- 您现在的位置：买卖IC网 > PDF目录5875 > ADA4897-2ARMZ-R7 (Analog Devices Inc)IC OPAMP RR 230MHZ LP 10MSOP PDF资料下载
参数资料
| 型号： | ADA4897-2ARMZ-R7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 29/29页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP RR 230MHZ LP 10MSOP |
| 标准包装： | 1,000 |
| 放大器类型： | 电压反馈 |
| 电路数： | 2 |
| 输出类型： | 满摆幅 |
| 转换速率： | 120 V/µs |
| -3db带宽： | 230MHz |
| 电流 - 输入偏压： | 11µA |
| 电压 - 输入偏移： | 28µV |
| 电流 - 电源： | 3mA |
| 电流 - 输出 / 通道： | 80mA |
| 电压 - 电源，单路/双路(±)： | 3 V ~ 10 V，±1.5 V ~ 5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 10-MSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页当前第29页
ADA4896-2/ADA4897-1/ADA4897-2
Data Sheet
Rev. B | Page 8 of 28
ABSOLUTE MAXIMUM RATINGS
Table 6.
Parameter
Rating
Supply Voltage
11 V
Power Dissipation
See Figure 3
Common-Mode Input Voltage
VS 0.7 V to +VS + 0.7 V
Differential Input Voltage
0.7 V
Storage Temperature Range
65°C to +125°C
Operating Temperature Range
40°C to +125°C
Lead Temperature (Soldering 10 sec)
300°C
Junction Temperature
150°C
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
THERMAL RESISTANCE
θJA is specified for the worst-case conditions, that is, θJA is
specified for a device soldered in a circuit board for surface-
Table 7. Thermal Resistance
Package Type
θJA
Unit
8-Lead Dual MSOP (ADA4896-2)
222
°C/W
8-Lead Dual LFCSP (ADA4896-2)
61
°C/W
8-Lead Single SOIC (ADA4897-1)
133
°C/W
6-Lead Single SOT-23 (ADA4897-1)
150
°C/W
10-Lead Dual MSOP (ADA4897-2)
210
°C/W
MAXIMUM POWER DISSIPATION
The maximum safe power dissipation for the ADA4896-2/
ADA4897-1/ADA4897-2 is limited by the associated rise in
junction temperature (TJ) on the die. At approximately 150C,
which is the glass transition temperature, the properties of the
plastic change. Even temporarily exceeding this temperature
limit may change the stresses that the package exerts on the
die, permanently shifting the parametric performance of the
temperature of 175C for an extended period of time can result
in changes in silicon devices, potentially causing degradation or
loss of functionality.
The power dissipated in the package (PD) is the sum of the
quiescent power dissipation and the power dissipated in the
the output.
The quiescent power dissipation is the voltage between the supply
pins (±VS) multiplied by the quiescent current (IS).
PD = Quiescent Power + (Total Drive Power Load Power)
L
OUT
L
OUT
S
D
R
V
R
V
I
V
P
2
RMS output voltages should be considered. If RL is referenced to
VS, as in single-supply operation, the total drive power is VS ×
IOUT. If the rms signal levels are indeterminate, consider the worst
case, when VOUT = VS/4 for RL to midsupply.
L
S
D
R
V
I
V
P
2
4
/
In single-supply operation with RL referenced to VS, worst case
is VOUT = VS/2.
Airflow increases heat dissipation, effectively reducing θJA.
Also, more metal directly in contact with the package leads
and exposed paddle from metal traces, through holes, ground,
and power planes reduces θJA.
Figure 3 shows the maximum safe power dissipation in the
package vs. the ambient temperature on a JEDEC standard
4-layer board. θJA values are approximations.
0
0.5
1.0
1.5
2.0
2.5
3.0
3.5
–45 –35 –25 –15 –5
5
15
25
35
45
55
65
75
85
95 105 115 125
MA
XI
MU
M
PO
W
E
R
D
ISSI
P
A
TI
ON
(
W
)
AMBIENT TEMPERATURE (°C)
8-LEAD SOIC
8-LEAD LFCSP
TJ = 150°C
094
47-
053
8-LEAD MSOP
6-LEAD SOT-23
10-LEAD MSOP
Figure 3. Maximum Power Dissipation vs. Temperature for a 4-Layer Board
ESD CAUTION
相关PDF资料 |
PDF描述 |
|---|---|
| 77313-101-20LF | HDR STR DR.100 DP |
| TSW-202-07-G-S | CONN HEADER 2POS .200" SNGL |
| TSW-105-20-T-S | CONN HEADER 5POS .100" SNGL |
| TSM-102-01-T-SH-P-TR | CONN HEADER 2POS .100" SNGL SMD |
| 9-146309-0-32 | CONN HEADR BRKWAY .100 64POS R/A |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADA4897-2ARMZ-RL | 功能描述:IC OPAMP RR 230MHZ LP 10MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:73 系列:Over-The-Top® 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.07 V/µs 增益带宽积:200kHz -3db带宽:- 电流 - 输入偏压:1nA 电压 - 输入偏移:285µV 电流 - 电源:50µA 电流 - 输出 / 通道:25mA 电压 - 电源，单路/双路(±):2 V ~ 44 V，±1 V ~ 22 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-WFDFN 裸露焊盘 供应商设备封装:16-DFN-EP（5x3） 包装:管件 |
| ADA4897-2TRMZ-EP | 制造商:Analog Devices 功能描述:LOW NOISE LOW POWER R/R OP AMP DUAL - Rail/Tube 制造商:Analog Devices 功能描述:IC OPAMP GP 230MHZ RRO 10MSOP 制造商:Analog Devices 功能描述:Low Noise Low Power R/R Op Amp Dual |
| ADA4898-1 | 制造商:AD 制造商全称:Analog Devices 功能描述:High Voltage, Low Noise, Low Distortion, Unity Gain Stable, High Speed Op Amp |
| ADA4898-1YRD-EBZ | 制造商:Analog Devices 功能描述:HIGH VOLTAGE, LOW NOISE, LOW DISTORTION, UNITY-GAIN STABLE, - Boxed Product (Development Kits) |
| ADA4898-1YRDZ | 功能描述:IC OPAMP VF ULN ULDIST 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源，单路/双路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
发布紧急采购，3分钟左右您将得到回复。