- 您现在的位置：买卖IC网 > PDF目录10659 > 78Q2123/F (Maxim Integrated Products)TXRX 10/100 MDIX 3.3V COMM 32QFN PDF资料下载
参数资料
| 型号： | 78Q2123/F |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 34/38页 |
| 文件大小： | 0K |
| 描述： | TXRX 10/100 MDIX 3.3V COMM 32QFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 490 |
| 类型： | PHY 收发器 |
| 驱动器/接收器数： | 4/4 |
| 规程： | IEEE 802 |
| 电源电压： | 3 V ~ 3.6 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-QFN 裸露焊盘（5x5） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页当前第34页第35页第36页第37页第38页
DS_21x3_001
78Q2123/78Q2133 Data Sheet
Rev. 1.6
5
1
Functional Description
1.1
General
1.1.1
Power Management
The 78Q2123 and 78Q2133 have three power saving modes:
Chip Power-Down
Receive Power Management
Transmit High Impedance Mode
Chip power-down is activated by setting the PWRDN bit in MII register MR0.11. When the chip is in
power-down mode, all on-chip circuitry is shut off, and the device consumes minimum power. While in
the power-down state, the 78Q2123/78Q2133 still respond to management transactions.
Receive power management (RXCC mode) is activated by setting the RXCC bit in MII register MR16.0.
In this mode of operation, the adaptive equalizer, the clock recovery phase lock loop (PLL), and all other
receive circuitry will be powered down when no valid MLT-3 signal is present at the UTP receive line
interface. As soon as a valid signal is detected, all circuits will automatically be powered up to resume
normal operation. During this mode of operation, RX_CLK will be inactive when there is no data being
received. Note that the RXCC mode is not supported during 10BASE-T operation.
Transmit high impedance mode is activated by setting the TXHIM bit in MII register MR16.12. In this
mode of operation, the transmit UTP drivers are in a high impedance state and TX_CLK is tri-stated. A
weak internal pull-up is enabled on TX_CLK. The receive circuitry remains fully operational. The default
state of MR16.12 is a logic low for disabling the transmit high impedance mode. Only a reset condition will
automatically clear MR16.12. The transmitter is fully functional when MR16.12 is cleared. This feature is
useful when configuring a system for Wake-On LAN (when the 78Q2123/78Q2133 are coupled with a
Wake-On LAN capable MAC).
1.1.2
Analog Biasing and Supply Regulation
The 78Q2123/78Q2133 require no external component to generate on-chip bias voltages and currents.
High accuracy is maintained through a closed-loop trimmed biasing network.
On-chip digital logic runs off an internal voltage regulator. Hence only a single 3.3V (
± 0.3V) supply is
required to power-up the device. The on-chip regulator is not affected by the power-down mode.
1.1.3
Clock Selection
The 78Q2123/78Q2133 have an on-chip crystal oscillator which can also be driven by an external oscillator.
In this mode of operation, a 25 MHz crystal should be connected between the XTLP and XTLN pins.
Alternatively, an external 25 MHz clock input can be connected to the XTLP pin. In this mode of operation,
a crystal is not required and the XTLN pin must be tied to ground.
1.1.4
Transmit Clock Generation
The transmitter uses an on-chip frequency synthesizer to generate the transmit clock. In 100BASE-TX
operation, the synthesizer multiplies the reference clock by 5 to obtain the internal 125 MHz serial transmit
clock. In 10BASE-T mode, it generates an internal 20MHz transmit clock by multiplying the reference
25 MHz clock by 4/5. The synthesizer references either the local 25 MHz crystal oscillator, or the externally
applied clock, depending on the selected mode of operation.
相关PDF资料 |
PDF描述 |
|---|---|
| ICL3225EIAZ-T | TRANSMITTER/RCVR RS232 20-SSOP |
| MAX981CUA+T | IC COMPARATOR OD 8-UMAX |
| MAX981ESA+T | IC COMPARATOR OD 8-SOIC |
| MAX972ESA+T | IC COMPARATOR OD 8-SOIC |
| MAX972CUA+T | IC COMPARATOR OD 8-UMAX |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 78Q2123R/F | 功能描述:以太网 IC 10/100 Fast Ethernet MicroPHY RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| 78Q2123R/F1 | 功能描述:以太网 IC RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| 78Q2123S/F | 功能描述:1/1 Transceiver Full Ethernet 16-TQFN (5x5) 制造商:maxim integrated 系列:MicroPHY?? 包装:管件 零件状态:有效 类型:收发器 协议:以太网 驱动器/接收器数:1/1 双工:全 接收器滞后:- 数据速率:- 电压 - 电源:3.3V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:16-WQFN 裸露焊盘 供应商器件封装:16-TQFN（5x5） 标准包装:60 |
| 78Q2123SR/F | 功能描述:1/1 Transceiver Full Ethernet 16-TQFN (5x5) 制造商:maxim integrated 系列:MicroPHY?? 包装:带卷（TR） 零件状态:有效 类型:收发器 协议:以太网 驱动器/接收器数:1/1 双工:全 接收器滞后:- 数据速率:- 电压 - 电源:3.3V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:16-WQFN 裸露焊盘 供应商器件封装:16-TQFN（5x5） 标准包装:2,500 |
| 78Q2132 | 制造商:TDK 制造商全称:TDK Electronics 功能描述:1/10BASE-T HomePNA/Ethernet Transceiver |
发布紧急采购，3分钟左右您将得到回复。