参数资料
| 型号： | AD8426ACPZ-WP |
| 厂商： | Analog Devices Inc |
| 文件页数： | 20/28页 |
| 文件大小： | 0K |
| 描述： | IC AMP INSTR RR 1.5MHZ 16LFCSP |
| 标准包装： | 64 |
| 放大器类型： | 仪表 |
| 电路数： | 2 |
| 输出类型： | 满摆幅 |
| 转换速率： | 0.6 V/µs |
| -3db带宽： | 1MHz |
| 电流 - 输入偏压： | 20nA |
| 电压 - 输入偏移： | 200µV |
| 电流 - 电源： | 350µA |
| 电流 - 输出 / 通道： | 13mA |
| 电压 - 电源，单路/双路(±)： | 2.2 V ~ 36 V，±1.35 V ~ 18 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-VQFN，CSP |
| 供应商设备封装： | 16-LFCSP（4x4） |
| 包装： | 托盘 - 晶粒 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页
AD8426
Rev. 0 | Page 27 of 28
DRIVING AN ADC
Option 2 shows a circuit for driving higher frequency signals.
It uses a precision op amp (AD8616) with relatively high band-
width and output drive. This amplifier can drive a resistor and
capacitor with a much higher time constant and is, therefore,
suited for higher frequency applications.
Figure 72 shows several different methods of driving an ADC.
The ADC in the ADuC7026 microcontroller was chosen for
this example because it has an unbuffered, charge sampling
architecture that is typical of most modern ADCs. This type of
architecture typically requires an RC buffer stage between the
ADC and the amplifier to work correctly.
Option 3 is useful for applications where the AD8426 must
operate from a large voltage supply but drives a single-supply
ADC. In normal operation, the AD8426 output signal stays
within the ADC range, and the AD8616 simply buffers the signal.
However, in a fault condition, the output of the AD8426 may
go outside the supply range of both the AD8616 and the ADC.
This is not a problem in this circuit, because the 10 kΩ resistor
between the two amplifiers limits the current into the AD8616
to a safe level.
Option 1 shows the minimum configuration required to drive
a charge sampling ADC. The capacitor provides charge to the
ADC sampling capacitor, and the resistor shields the AD8426
from the capacitance. To keep the AD8426 stable, the RC time
constant of the resistor and capacitor needs to stay above 5 μs.
This circuit is mainly useful for lower frequency signals.
AD8426
REF
100nF
100
10k
10
10nF
ADC0
ADC1
ADC2
AGND
3.3V
OPTION 1: DRIVING LOW FREQUENCY SIGNALS
OPTION 2: DRIVING HIGH FREQUENCY SIGNALS
OPTION 3: PROTECTING ADC FROM LARGE VOLTAGES
3.3V
AD8426
AD8616
ADuC7026
REF
3.3V
10
10nF
AD8426
AD8616
REF
+15V
–15V
AVDD
09
49
0-
0
65
Figure 72. Driving an ADC
相关PDF资料 |
PDF描述 |
|---|---|
| TSW-124-14-T-S | CONN HEADER 24POS .100" SNGL TIN |
| AD8642ARZ | IC OPAMP JFET R-R 3.5MHZ 8SOIC |
| LT1002CN#PBF | IC PREC OPAMP DUAL MATCHED 14DIP |
| TSW-105-14-S-S | CONN HEADER 5POS .100" SGL GOLD |
| TSW-102-08-L-D-RA | CONN HEADER 4POS .100 DL R/A AU |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8426BCPZ-R7 | 功能描述:IC AMP INSTR RR 1.5MHZ 16LFCSP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:73 系列:Over-The-Top® 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.07 V/µs 增益带宽积:200kHz -3db带宽:- 电流 - 输入偏压:1nA 电压 - 输入偏移:285µV 电流 - 电源:50µA 电流 - 输出 / 通道:25mA 电压 - 电源，单路/双路(±):2 V ~ 44 V，±1 V ~ 22 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-WFDFN 裸露焊盘 供应商设备封装:16-DFN-EP（5x3） 包装:管件 |
| AD8426BCPZ-R7_PROMO | 制造商:Analog Devices 功能描述:INSTR-AMPLIFIER 1MHZ 90DB L |
| AD8426BCPZ-WP | 功能描述:IC AMP INSTR RR 1.5MHZ 16LFCSP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:150 系列:- 放大器类型:音频 电路数:2 输出类型:- 转换速率:5 V/µs 增益带宽积:12MHz -3db带宽:- 电流 - 输入偏压:100nA 电压 - 输入偏移:500µV 电流 - 电源:6mA 电流 - 输出 / 通道:50mA 电压 - 电源，单路/双路(±):4 V ~ 32 V，±2 V ~ 16 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:8-TSSOP 包装:管件 |
| AD8428 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Noise, Low Gain Drift, G = 2000 |
| AD8428_12 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Noise, Low Gain Drift, G = 2000 |
发布紧急采购，3分钟左右您将得到回复。