参数资料
型号: AD8367ARUZ
厂商: Analog Devices Inc
文件页数: 13/24页
文件大小: 0K
描述: IC AMP VGA 14TSSOP
标准包装: 96
系列: X-AMP®
放大器类型: 可变增益
电路数: 1
-3db带宽: 500MHz
电流 - 输入偏压: 27µA
电流 - 电源: 26mA
电压 - 电源,单路/双路(±): 2.7 V ~ 5.5 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 14-TSSOP(0.173",4.40mm 宽)
供应商设备封装: 14-TSSOP
包装: 管件
产品目录页面: 775 (CN2011-ZH PDF)
AD8367
Rev. A | Page 20 of 24
Table 7 details the various configuration options of the evaluation board.
Table 7. Evaluation Board Configuration Options
Component
Function
Default Condition
TP1, TP2
Supply and Ground Vector Pins.
Not Applicable
TP3, TP4
Mode and Gain Vector Pins.
Not Applicable
SW1
VGA/AGC Select: Used to select VGA (Position A) or AGC (Position B) mode of
operation. SW2 must be set for Position A for AGC mode of operation.
SW1 = A
SW2
MODE Select. Used to select positive or negative VGA slope. Set to Position B for an
increasing gain with VGAIN, Position A for decreasing gain law.
SW2 = B
LK1
Device Enable. When LK1 is installed, the ENBL pin is connected to the positive supply
and the AD8367 is in operating mode.
LK1 = Installed
R1, R2
Input Interface. R1 and R2 are used to provide an L-pad impedance-transforming
network. The broadband matching network transforms a 50 Ω source to match a
200 Ω load with 11.5 dB of insertion loss.
R1 = 57.6 Ω (Size 0603)
R2 = 174 Ω (Size 0603)
R3, R4, C4
Output Interface. R3 and R4 are used to transform a 50 Ω load termination to look like
a 200 Ω load with 11.5 dB of insertion loss. The ac coupling capacitor, C4, can be
increased to obtain a lower high-pass corner frequency.
R3 = 57.6 Ω (Size 0603)
R4 = 174 Ω (Size 0603)
C4 = 0.1 μF (Size 0603)
C1, C2, C3, R5, R6
Power Supply Decoupling. The nominal supply decoupling consists of a 1 μF capacitor
to ground, a 4.7 Ω series resistor, and a 0.1 μF capacitor to ground. The same
decoupling network should be used on both the VPSI and VPSO supply lines.
C1 = 1 μF (Size 0603)
R5 = R6 = 4.7 Ω (Size 0805)
C2 = C3 = 0.1 μF (Size 0603)
C5
Internal Supply Decoupling. Capacitor C5 provides midsupply decoupling.
C5 = 10 nF (Size 0603)
CHP
Filter Capacitor. HPFL capacitor, sets the high-pass corner frequency.
CHP = 0.01 μF (Size 0805)
RHP = 0 Ω (Size 0603)
CAGC
AGC Filter Capacitor. Capacitor, CAGC, sets closed-loop AGC response time.
CAGC = 0.1 μF (Size 0805)
R7
Mode Pull-Up Resistor.
R7 = 10 kΩ (Size 0805)
RHP
High-Pass Filter Resistor.
RHP = 100 Ω (Size)
CHARACTERIZATION SETUP AND METHODS
Minimum-loss, L-pad matching networks were used to
interface standard 50 Ω. A test equipment to the 200 Ω input
impedance during the characterization process. Using a 57.6 Ω
shunt resistor followed by a 174 Ω series resistor provides a
broadband match between the 50 Ω test equipment and the
200 Ω device impedance, as illustrated in Figure 45. The
insertion loss of this network is 11.5 dB.
02710-
045
57.6
Ω
174
Ω
57.6
Ω
174
Ω
AD8367
Figure 45. Characterization Test Setup
相关PDF资料
PDF描述
LT1994MPDD#PBF IC OP AMP I/O DIFF LN 8-DFN
PBC08SBCN CONN HEADER .100 SINGL R/A 8POS
PEC27SBAN CONN HEADER .100 SINGL R/A 27POS
OP413FSZ-REEL IC OPAMP GP 3.4MHZ QUAD 16SOIC
929835-01-17 CONN HEADER .100 SNGL R/A 17POS
相关代理商/技术参数
参数描述
AD8367ARUZ 制造商:Analog Devices 功能描述:PROGRAMMABLE GAIN AMPLIFIER IC ((NW))
AD8367ARUZ 制造商:Analog Devices 功能描述:IC DETECTOR
AD8367ARUZ1 制造商:AD 制造商全称:Analog Devices 功能描述:500 MHz, Linear-in-dB VGA with AGC Detector
AD8367ARUZ-RL7 功能描述:IC AMP VGA 14TSSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:X-AMP® 标准包装:150 系列:- 放大器类型:音频 电路数:2 输出类型:- 转换速率:5 V/µs 增益带宽积:12MHz -3db带宽:- 电流 - 输入偏压:100nA 电压 - 输入偏移:500µV 电流 - 电源:6mA 电流 - 输出 / 通道:50mA 电压 - 电源,单路/双路(±):4 V ~ 32 V,±2 V ~ 16 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP(0.173",4.40mm 宽) 供应商设备封装:8-TSSOP 包装:管件
AD8367-EVAL 制造商:Analog Devices 功能描述:Evaluation Kit For 500 MHz, Linear-In-DB VGA With AGC Detector 制造商:Analog Devices 功能描述:AD8367 EVALUATION BOARD - Bulk 制造商:Analog Devices 功能描述:SEMICONDUCTOR ((NS))