- 您现在的位置：买卖IC网 > PDF目录373876 > AD5320 (Analog Devices, Inc.) +2.7 V to +5.5 V, 140 uA, Rail-to-Rail Output 12-Bit DAC in a SOT-23 PDF资料下载
参数资料
| 型号： | AD5320 |
| 厂商： | Analog Devices, Inc. |
| 英文描述： | +2.7 V to +5.5 V, 140 uA, Rail-to-Rail Output 12-Bit DAC in a SOT-23 |
| 中文描述： | 2.7 V至5.5 V，140微安，轨到轨输出12位DAC采用SOT - 23 |
| 文件页数： | 9/12页 |
| 文件大小： | 192K |
| 代理商： | AD5320 |
AD5320
–9–
REV. B
SYNC
Interrupt
In a normal write sequence, the
SYNC
line is kept low for at
least 16 falling edges of SCLK and the DAC is updated on the
16th falling edge. However, if
SYNC
is brought high before the
16th falling edge this acts as an interrupt to the write sequence.
The shift register is reset and the write sequence is seen as
invalid. Neither an update of the DAC register contents or a
change in the operating mode occurs—see Figure 23.
Power-On-Reset
The AD5320 contains a power-on-reset circuit that controls the
output voltage during power-up. The DAC register is filled with
zeros and the output voltage is 0 V. It remains there until a
valid write sequence is made to the DAC. This is useful in
applications where it is important to know the state of the out-
put of the DAC while it is in the process of powering up.
Power-Down Modes
The AD5320 contains four separate modes of operation. These
modes are software-programmable by setting two bits (DB13
and DB12) in the control register. Table I shows how the state
of the bits corresponds to the mode of operation of the device.
T able I. Modes of Operation for the AD5320
DB13
DB12
Operating Mode
0
0
Normal Operation
Power-Down Modes
1 k
to GND
100 k
to GND
Three-State
0
1
1
1
0
1
When both bits are set to 0, the part works normally with its
normal power consumption of 140
μ
A at 5 V. However, for the
three power-down modes, the supply current falls to 200 nA at
5 V (50 nA at 3 V). Not only does the supply current fall but
the output stage is also internally switched from the output of
the amplifier to a resistor network of known values. This has
the advantage that the output impedance of the part is known
while the part is in power-down mode. There are three dif-
ferent options. The output is connected internally to GND
through a 1 k
resistor, a 100 k
resistor or it is left open-cir-
cuited (Three-State). The output stage is illustrated in Figure 24.
POWER-DOWN
CIRCUITRY
RESISTOR
NETWORK
V
OUT
RESISTOR
STRING DAC
AMPLIFIER
Figure 24. Output Stage During Power-Down
The bias generator, the output amplifier, the resistor string and
other associated linear circuitry are all shut down when the
power-down mode is activated. However, the contents of the
DAC register are unaffected when in power-down. The time to
exit power-down is typically 2.5
μ
s for V
DD
= 5 V and 5
μ
s for
V
DD
= 3 V. See Figure 18 for a plot.
MICROPROCE SSOR INT E RFACING
AD5320 to ADSP-2101/ADSP-2103 Interface
Figure 25 shows a serial interface between the AD5320 and the
ADSP-2101/ADSP-2103. The ADSP-2101/ADSP-2103 should
be set up to operate in the SPORT Transmit Alternate Framing
Mode. The ADSP-2101/ADSP-2103 SPORT is programmed
through the SPORT control register and should be configured as
follows: Internal Clock Operation, Active Low Framing, 16-Bit
Word Length. Transmission is initiated by writing a word to the
Tx register after the SPORT has been enabled.
SCLK
ADSP-2101/
ADSP-2103*
DT
*ADDITIONAL PINS OMITTED FOR CLARITY
DIN
SCLK
AD5320*
TFS
Figure 25. AD5320 to ADSP-2101/ADSP-2103 Interface
DB15
DB0
SCLK
SYNC
DIN
DB15
DB0
VALID WRITE SEQUENCE, OUTPUT UPDATES
ON THE 16
FALLING EDGE
INVALID WRITE SEQUENCE:
SYNC
HIGH BEFORE 16
TH
FALLING EDGE
Figure 23.
SYNC
Interrupt Facility
相关PDF资料 |
PDF描述 |
|---|---|
| AD5320BRM | +2.7 V to +5.5 V, 140 uA, Rail-to-Rail Output 12-Bit DAC in a SOT-23 |
| AD5320BRT | +2.7 V to +5.5 V, 140 uA, Rail-to-Rail Output 12-Bit DAC in a SOT-23 |
| AD5320* | +2.7 V to +5.5 V. 140 uA. Rail-to-Rail Output 12-Bit DAC in a SOT-23 |
| AD5321 | +2.5 V to +5.5 V, 120 uA, 2-Wire Interface, Voltage Output 8-/10-/12-Bit DACs |
| AD5321BRM | +2.5 V to +5.5 V, 120 uA, 2-Wire Interface, Voltage Output 8-/10-/12-Bit DACs |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD5320_05 | 制造商:AD 制造商全称:Analog Devices 功能描述:2.7 V to 5.5 V, 140 ??A, Rail-to-Rail Output 12-Bit DAC in an SOT-23 |
| AD5320BRM | 功能描述:IC DAC 12BIT 2.7V R-R OUT 8-MSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 产品培训模块:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色产品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 标准包装:91 系列:- 设置时间:4µs 位数:10 数据接口:MICROWIRE?，串行，SPI? 转换器数目:8 电压电源:单电源 功率耗散（最大）:2.7mW 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-DFN-EP（4x3） 包装:管件 输出数目和类型:8 电压，单极 采样率（每秒）:* |
| AD5320BRM-REEL | 功能描述:IC DAC 12BIT R-R W/BUFF 8-MSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 标准包装:2,400 系列:- 设置时间:- 位数:18 数据接口:串行 转换器数目:3 电压电源:模拟和数字 功率耗散（最大）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:36-TFBGA 供应商设备封装:36-TFBGA 包装:带卷 (TR) 输出数目和类型:* 采样率（每秒）:* |
| AD5320BRM-REEL7 | 功能描述:IC DAC 12BIT R-R W/BUFF 8-MSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 标准包装:2,400 系列:- 设置时间:- 位数:18 数据接口:串行 转换器数目:3 电压电源:模拟和数字 功率耗散（最大）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:36-TFBGA 供应商设备封装:36-TFBGA 包装:带卷 (TR) 输出数目和类型:* 采样率（每秒）:* |
发布紧急采购，3分钟左右您将得到回复。