参数资料
| 型号： | AD760AQ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 6/12页 |
| 文件大小： | 0K |
| 描述： | IC DAC 16BIT W/AMP SRL 28-CDIP |
| 产品培训模块： | Data Converter Fundamentals DAC Architectures |
| 标准包装： | 1 |
| 系列： | DACPORT® |
| 设置时间： | 6µs |
| 位数： | 16 |
| 数据接口： | 串行，并联 |
| 转换器数目： | 1 |
| 电压电源： | 双 ± |
| 功率耗散（最大）： | 725mW |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 28-CDIP（0.600"，15.24mm） |
| 供应商设备封装： | 28-CDIP |
| 包装： | 管件 |
| 输出数目和类型： | 2 电压，单极；2 电压，双极 |
| 采样率（每秒）： | 167k |
| 产品目录页面： | 781 (CN2011-ZH PDF) |
AD760
REV. A
–3–
NOTES
1For 18-bit resolution, 1 LSB = 0.00038% of FSR. For 16-bit resolution, 1 LSB = 0.0015% of FSR. For 14-bit resolution, 1 LSB = 0.006% of FSR. FSR stands for
full-scale range and is 10 V in unipolar mode and 20 V in bipolar mode.
2Characteristics are guaranteed at V
OUT Pin (23).
3T
CAL is the calibration temperature.
4Gain Error is measured with a fixed 50
resistor as shown in Figure 5a and Figure 6a.
5Gain Error and gain drift are measured with the internal reference. The internal reference is the main contributor to the gain drift. If lower drift is required, the
AD760 can be used with a precision external reference such as the AD587, AD586 or AD688.
6DAC Gain Error is measured without the on-chip voltage reference. It represents the performance that can be obtained with an external precision reference.
7External current is defined as the current available in addition to that supplied to REF IN and SPAN/BIPOLAR OFFSET on the AD760.
8Operation on ±12 V supplies is possible using an external reference such as the AD586 and reducing the output range. Refer to the Internal/External Reference
section.
Specifications subject to change without notice.
AC PERFORMANCE CHARACTERISTICS
Parameter
Limit
Units
Test Conditions/Comments
Output Settling Time
13
s max
20 V Step, TA = +25°C
(Time to +0.0008% FS, with
8
s typ
20 V Step, TA = +25°C
2 k , 1000 pF Load)
10
s typ
20 V Step
6
s typ
10 V Step, TA = +25°C
8
s typ
10 V Step
2.5
s typ
1 LSB Step
MUXOUT Recovery Time
Recovery time is referenced to the rising edge of CALOK,
(Time to +0.0008% FS, with
when MUXOUT switches from MUXIN to VOUT.
100 pF Load)
MUXIN = VOUT prior to calibration.
2
s typ
MUXIN, VOUT = –10 V to +10 V
Total Harmonic Distortion + Noise
A, S Grade
0.005
% max
0 dB, 1001 Hz. Sample Rate = 100 kHz. TA = +25°C
A, S Grade
0.03
% max
–20 dB, 1001 Hz. Sample Rate = 100 kHz. TA = +25°C
A, S Grade
3.0
% max
–60 dB, 1001 Hz. Sample Rate = 100 kHz. TA = +25°C
Signal-to-Noise Ratio
94
dB min
TA = +25°C, byte load
Digital-to-Analog Glitch Impulse
15
nV-s typ
DAC alternately loaded with 8000H and 7FFFH
MUXOUT Glitch Impulse
30
nV-s typ
100 pF Load. MUXIN = VOUT = negative full scale
Digital Feedthrough
2
nV-s typ
DAC alternately loaded with 0000H and FFFFH. CS high
Output Noise Voltage Density (1 kHz–1 MHz)
120
nV/ Hz typ
Measured at VOUT, 20 V span, excludes internal reference
Reference Noise (1 kHz–1 MHz)
125
nV/ Hz typ
Measured at REF OUT
Specifications are subject to change without notice.
With the exception of Total Harmonic Distortion + Noise and Signal-to-Noise
Ratio, these characteristics are included for design guidance only and are not subject to test. THD+N and SNR are 100% tested. (TMIN < TA
< TMAX, VCC = +15 V, VEE = –15 V, VLL = +5 V, tested at VOUT except where noted.)
相关PDF资料 |
PDF描述 |
|---|---|
| AD766AN | IC DAC 16BIT W/REF DSP 16-DIP |
| AD767BD | IC DAC 12BIT W/AMP 24-CDIP |
| AD768AR | IC DAC 16BIT 30MSPS 28-SOIC |
| AD7724ASTZ | IC MOD SIGMA-DELTA DUAL 48LQFP |
| AD7729ARU | IC ADC 15BIT DUAL W/DAC 28-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD760SQ | 制造商:未知厂家 制造商全称:未知厂家 功能描述:16-Bit Digital-to-Analog Converter |
| AD7610 | 制造商:AD 制造商全称:Analog Devices 功能描述:14-Bit, 1 MSPS, Differential, Programmable Input PulSAR ADC |
| AD7610ACP | 制造商:Analog Devices 功能描述:500KSPS 16-BIT ADC S/W PROG. INPUT RANGES - Bulk |
| AD7610AST | 制造商:Analog Devices 功能描述:500KSPS 16-BIT ADC S/W PROG. INPUT RANGES - Bulk |
| AD7610BCPZ | 功能描述:IC ADC 16BIT 250KSPS 48-LFCSP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:PulSAR® 标准包装:1 系列:- 位数:14 采样率（每秒）:83k 数据接口:串行，并联 转换器数目:1 功率耗散（最大）:95mW 电压电源:双 ± 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:28-DIP（0.600"，15.24mm） 供应商设备封装:28-PDIP 包装:管件 输入数目和类型:1 个单端，双极 |
发布紧急采购，3分钟左右您将得到回复。