- 您现在的位置：买卖IC网 > PDF目录10664 > AD7357BRUZ (Analog Devices Inc)IC ADC DUAL14BIT 4.2MSPS 16TSSOP PDF资料下载
参数资料
| 型号： | AD7357BRUZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 10/21页 |
| 文件大小： | 0K |
| 描述： | IC ADC DUAL14BIT 4.2MSPS 16TSSOP |
| 设计资源： | DC-Coupled, Single-Ended-to-Differential Conversion Using AD8138 and AD7357 (CN0061) |
| 标准包装： | 1 |
| 位数： | 14 |
| 采样率（每秒）： | 4.2M |
| 数据接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 转换器数目： | 2 |
| 功率耗散（最大）： | 59mW |
| 电压电源： | 单电源 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 16-TSSOP |
| 包装： | 管件 |
| 输入数目和类型： | 2 个差分，双极 |
| 产品目录页面： | 777 (CN2011-ZH PDF) |
AD7357
Rev. B | Page 17 of 20
POWER-UP TIMES
The AD7357 has two power-down modes: partial power-
down and full power-down. There are described in detail in
sections. This section deals with the power-up time required
when coming out of either of these modes. It should be noted
that the power-up times apply with the recommended decoupling
capacitors in place on the REFA and REFB pins.
To power up from partial power-down mode, one dummy cycle
is required. The device is fully powered up after approximately
200 ns from the falling edge of CS has elapsed. Once the partial
power-up time has elapsed, the ADC is fully powered up and
the input signal is acquired properly. The quiet time, tQUIET, must
still be allowed from the point where the bus goes back into three-
state after the dummy conversion to the next falling edge of CS.
To power up from full power-down, approximately 6 ms should
be allowed from the falling edge of CS, shown in
as
tPOWER-UP2.
Note that during power-up from partial power-down mode, the
track-and-hold, which is in hold mode while the part is powered
down, returns to track mode after the first SCLK edge that the
part receives after the falling edge of CS.
When power supplies are first applied to the AD7357, the ADC
can power up in either of the power-down modes or in normal
mode. Because of this, it is best to allow a dummy cycle to elapse
to ensure that the part is fully powered up before attempting
a valid conversion. Likewise, if the part is to be kept in partial
power-down mode immediately after the supplies are applied,
then two dummy cycles must be initiated. The first dummy
cycle must hold CS low until after the 10th SCLK falling edge;
in the second cycle, CS must be brought high between the
second and 10th SCLK falling edges (see
).
Alternatively, if the part is to be placed into full power-down
mode when the supplies are applied, three dummy cycles must
be initiated. The first dummy cycle must hold CS low until after
the 10th SCLK falling edge; the second and third dummy cycles
place the part into full power-down mode (see
and
the
section).
POWER vs. THROUGHPUT RATE
The power consumption of the AD7357 varies with the
throughput rate. When using very slow throughput rates
and as fast an SCLK frequency as possible, the various power-
down options can be used to make significant power savings.
However, the AD7357 quiescent current is low enough that
even without using the power-down options, there is a noticeable
variation in power consumption with sampling rate. This is true
whether a fixed SCLK value is used or if it is scaled with the sam-
pling rate. Figure 29 shows a plot of power vs. throughput rate
when operating in normal mode for a fixed maximum SCLK
frequency and an SCLK frequency that scales with the sampling
rate. The internal reference was used for Figure 29.
10
14
18
22
26
30
34
38
0
1000
2000
3000
4000
THROUGHPUT (kSPS)
TO
T
A
L
P
O
WE
R
(
m
W)
80MHz SCLK
VARIABLE SCLK
07
75
7-
1
29
Figure 29. Power vs. Throughput Rate
相关PDF资料 |
PDF描述 |
|---|---|
| AD7731BRZ | IC ADC 24BIT SIGMA-DELTA 24-SOIC |
| LTC2355IMSE-14#PBF | IC ADC 14BIT 3.5MSPS 10-MSOP |
| MAX9092AUA+T | IC COMPARATOR GP DUAL 8UMAX |
| VI-B13-MX-F4 | CONVERTER MOD DC/DC 24V 75W |
| LTC2356IMSE-14#PBF | IC ADC 14BIT 3.5MSPS 10-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD7357BRUZ-500RL7 | 功能描述:IC ADC DUAL14BIT 4.2MSPS 16TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| AD7357BRUZ-RL | 功能描述:IC ADC 14BITDUAL 4.MSPS 16TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| AD7357WYRUZ | 制造商:Analog Devices 功能描述:ADC Dual SAR 4.2Msps 14-bit Serial 16-Pin TSSOP 制造商:Analog Devices 功能描述:14-BIT DUAL DIFF SIMULT 5 MSPS ADC I.C. - Rail/Tube 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:IC ADC 14BIT SRL 5MSPS 16TSSOP 制造商:Analog Devices 功能描述:Analog to Digital Converters - ADC 14-Bit Dual Diff Simult 5 MSPS 制造商:Analog Devices 功能描述:14-Bit Dual Diff Simult 5 MSPS ADC I.C. |
| AD7357WYRUZ-RL | 功能描述:模数转换器 - ADC 14-Bit Dual Diff Simult 5 MSPS RoHS:否 制造商:Analog Devices 通道数量: 结构: 转换速率: 分辨率: 输入类型: 信噪比: 接口类型: 工作电源电压: 最大工作温度: 安装风格: 封装 / 箱体: |
| AD7357YRUZ | 功能描述:IC ADC DUAL14BIT 4.2MSPS 16TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:- 位数:14 采样率（每秒）:83k 数据接口:串行，并联 转换器数目:1 功率耗散（最大）:95mW 电压电源:双 ± 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:28-DIP（0.600"，15.24mm） 供应商设备封装:28-PDIP 包装:管件 输入数目和类型:1 个单端，双极 |
发布紧急采购，3分钟左右您将得到回复。