (24XX1025) will leave the data line high to enable
the master to generate the Stop condition.
FIGURE 4-1:
DATA TRANSFER SEQUENCE ON THE SERIAL BUS
(A)
(B)
(D)
(D)
(C)
(A)
SCL
SDA
Start
Condition
FIGURE 4-2:
Address or
Acknowledge
Valid
ACKNOWLEDGE TIMING
Data
Allowed
To Change
Stop
Condition
Acknowledge
Bit
SCL
1
2
3
4
5
6
7
8
9
1
2
3
SDA
Data from transmitter
Data from transmitter
The transmitter must release the SDA line at this
point allowing the receiver to pull the SDA line low
to acknowledge the previous eight bits of data.
? 2005-2012 Microchip Technology Inc.
The receiver must release the SDA line at this
point so the transmitter can continue sending
data.
DS21941K-page 7
相关PDF资料 |
PDF描述 |
|---|---|
| 24LC1026-I/SN | IC EEPROM 1024KB 400KHZ 8-SOIC |
| 24FC1025-I/SN | IC EEPROM 1MBIT 1MHZ 8SOIC |
| 24AA1026-I/SN | IC EEPROM 1024KB 400KHZ 8-SOIC |
| 24LC1025-I/SN | IC EEPROM 1MBIT 400KHZ 8SOIC |
| SST39VF3202B-70-4I-EKE | IC FLASH MPF 32MBIT 70NS 48TSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 24AA1025T | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:1024K I2C? CMOS Serial EEPROM |
| 24AA1025T-E/P | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:1024K I2C? CMOS Serial EEPROM |
| 24AA1025T-E/SM | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:1024K I2C? CMOS Serial EEPROM |
| 24AA1025T-E/SN | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:1024K I2C? CMOS Serial EEPROM |
| 24AA1025T-I/P | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:1024K I2C? CMOS Serial EEPROM |
发布紧急采购，3分钟左右您将得到回复。