- 您现在的位置：买卖IC网 > PDF目录1171 > 73S8009R-DB (Maxim Integrated Products)BOARD DEMO 73S8009R 28-SOIC PDF资料下载
参数资料
| 型号： | 73S8009R-DB |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 11/18页 |
| 文件大小： | 0K |
| 描述： | BOARD DEMO 73S8009R 28-SOIC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1 |
| 系列： | * |
UM_8009R_065
4 Design Considerations
73S8009R Demo Board User Manual
4.1
General Layout Rules
Follow these layout rules:
?
?
?
?
?
?
?
4.2
Route I/O and auxiliary signals away from card interface signals.
Keep CLK trace as short as possible and with minimal bends in the trace. If possible, keep routing of
the CLK trace to one layer (avoid vias to other layers). Keep CLK trace away from other traces
especially RST, I/O and VCC. Filtering of the CLK trace is allowed for noise purposes. Up to 30 pF
to ground is allowed at the CLK pin of the smart card connector. Also, the zero Ω series resistor (R7)
can be replaced with a small resistor for additional filtering (no more than 100 Ω ).
Keep VCC trace as short as possible. Make trace a minimum of 0.5 mm thick. Also, keep VCC away
from other traces especially RST and CLK.
Keep RST trace away from VCC and CLK traces. Up to 30 pF to ground is allowed for filtering.
Keep 0.1 μ F close to VDD pin of the device and directly take other end to ground.
Keep 0.1 μ F and 10 μ F close to VPC pin of the device and directly take other end to ground.
Keep 3.3 μ F (1.0 μ F for NDS) close to VCC pin of the smart card connector and directly take other
end to ground.
Optimization for Compliance with EMV
Default configuration of the Demo Board contains a 27 pF capacitor (C12) from the CLK pin of the smart
connector to ground and a 27 pF capacitor (C13) from the RST pin of the smart connector to ground.
These capacitors serve as filters for CLK and RST signals in the case of long traces or test equipment
perturbations. The capacitor on CLK reduces ringing on the trace, reduces coupling to other traces and
slows down the edge of the CLK signal. The capacitor on RST helps the perturbation specification in a
noisy environment. The filter capacitors can be useful in the EMV test environment and have no effect on
NDS testing
C12 and C13 are represented on both schematic and BOM. These capacitors are optional filter
capacitors on the smart card lines CLK and RST, respectively for each card interface. These capacitors
may be adjusted (value, not to exceed 30 pF) or removed to optimize performance in each specific
application (PCB, card clock frequency, compliance with applicable standards etc).
The default VCC capacitor of 3.3 μ F is required to meet the dynamic VCC (smart card supply) transient
current requirement in EMV2000 version 4.0.
Rev. 1.2
11
相关PDF资料 |
PDF描述 |
|---|---|
| 73S8014RT-DB | BOARD DEMO 73S8010RT 20-SOIC |
| 74-1/4"X72YD | TAPE ELECTRICAL POLY 1/4" YEL |
| 74032-103LF | USB A TYPE PLUG KIT LF |
| 74056-0010BLF | UNIV SERIAL BUS T/H LF |
| 74065-0005 | CONN GBIC RECEPT 20POS RT/ANG |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 73S8009R-IL/F | 功能描述:输入/输出控制器接口集成电路 Smart Card Interface IC RoHS:否 制造商:Silicon Labs 产品: 输入/输出端数量: 工作电源电压: 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-64 封装:Tray |
| 73S8009R-ILR/F | 功能描述:输入/输出控制器接口集成电路 Smart Card Interface IC RoHS:否 制造商:Silicon Labs 产品: 输入/输出端数量: 工作电源电压: 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-64 封装:Tray |
| 73S8009R-IM/F | 功能描述:输入/输出控制器接口集成电路 Smart Card Interface IC RoHS:否 制造商:Silicon Labs 产品: 输入/输出端数量: 工作电源电压: 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-64 封装:Tray |
| 73S8009R-IMR/F | 功能描述:输入/输出控制器接口集成电路 Smart Card Interface IC RoHS:否 制造商:Silicon Labs 产品: 输入/输出端数量: 工作电源电压: 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-64 封装:Tray |
| 73S8010C | 制造商:TERIDIAN 制造商全称:TERIDIAN 功能描述:Smart Card Interface |
发布紧急采购，3分钟左右您将得到回复。