- 您现在的位置：买卖IC网 > PDF目录16278 > 73M1866B-KEYCHN (Maxim Integrated Products)BOARD KEYCHAIN INF DANUBE EVM PDF资料下载
参数资料
| 型号： | 73M1866B-KEYCHN |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 68/88页 |
| 文件大小： | 0K |
| 描述： | BOARD KEYCHAIN INF DANUBE EVM |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页当前第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页
73M1866B/73M1966B Data Sheet
DS_1x66B_001
70
Rev. 1.6
Function
Mnemonic
Register
Location
Type
Description
ENLVD
0x12[3]
WO
LeV Detection (OVDET, UVDET, OIDET monitors)
0 = Enable LeV detection. (Default)
1 = Disable LeV detection (used in line-powered mode to save power).
This bit will be 0 when Line Powered Mode is detected (ENLPW is set
in Register 0x02[2]) and set to 1 when an interrupt occurs within the
73M1916. This bit must be reset prior to switching back to Barrier
Powered Mode.
ENNOM
0x12[0]
WO
Enable Nominal Operation
0 = Speeds up the on and off hook transitions time by increasing the
DC loop bandwidth of the DC transconductance circuit in the
73M1x66B. This should be used for pulse dialing, going on and off
hook, etc. In addition, ENNOM=0 prevents the reset of all bits in
Register 0x12. (Default)
1 = Enter Nominal Operation. Reduces the loop bandwidth of the DC
transconductance circuit. Allows reset of Register 0x12 caused by bits
UVDET, OVDET or OIDET.
ENSHL
0x12[4]
WO
Enable Shunt Loading
0 = Disable shunt loading. (Default)
1 = Enable shunt loading of the line. Not used for most applications.
IDISPD
0x13[1]
WO
Discharge and Pulse Dialing
Controls the DC discharge current and how fast the loop turns off.
Affects pulse dialing waveform. Controls the amount of discharge
current during hook switch transitions.
0 = Minimum current. (Default)
1 = Maximum current.
It is recommended to set IDISPD to 1 prior to hook switching
operations.
ILM
0x13[5]
WO
Current Limit Enable
This control enables or disables loop current limit.
0 = No current limit. (Default)
1 = 42 mA current limit enabled.
ILMON
0x1E[7]
R
Current Limit Mode On
This status bit is effective only when the ILM bit is set to 1.
0 = Loop current is lower than 42 mA.
1 = Loop current is higher than 42 mA and the current limiting mode is
active.
OFH
0x12[7]
WO
Off-Hook Enable
This bit controls the state of the Hook signal.
0 = On-Hook. (Default)
1 = Off-Hook.
PLDM
0x13[3]
WO
Pulse Dialing Mode Enable
Alleviates the strict timing requirements for the Host having to control
ENDC and OFH during pulse dialing. With PLDM = 1, the Host only
has to toggle OFH to perform pulse dialing.
0 = Pulse Dialing Mode is disabled. (Default)
1 = Pulse Dialing Mode is enabled.
RLPNEN
0x16[5]
W
Receive Low Pass Notch Enable
0 = Billing Tone Receive Low Pass Notch (RLPN) filter bypassed.
(Default)
1 = RLPN Filter Enabled. See RLPNH for notch frequency selection.
相关PDF资料 |
PDF描述 |
|---|---|
| UPS2D221MRD6 | CAP ALUM 220UF 200V 20% RADIAL |
| 73M1822-KEYCHN | BOARD KEYCHAIN 73M1822 42-QFN |
| 78Q2133-DB | EVAL BOARD 78Q2133 |
| MAX14821EVKIT# | EVAL KIT MAX14821 |
| UVZ1C472MHD | CAP ALUM 4700UF 16V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 73M1902-IM/F | 功能描述:电信线路管理 IC MicroDAA Chip Set Host Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| 73M1902-IMR/F | 功能描述:电信线路管理 IC MicroDAA Chip Set Host Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| 73M1902-IVT/F | 功能描述:电信线路管理 IC MicroDAA Chip Set Host Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| 73M1902-IVTR/F | 功能描述:电信线路管理 IC MicroDAA Chip Set Host Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| 73M1903 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Soft Modem AFEs |
发布紧急采购，3分钟左右您将得到回复。