参数资料
| 型号： | ADMP504ACEZ-RL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 13/13页 |
| 文件大小： | 0K |
| 描述： | MIC MEMS OMNI-DIR ANALOG 3LGA |
| 标准包装： | 10,000 |
| 系列： | ADMP504 |
| 类型： | MEMS（硅） |
| 输出类型： | 模拟 |
| 方向： | 全向 |
| 频率范围： | 100Hz ~ 20kHz |
| 灵敏度： | -38dB ±3dB |
| 信噪比： | 65dB |
| 阻抗： | 200 欧姆 |
| 电压 - 额定： | 1.6 ~ 3.3V |
| 电流 - 电源： | 200µA |
| 端口位置： | 底部 |
| 密封等级： | 无 |
| 端子： | 表面贴装型 |
| 尺寸/尺寸： | 3.35mm L x 2.50mm W |
| 高度（最大）： | 0.98mm |
| 形状： | 矩形 |
| 包装： | 带卷 (TR) |
ADMP504
Data Sheet
Rev. A | Page 8 of 12
HANDLING INSTRUCTIONS
PICK-AND-PLACE EQUIPMENT
The MEMS microphone can be handled using standard pick-
and-place and chip shooting equipment. Take care to avoid
damage to the MEMS microphone structure as follows:
Use a standard pickup tool to handle the microphone.
Because the microphone hole is on the bottom of the
package, the pickup tool can make contact with any part
of the lid surface.
Use care during pick-and-place to ensure that no high
shock events above 10 kg are experienced because this may
cause damage to the microphone.
Do not pick up the microphone with a vacuum tool that
makes contact with the bottom side of the microphone.
Do not pull air out or blow air into the microphone port.
Do not use excessive force to place the microphone
on the PCB.
REFLOW SOLDER
For best results, the soldering profile should be in accordance
with the recommendations of the manufacturer of the solder
paste used to attach the MEMS microphone to the PCB. It is
recommended that the solder reflow profile not exceed the
limit conditions specified in Figure 3 and Table 3.
BOARD WASH
When washing the PCB, ensure that water does not make
contact with the microphone port. Blow-off procedures and
ultrasonic cleaning must not be used.
OBSOLETE
相关PDF资料 |
PDF描述 |
|---|---|
| ADMP521ACEZ-RL7 | IC MEMS MICROPHONE ULTRA LN 5LGA |
| ADN2890ACP-RL7 | IC AMP LIM 16LFCSP |
| ADN2891ACPZ-500RL7 | IC AMP LIM 16LFCSP |
| ADN2892ACPZ-500RL7 | IC AMP LIM 16LFCSP |
| ADR827BRMZ-REEL7 | IC OPAMP GP R-R 1MHZ LP 10MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADMP504ACEZ-RL7 | 功能描述:MIC MEMS OMNI-DIR ANALOG 3LGA RoHS:是 类别:音频产品 >> 麦克风 系列:ADMP504 产品目录绘图:SPM04xxHx(5,xH)-xB SP Series_FTPRNT-5 标准包装:1 系列:SiSonic™ 类型:MEMS（硅） 输出类型:模拟 方向:全向 频率范围:100Hz ~ 10kHz 灵敏度:-42dB ±3dB 信噪比:59dB 阻抗:100 欧姆 电压 - 额定:1.5 ~ 3.6V 电流 - 电源:250µA 端口位置:顶部 密封等级:无 端子:表面贴装型 尺寸/尺寸:4.72mm L x 3.76mm W 高度（最大）:1.35mm 形状:矩形 包装:Digi-Reel® 产品目录页面:2669 (CN2011-ZH PDF) 其它名称:423-1131-6 |
| ADMP504XCEZ-RL7 | 制造商:Analog Devices 功能描述:- Tape and Reel |
| ADMP510 | 制造商:AD 制造商全称:Analog Devices 功能描述:RF Hardened, Ultralow Noise Microphone with Bottom Port and Analog Output |
| ADMP510ACEZ-RL | 制造商:AD 制造商全称:Analog Devices 功能描述:RF Hardened, Ultralow Noise Microphone with Bottom Port and Analog Output |
| ADMP510ACEZ-RL7 | 制造商:AD 制造商全称:Analog Devices 功能描述:RF Hardened, Ultralow Noise Microphone with Bottom Port and Analog Output |
发布紧急采购，3分钟左右您将得到回复。