- 您现在的位置：买卖IC网 > PDF目录10572 > AD8321ARZ-REEL (Analog Devices Inc)IC LINE DVR CATV 20-SOIC T/R PDF资料下载
参数资料
| 型号： | AD8321ARZ-REEL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 18/20页 |
| 文件大小： | 0K |
| 描述： | IC LINE DVR CATV 20-SOIC T/R |
| 产品变化通告： | AD8321 Discontinuation 02/Mar/2012 |
| 标准包装： | 1,000 |
| 类型： | 线路驱动器，发射器 |
| 应用： | 调制解调器，CATV |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 20-SOIC W |
| 包装： | 带卷 (TR) |
| 配用： | AD8321-EVAL-ND - BOARD EVAL FOR AD8321 |
AD8321
OPERATIONAL DESCRIPTION
The AD8321 is a digitally controlled variable gain power ampli
fier that is optimized for driving a 75
W cable. As a multifunc
tional bipolar device on a single silicon die, it incorporates all the
analog features necessary to accommodate reverse path (upstream)
high speed (5 MHz to 65 MHz) cable data modem requirements.
The AD8321 has an overall gain range of approximately 53 dB
and is capable of greater than 100 MHz operation at output
signal levels exceeding 12 dBm. Overall, when considering
the device’s wide gain range, low distortion, wide bandwidth
and variable load drive, the device can be used in many variable
gain block applications.
VCC
GND
VIN–
AD8321
POWER-
DOWN/
SWITCH
INTER
ATTENUATOR CORE
INV
DATA SHIFT REGISTER
DATA LATCH
PWR
AMP
REVERSE
AMP
–20
VOUT
VIN+
The gain transfer function is as follows:
AV = 26 dB – ((71 – CODE)
0.7526 dB) for CODE 71
AV = 26 dB for 71
CODE 127
AV = 26 dB + ((199 – CODE)
0.7526 dB) for 128
CODE
199
AV = 26 dB for 199
CODE 255
where CODE is the decimal equivalent of the 8-bit word loaded in
the AD8321’s data latch (see Figure 23).
30
20
10
GAIN
–
dB
0
–10
–30
PD
0
32
64
96
128
160
192
224
256
GAIN CODE – Decimal
Figure 23. Linear-In dB Gain vs. Gain Control
The AD8321 is composed of four analog functions in the
DATEN CLK
SDATA
Figure 22. Functional Block Diagram
The digitally programmable gain is controlled by the three-wire
“SPI” compatible inputs. These inputs are called SDATA
(serial data input port),
DATEN (data enable low input port)
and CLK (clock input port). See Pin Function Descriptions
and Functional Block diagram. The AD8321 is programmed by
an 8-bit “attenuator” word. When a standard 8-bit word is
used, the first data bit MSB will be shifted out of the 7-bit shift
register during the eighth rising CLK edge. The lower seven
bits will then be loaded into the AD8321’s digital decode sec
tion when the
DATEN input is taken high.
The gain of the AD8321 is linear in steps of 0.7526 dB. The
gain transfer function starts at –27.43 dB (at decimal code 0)
and increases 0.7526 dB/LSB. The gain increases up to decimal
code 71. At this point the gain is at its maximum level of 26 dB.
If a decimal word between 71 and 127 is entered, the gain is no
longer incremented and stays at 26 dB. Since the MSB of an 8-bit
word is a “don’t care” bit, at decimal code 128, the AD8321’s
gain returns to its minimum value. The gain vs. gain control
relationship repeats itself as shown in Figure 23 for the upper
127 codes.
power-up or forward mode. The input amplifier (preamp) which
can be used single-endedly or differentially and provides a maxi
mum of 12 dB of attenuation. If the input is used in the differ
ential configuration, it is imperative that the input signals are
180 degrees out of phase and of equal amplitudes. This will
ensure the proper gain accuracy and harmonic performance.
The preamp stage drives a vernier stage that provides the fine
tune gain adjustment. The 0.7526 dB step resolution is imple
mented in this stage. After the vernier stage, a DAC provides the
bulk of the AD8321’s attenuation (six bits or 36 dB). The signals
in the preamp and vernier gain blocks are differential to improve
the PSRR and linearity. A single-ended current is fed from the
DAC into the output stage, which amplifies this current to the
appropriate level necessary to drive a 75
W load. The output
stage utilizes negative feedback to implement a 75
W output
impedance. This eliminates the need for an external 75
W match
ing resistor needed in typical video (or video filter) termination
requirements.
REV. A
–7–
相关PDF资料 |
PDF描述 |
|---|---|
| MAX11614EEE+ | IC ADC SERIAL 12BIT 8CH 16-QSOP |
| MAX11210EEE+ | IC ADC 24BIT SPI/SRL 5SPS 16QSOP |
| MAX1111EEE+ | IC ADC 8BIT LP 16-QSOP |
| MAX1108EUB+ | IC ADC 8BIT LP 10-UMAX |
| MAX1110CAP+ | IC ADC SRL 8CH8BIT 50KSPS 20SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8321ARZ-REEL2 | 制造商:AD 制造商全称:Analog Devices 功能描述:Gain Programmable CATV Line DRiver |
| AD8321-EVAL | 功能描述:BOARD EVAL FOR AD8321 RoHS:否 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- 主要目的:电源管理，电池充电器 嵌入式:否 已用 IC / 零件:MAX8903A 主要属性:1 芯锂离子电池 次要属性:状态 LED 已供物品:板 |
| AD8321XR2 | 制造商:Analog Devices 功能描述: |
| AD8322 | 制造商:AD 制造商全称:Analog Devices 功能描述:5 V CATV Line Driver Coarse Step Output Power Control |
| AD8322ARU | 制造商:Analog Devices 功能描述:SP Amp Line Driver Amp Single 5.25V 28-Pin TSSOP Tube 制造商:Rochester Electronics LLC 功能描述:TSSOP COARSE STEP +5V CATV LINE DRIVER - Bulk |
发布紧急采购，3分钟左右您将得到回复。