- 您现在的位置：买卖IC网 > PDF目录16950 > ADP1740-1.5-EVALZ (Analog Devices Inc)BOARD EVAL FOR ADP1740-1.5 PDF资料下载
参数资料
| 型号： | ADP1740-1.5-EVALZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 12/20页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL FOR ADP1740-1.5 |
| 标准包装： | 1 |
| 每 IC 通道数： | 1 - 单 |
| 输出电压： | 1.5V |
| 电流 - 输出： | 2A |
| 输入电压： | 1.6 ~ 3.6 V |
| 稳压器类型： | 正，固定式 |
| 工作温度： | -40°C ~ 125°C |
| 板类型： | 完全填充 |
| 已供物品： | 板 |
| 已用 IC / 零件： | ADP1740 |
ADP1740/ADP1741
Data Sheet
1
T
EN
The EN pin active/inactive thresholds are derived from the VIN
voltage. Therefore, these thresholds vary with changing input
voltage. Figure 29 shows typical EN active/inactive thresholds
when the input voltage varies from 1.6 V to 3.6 V.
1.1
1.0
V OUT
0.9
EN ACTIVE
2
500mV/DIV
V OUT = 1.5V
C IN = C OUT = 4.7μF
0.8
EN INACTIVE
CH1 2.0V BW
CH2 500mV BW M40μs
A CH1
920mV
0.7
T 9.8%
Figure 27. V OUT Ramp-Up with Internal Soft Start
ADJUSTABLE OUTPUT VOLTAGE (ADP1741)
0.6
The output voltage of the ADP1741 can be set over a 0.75 V to
0.5
1.6
1.8
2.0
2.2
2.4
2.6
2.8
3.0
3.2
3.4
3.6
3.3 V range. The output voltage is set by connecting a resistive
voltage divider from VOUT to ADJ. The output voltage is calcu-
lated using the following equation:
INPUT VOLTAGE (V)
Figure 29. Typical EN Pin Thresholds vs. Input Voltage
POWER-GOOD FEATURE
V OUT = 0.5 V × (1 + R1 / R2 )
(2)
The ADP1740/ADP1741 provide a power-good pin, PG, to
where:
R1 is the resistor from VOUT to ADJ.
R2 is the resistor from ADJ to GND.
The maximum bias current into ADJ is 150 nA, so to achieve less
than 0.5% error due to the bias current, use values less than
60 kΩ for R2.
ENABLE FEATURE
The ADP1740/ADP1741 use the EN pin to enable and disable
the VOUT pins under normal operating conditions. As shown
in Figure 28, when a rising voltage on EN crosses the active
threshold, VOUT turns on. When a falling voltage on EN
crosses the inactive threshold, VOUT turns off.
T
EN
indicate the status of the output. This open-drain output
requires an external pull-up resistor to VIN. If the part is in
shutdown mode, current-limit mode, or thermal shutdown, or
if it falls below 90% of the nominal output voltage, the power-
good pin (PG) immediately transitions low. During soft start,
the rising threshold of the power-good signal is 93.5% of the
nominal output voltage.
The open-drain output is held low when the ADP1740/ADP1741
have sufficient input voltage to turn on the internal PG transistor.
An optional soft start delay can be detected. The PG transistor
is terminated via a pull-up resistor to VOUT or VIN.
Power-good accuracy is 93.5% of the nominal regulator output
voltage when this voltage is rising, with a 90% trip point when
this voltage is falling. Regulator input voltage brownouts or
glitches trigger power no-good if V OUT falls below 90%.
A normal power-down triggers power no-good when V OUT
drops below 90%.
V OUT
2 1
500mV/DIV
V OUT = 1.5V
C IN = C OUT = 4.7μF
CH1 500mV BW CH2 500mV BW M2.0ms
A CH1
1.05V
T 29.6%
Figure 28. Typical EN Pin Operation
As shown in Figure 28, the EN pin has hysteresis built in. This
hysteresis prevents on/off oscillations that can occur due to
noise on the EN pin as it passes through the threshold points.
Rev. F | Page 12 of 20
相关PDF资料 |
PDF描述 |
|---|---|
| RMA06DRMI-S288 | CONN EDGECARD 12POS .125 EXTEND |
| EYM06DRMD-S664 | CONN EDGECARD 12POS .156 WW |
| GBA31DRSN-S288 | CONN EDGECARD 62POS .125 EXTEND |
| GEM31DTKN-S288 | CONN EDGECARD 62POS .156 EXTEND |
| VI-J5V-EY | CONVERTER MOD DC/DC 5.8V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADP1740ACPZ-0.75R7 | 功能描述:IC REG LDO 0.75V 2A 16LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:anyCAP® 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:最高 6V 电压 - 压降（标准）:0.23V @ 1.5A 稳压器数量:1 电流 - 输出:1.5A 电流 - 限制（最小）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:TO-261-4，TO-261AA 供应商设备封装:SOT-223-3 包装:Digi-Reel® 其它名称:ADP3339AKCZ-3.3-RLDKR |
| ADP1740ACPZ-0.75-R7 | 制造商:AD 制造商全称:Analog Devices 功能描述:2 A, Low VIN, Low Dropout Linear Regulator |
| ADP1740ACPZ-1.0-R7 | 功能描述:IC REG LDO 1V 2A 16LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:MIC5365/66 Ultra-small LDO Regulators 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降（标准）:0.155V @ 150mA 稳压器数量:1 电流 - 输出:150mA 电流 - 限制（最小）:200mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:4-UDFN 裸露焊盘，4-TMLF? 供应商设备封装:4-TMLF?（1x1） 包装:Digi-Reel® 其它名称:576-3192-6 |
| ADP1740ACPZ-1.1-R7 | 功能描述:IC REG LDO 1.1V 2A 16LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:anyCAP® 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:最高 6V 电压 - 压降（标准）:0.23V @ 1.5A 稳压器数量:1 电流 - 输出:1.5A 电流 - 限制（最小）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:TO-261-4，TO-261AA 供应商设备封装:SOT-223-3 包装:Digi-Reel® 其它名称:ADP3339AKCZ-3.3-RLDKR |
| ADP1740ACPZ-1.2-R7 | 功能描述:IC REG LDO 1.2V 2A 16LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:MIC5365/66 Ultra-small LDO Regulators 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降（标准）:0.155V @ 150mA 稳压器数量:1 电流 - 输出:150mA 电流 - 限制（最小）:200mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:4-UDFN 裸露焊盘，4-TMLF? 供应商设备封装:4-TMLF?（1x1） 包装:Digi-Reel® 其它名称:576-3192-6 |
发布紧急采购，3分钟左右您将得到回复。