- 您现在的位置：买卖IC网 > PDF目录378279 > ADC08351CIMTCX (NATIONAL SEMICONDUCTOR CORP) 8-Bit, 42 MSPS, 40 mW A/D Converter PDF资料下载
参数资料
| 型号： | ADC08351CIMTCX |
| 厂商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分类： | ADC |
| 英文描述： | 8-Bit, 42 MSPS, 40 mW A/D Converter |
| 中文描述： | 1-CH 8-BIT RESISTANCE LADDER ADC, PARALLEL ACCESS, PDSO20 |
| 封装： | TSSOP-20 |
| 文件页数： | 13/15页 |
| 文件大小： | 492K |
| 代理商： | ADC08351CIMTCX |
Applications Information
(Continued)
ACCURATELY EVALUATING THE ADC
If a signal that is spectrally impure is presented to the ADC,
the output from the ADC cannot be pure. Nearly all signal
generators in use today produce signals that are not spec-
trally pure enough to adequately evaluate present-day
ADCs. This is especially true at higher frequencies and at
high resolutions.
To ensure that the signal you are presenting to the ADC be-
ing evaluated is spectrally pure, use a bandpass filter be-
tween the signal generator and the ADC input. One such
possible filter is the elliptic filter shown in Figure 8.
In addition to being used to eliminate undesired frequencies
from a desired signal, this filter can be used to filter a square
wave, reducing 3rd and higher harmonics to negligible lev-
els.
When evaluating dynamic performance of an ADC, repeat-
ability of measurements could be a problem unless coherent
sampling is used.
and ADC08351 evaluation system is available that can sim-
plify evaluation of thsi product.
7.0 COMMON APPLICATION PITFALLS
Driving the inputs (analog or digital) beyond the power
supply rails.
For proper operation, all inputs should not go
more than 300 mV beyond the supply rails. That is, more
than 300 mV below the ground pins or 300 mV above the
supply pins. Exceeding these limits on even a transient basis
may cause faulty or erratic operation. It is not uncommon for
high speed digital circuits (e.g., 74F and 74AC devices) to
exhibit undershoot that goes more than a volt below ground
or above the power supply. Since these conditions are of
very short duration with very fast rise and fall times, they can
DS100895-29
FIGURE 7. Inverting Circuit with Bias Adjust
DS100895-31
FIGURE 8. This elliptic filter has a cutoff frequency of about 11MHz and is suitable for input frequencies of 5MHz to
10MHz. It should be driven by a generator of 75
source impedance and teminated with 75
. This termination may
be provided by the ADC evaluation circuit.
A
www.national.com
13
相关PDF资料 |
PDF描述 |
|---|---|
| ADC0841 | 8-Bit P Compatible A/D Converter |
| ADC0841BCN | 8-Bit P Compatible A/D Converter |
| ADC0841BCV | 8-Bit P Compatible A/D Converter |
| ADC0841CCN | 8-Bit P Compatible A/D Converter |
| ADC0841CCV | 8-Bit P Compatible A/D Converter |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADC08351CIMTCX/NOPB | 功能描述:模数转换器 - ADC RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| ADC08351EVAL | 功能描述:EVALUATION BOARD FOR ADC08351 RoHS:是 类别:编程器，开发系统 >> 过时/停产零件编号 系列:- 标准包装:1 系列:- 传感器类型:CMOS 成像，彩色（RGB） 传感范围:WVGA 接口:I²C 灵敏度:60 fps 电源电压:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相关产品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| ADC08351EVM | 功能描述:ADC08351EVM 制造商:texas instruments 系列:* 零件状态:在售 标准包装:1 |
| ADC0838 | 制造商:MICRO-LINEAR 制造商全称:MICRO-LINEAR 功能描述:Serial I/O 8-Bit A/D Converters with Multiplexer Options |
| ADC0838A | 制造商:TI 制造商全称:Texas Instruments 功能描述:A/D PERIPHERALS WITH SERIAL CONTROL |
发布紧急采购，3分钟左右您将得到回复。