- 您现在的位置：买卖IC网 > PDF目录17042 > A3PE-STARTER-KIT-2 (Microsemi SoC)KIT EVAL FOR A3PE1500 PROASIC3 PDF资料下载
参数资料
| 型号： | A3PE-STARTER-KIT-2 |
| 厂商： | Microsemi SoC |
| 文件页数： | 64/162页 |
| 文件大小： | 0K |
| 描述： | KIT EVAL FOR A3PE1500 PROASIC3 |
| 产品变化通告： | Kit/Part Number Change 25/Jul/2012 |
| 标准包装： | 1 |
| 系列： | ProASIC3 |
| 类型： | FPGA |
| 适用于相关产品： | A3PE1500 |
| 所含物品： | 板，电源，编程器 |
| 其它名称： | 1100-1144 A3PE-STARTER-KIT |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页当前第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页第154页第155页第156页第157页第158页第159页第160页第161页第162页
Datasheet Information
5-6
Revision 13
v2.1
(continued)
The words "ambient temperature" were added to the temperature range in the
"Temperature Grade Offerings", "Speed Grade and Temperature Grade Matrix",
and "Speed Grade and Temperature Grade Matrix" sections.
iii, iv, iv
The "Clock Conditioning Circuit (CCC) and PLL" section was updated.
i
The caption "Main (chip)" in Figure 2-9 Overview of Automotive ProASIC3
VersaNet Global Network was changed to "Chip (main)."
2-9
The TJ parameter in Table 3-2 Recommended Operating Conditions was
changed to TA, ambient temperature, and table notes 4–6 were added.
3-2
The "PLL Macro" section was updated to add information on the VCO and PLL
outputs during power-up.
2-15
v2.0
(April 2007)
In the "Temperature Grade Offerings" section, Ambient was deleted.
iii
Ambient was deleted from "Temperature Grade Offerings".
iii
Ambient was deleted from the "Speed Grade and Temperature Grade Matrix".
iv
The "PLL Macro" section was updated to include power-up information.
2-15
Table 2-13 ProASIC3E CCC/PLL Specification was updated.
2-30
Figure 2-19 Peak-to-Peak Jitter Definition is new.
2-18
The "SRAM and FIFO" section was updated with operation and timing
requirement information.
2-21
The "RESET" section was updated with read and write information.
2-25
The "RESET" section was updated with read and write information.
2-25
The "Introduction" in the "Advanced I/Os" section was updated to include
information on input and output buffers being disabled.
2-28
In the Table 2-15 Levels of Hot-Swap Support, the ProASIC3 compliance
descriptions were updated for levels 3 and 4.
2-34
Table 2-45 I/O Hot-Swap and 5 V Input Tolerance Capabilities in ProASIC3E
Devices was updated.
2-64
Notes 3, 4, and 5 were added to Table 2-17 Comparison Table for 5 V–
Compliant Receiver Scheme. 5 x 52.72 was changed to 52.7 and the Maximum
current was updated from 4 x 52.7 to 5 x 52.7.
2-40
The "VCCPLF PLL Supply Voltage" section was updated.
2-50
The "VPUMP Programming Supply Voltage" section was updated.
2-50
The "GL Globals" section was updated to include information about direct input
into quadrant clocks.
2-51
VJTAG was deleted from the "TCK Test Clock" section.
2-51
In Table 2-22 Recommended Tie-Off Values for the TCK and TRST Pins, TSK
was changed to TCK in note 2. Note 3 was also updated.
2-51
Ambient was deleted from Table 3-2 Recommended Operating Conditions.
VPUMP programming mode was changed from "3.0 to 3.6" to "3.15 to 3.45".
3-2
Note 3 is new in Table 3-4 Overshoot and Undershoot Limits (as measured on
quiet I/Os).
3-2
In EQ 3-2, 150 was changed to 110 and the result changed to 5.88.
3-5
Revision
Changes
Page
相关PDF资料 |
PDF描述 |
|---|---|
| 0210490279 | CABLE JUMPER 1.25MM .051M 22POS |
| EBM22DCMD-S288 | CONN EDGECARD 44POS .156 EXTEND |
| ECA14DRMI-S288 | CONN EDGECARD 28POS .125 EXTEND |
| 0210490905 | CABLE JUMPER 1.25MM .102M 21POS |
| MPC8377E-RDBA | BOARD REF DES MPC8377 REV 2.1 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A3PFA1X201J1 | 制造商:APEM 功能描述:Pushbutton,A3,latching,12V,red |
| A3PFA1X201J2 | 制造商:APEM 功能描述:Pushbutton,latching,12V,green |
| A3PFA1X201J3 | 制造商:APEM 功能描述:Pushbutton,latching,12V,amber |
| A3PFA1X201J4 | 制造商:APEM 功能描述:Pushbutton,A3,latching,12V,blue |
| A3PFA1X201K1 | 制造商:APEM 功能描述:Pushbutton,A3,latching 24V,red |
发布紧急采购，3分钟左右您将得到回复。