- 您现在的位置：买卖IC网 > PDF目录1773 > A4980KLPTR-T (Allegro Microsystems Inc)IC STEPPER DVR PROGR 28-TSSOP PDF资料下载
参数资料
| 型号： | A4980KLPTR-T |
| 厂商： | Allegro Microsystems Inc |
| 文件页数： | 15/44页 |
| 文件大小： | 0K |
| 描述： | IC STEPPER DVR PROGR 28-TSSOP |
| 标准包装： | 1 |
| 应用： | 步进电机驱动器 |
| 输出数： | 1 |
| 电流 - 输出： | ±1.4A |
| 电压 - 负载： | 0 V ~ 50 V |
| 电源电压： | 3 V ~ 5.5 V |
| 工作温度： | -40°C ~ 150°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.173"，4.40mm 宽）裸露焊盘 |
| 供应商设备封装： | 28-TSSOP 裸露焊盘 |
| 包装： | 标准包装 |
| 其它名称： | 620-1461-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页
A4980
Automotive, Programmable Stepper Driver
current to rise to the limit quickly and the PWM current control
to activate. However, when a motor is running at speed the back
EMF, generated by the speed of the magnetic poles in the motor
passing the phase windings, acts against the supply voltage and
reduces the rise time of the phase current. Therefore the PWM
current control takes longer to activate. Assuming a constant step
rate, this results in fewer PWM cycles for each step of the motor.
The A4980 uses this difference to detect a motor changing from
continuous stepping to stalled. Two PWM counters, one for each
phase, accumulate the number of PWM cycles when the phase
current is stepped from zero to full current. At the end of each
phase current rise, the counter for that phase is compared to the
counter for the previous current rise, in the opposite phase. If the
difference is greater than the number in the PWM compare regis-
ter, then the ST bit in the diagnostic registers is set. In addition, if
the ST signal is selected as the output on the DIAG pin, then the
pin will go low.
This stall detection scheme assumes a number of factors:
? The motor must be stepping fast enough for the back EMF to
reduce the phase current slew rate. Stall detection reliability
improves as the current slew rate reduces.
? The motor is not being stepped in full step mode.
? The phase current table must conform to the 0% and ±100%
conditions at steps 0, 16, 32, and 48.
? The phase current profiles must be the same for both phases.
Although stall detection cannot be guaranteed using this detection
method, good stall detection reliability can be achieved by careful
selection of motor speed, count difference, and by conforming to
the above factors.
In addition to using the integrated features of the A4980, it is
also possible to perform stall detection by examining the PWM
on-time for a single phase using an external microcontroller. In
the A4980 the PWM-on signal for phase A can be selected as the
output on the DIAG pin, by using the serial interface.
Allegro MicroSystems, LLC
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
15
相关PDF资料 |
PDF描述 |
|---|---|
| A4982SLPTR-T | IC DRIVER MICROSTEPPING 24-TSSOP |
| A4983SETTR-T | IC MOTOR DRIVER MICROSTEP 28-QFN |
| A4984SLPTR-T | IC STEPPER MOTOR DRIVER 24TSSOP |
| A4985SETTR-T | IC STEPPER MOTOR DRIVER 32QFN |
| A4986SLPTR-T | IC PWM MOTOR DRIVER 24TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A4982 | 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:DMOS Microstepping Driver with Translator And Overcurrent Protection |
| A4982_V4 | 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:DMOS Microstepping Driver with Translator And Overcurrent Protection |
| A49821 | 制造商:TE Connectivity 功能描述:Triquint value add services |
| A4982SETTR-T | 功能描述:IC STEPPER MOTOR DRIVER 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电机和风扇控制器，驱动器 系列:- 标准包装:1 系列:- 应用:直流电机驱动器，步进电机驱动器 评估套件:- 输出数:1 或 2 电流 - 输出:750mA 电压 - 负载:10 V ~ 40 V 电源电压:4.5 V ~ 5.5 V 工作温度:-20°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-BFSOP（0.295"，7.50mm 宽） 供应商设备封装:24-SOP 包装:Digi-Reel® 其它名称:MTS62C19A-HS105DKR |
| A4982SLPTR | 制造商:Allegro MicroSystems LLC 功能描述:DMOS Microstepping Driver |
发布紧急采购，3分钟左右您将得到回复。