- 您现在的位置：买卖IC网 > PDF目录12016 > ADUC7121BBCZ (Analog Devices Inc)IC ARM7TDMI MCU 126KB 108CSPBGA PDF资料下载
参数资料
| 型号： | ADUC7121BBCZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 16/96页 |
| 文件大小： | 0K |
| 描述： | IC ARM7TDMI MCU 126KB 108CSPBGA |
| 标准包装： | 1 |
| 系列： | MicroConverter® ADuC7xxx |
| 核心处理器： | ARM7 |
| 芯体尺寸： | 16/32-位 |
| 速度： | 41.78MHz |
| 连通性： | I²C，SPI，UART/USART |
| 外围设备： | POR，PWM，WDT |
| 输入/输出数： | 32 |
| 程序存储器容量： | 126KB（63K x 16） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 8K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 3 V ~ 3.6 V |
| 数据转换器： | A/D 9x12b，D/A 4x12b |
| 振荡器型： | 内部 |
| 工作温度： | -10°C ~ 95°C |
| 封装/外壳： | 108-LFBGA，CSPBGA |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页
Data Sheet
ADuC7121
Rev. B | Page 23 of 96
MEMORY ORGANIZATION
The ADuC7121 incorporates three separate blocks of memory:
8 kB of SRAM and two 64 kB of on-chip Flash/EE memory.
There are 126 kB of on-chip Flash/EE memory available to the
user, and the remaining 2 kB are reserved for the factory-
configured boot page. These two blocks are mapped as shown
Note that by default, after a reset, the Flash/EE memory is mirrored
at Address 0x00000000. It is possible to remap the SRAM at
Address 0x00000000 by clearing Bit 0 of the REMAP MMR.
This remap function is described in more detail in the Flash/EE
Memory section.
Figure 9. Physical Memory Map
MEMORY ACCESS
The ARM7 core sees memory as a linear array of 232 byte
locations where the different blocks of memory are mapped as
outlined in Figure 9.
The ADuC7121 memory organization is configured in little
endian format: the least significant byte is located in the lowest
byte address and the most significant byte is located in the
highest byte address.
Figure 10. Little Endian Format
FLASH/EE MEMORY
The 128 kB of Flash/EE are organized as two banks of 32k × 16
bits. The first block, Block 0, controls flash, starting at
Address 0x80000 and finishing at Address 0x90000. In the first
block, 31k × 16 bits is user space and 1k × 16 bits is reserved for
the factory configured boot page. The page size of this Flash/EE
memory is 512 bytes.
The second block, Block 1, controls flash, starting at
Address 0x90000 and finishing at Address 0x9F700. The second
64 kB block is arranged in 32k × 16 bits, all of which is available
as user space.
The 126 kB of Flash/EE are available to the user as code and
nonvolatile data memory. There is no distinction between data
and program because ARM code shares the same space. The real
width of the Flash/EE memory is 16 bits, meaning that in ARM
mode (32-bit instruction), two accesses to the Flash/EE are neces-
sary for each instruction fetch. Therefore, it is recommended that
Thumb mode be used when executing from Flash/EE memory
for optimum access speed. The maximum access speed for the
Flash/EE memory is 41.78 MHz in Thumb mode and 20.89 MHz
in full ARM mode (see the Execution Time from SRAM and
FLASH/EE section).
SRAM
The 8 kB of SRAM are available to the user, organized as 2k ×
32 bits, that is, 2k words. ARM code can run directly from
SRAM at 41.78 MHz, given that the SRAM array is configured
as a 32-bit wide memory array (see the Execution Time from
SRAM and FLASH/EE section).
MEMORY MAPPED REGISTERS
The memory mapped register (MMR) space is mapped into the
upper two pages of the memory array and accessed by indirect
addressing through the ARM7 banked registers.
The MMR space provides an interface between the CPU and all
on-chip peripherals. All registers, except the core registers, reside
in the MMR area. All shaded locations shown in Figure 11 are
unoccupied or reserved locations and should not be accessed by
user software. Table 10 through Table 27 provide the complete
MMR memory maps.
The access time reading or writing an MMR depends on the
advanced microcontroller bus architecture (AMBA) bus used
to access the peripheral. The processor has two AMBA buses:
advanced high performance bus (AHB) used for system modules
and advanced peripheral bus (APB) used for a lower performance
peripheral. Access to the AHB is one cycle, and access to the
APB is two cycles. All peripherals on the ADuC7121 are on the
APB except the Flash/EE memory and the GPIOs.
RESERVED
0x00080000
FLASH/EE
RESERVED
0x00041FFF
0x00040000
SRAM
0xFFFF0000
0xFFFFFFFF
MMRs
0x0001FFFF
0x00000000
0x0009F800
RESERVED
REMAPPABLE MEMORY SPACE
(FLASH/EE OR SRAM)
09492-
009
BIT 31
BYTE 2
A
6
2
.
BYTE 3
B
7
3
.
BYTE 1
9
5
1
.
BYTE 0
8
4
0
.
BIT 0
32 BITS
0xFFFFFFFF
0x00000004
0x00000000
09492-
010
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B34-IY-F1 | CONVERTER MOD DC/DC 48V 50W |
| VI-JTZ-IX-F4 | CONVERTER MOD DC/DC 2V 30W |
| VE-B33-IY-F4 | CONVERTER MOD DC/DC 24V 50W |
| VI-JTZ-IW-F4 | CONVERTER MOD DC/DC 2V 40W |
| VJ2220Y824KBAAT4X | CAP CER 0.82UF 50V 10% X7R 2220 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADUC7121BBCZ-RL | 功能描述:PRECISION ANALOG MCU I.C RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC7xxx 标准包装:38 系列:Encore!® XP® 核心处理器:eZ8 芯体尺寸:8-位 速度:5MHz 连通性:IrDA，UART/USART 外围设备:欠压检测/复位，LED，POR，PWM，WDT 输入/输出数:16 程序存储器容量:4KB（4K x 8） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:1K x 8 电压 - 电源 (Vcc/Vdd):2.7 V ~ 3.6 V 数据转换器:- 振荡器型:内部 工作温度:-40°C ~ 105°C 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 包装:管件 其它名称:269-4116Z8F0413SH005EG-ND |
| ADUC7122 | 制造商:AD 制造商全称:Analog Devices 功能描述:Precision Analog Microcontroller, 12-Bit Analog I/O, ARM7TDMI? MCU |
| ADUC7122BBCZ | 功能描述:IC ARM7TDMI MCU 126KB 108CSPBGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC7xxx 标准包装:250 系列:56F8xxx 核心处理器:56800E 芯体尺寸:16-位 速度:60MHz 连通性:CAN，SCI，SPI 外围设备:POR，PWM，温度传感器，WDT 输入/输出数:21 程序存储器容量:40KB（20K x 16） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:6K x 16 电压 - 电源 (Vcc/Vdd):2.25 V ~ 3.6 V 数据转换器:A/D 6x12b 振荡器型:内部 工作温度:-40°C ~ 125°C 封装/外壳:48-LQFP 包装:托盘 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323 |
| ADUC7122BBCZ-RL | 功能描述:PRECISION ANALOG MCU I.C RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC7xxx 标准包装:38 系列:Encore!® XP® 核心处理器:eZ8 芯体尺寸:8-位 速度:5MHz 连通性:IrDA，UART/USART 外围设备:欠压检测/复位，LED，POR，PWM，WDT 输入/输出数:16 程序存储器容量:4KB（4K x 8） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:1K x 8 电压 - 电源 (Vcc/Vdd):2.7 V ~ 3.6 V 数据转换器:- 振荡器型:内部 工作温度:-40°C ~ 105°C 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 包装:管件 其它名称:269-4116Z8F0413SH005EG-ND |
| ADUC7124 | 制造商:AD 制造商全称:Analog Devices 功能描述:Precision Analog Microcontroller, 12-Bit Analog I/O, Large Memory, ARM7TDMI MCU with Enhanced IRQ Handler |
发布紧急采购，3分钟左右您将得到回复。