- 您现在的位置：买卖IC网 > PDF目录18800 > AS5045-ASST (ams)IC ENCODER PROG 12-BIT 16-SSOP PDF资料下载
参数资料
| 型号： | AS5045-ASST |
| 厂商： | ams |
| 文件页数： | 27/34页 |
| 文件大小： | 0K |
| 描述： | IC ENCODER PROG 12-BIT 16-SSOP |
| 应用说明： | AS5000 Series Magnet Selection Guide AS5000 Series Magnets for Extended Vertical Range |
| 标准包装： | 1 |
| 传感范围： | 45mT ~ 75mT |
| 类型： | 线性，旋转编码器 - 可编程 |
| 电源电压： | 3 V ~ 3.6 V，4.5 V ~ 5.5 V |
| 电流 - 电源： | 21mA |
| 电流 - 输出（最大）： | 4mA |
| 输出类型： | 数字式，PWM，12 位串行 |
| 特点： | 可编程 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 16-SSOP |
| 包装： | 标准包装 |
| 产品目录页面： | 804 (CN2011-ZH PDF) |
| 其它名称： | AS5045-ASSTDKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页当前第27页第28页第29页第30页第31页第32页第33页第34页
AS5045
Data Sheet
The chip will continue to operate, but with degraded output linearity, if the signal field strength is outside the
recommended range. Too strong magnetic fields will introduce errors due to saturation effects in the internal
preamplifiers. Too weak magnetic fields will introduce errors due to noise becoming more dominant.
16 Failure Diagnostics
The AS5045 also offers several diagnostic and failure detection features:
16.1 Magnetic Field Strength Diagnosis
By software: the MagINC and MagDEC status bits will both be high when the magnetic field is out of range.
By hardware: Pins #1 (MagINCn) and #2 (MagDECn) are open-drain outputs and will both be turned on (= low with
external pull-up resistor) when the magnetic field is out of range. If only one of the outputs are low, the magnet is
either moving towards the chip (MagINCn) or away from the chip (MagDECn).
16.2 Power Supply Failure Detection
By software: If the power supply to the AS5045 is interrupted, the digital data read by the SSI will be all “0”s. Data is
only valid, when bit OCF is high, hence a data stream with all “0”s is invalid. To ensure adequate low levels in the
failure case, a pull-down resistor (~10k Ω ) should be added between pin DO and VSS at the receiving side
By hardware: The MagINCn and MagDECn pins are open drain outputs and require external pull-up resistors. In
normal operation, these pins are high ohmic and the outputs are high (see Table 5 ). In a failure case, either when the
magnetic field is out of range of the power supply is missing, these outputs will become low. To ensure adequate low
levels in case of a broken power supply to the AS5045, the pull-up resistors (~10k Ω ) from each pin must be
connected to the positive supply at pin 16 (VDD5V).
By hardware: PWM output: The PWM output is a constant stream of pulses with 1kHz repetition frequency. In case
of power loss, these pulses are missing
17 Angular Output Tolerances
17.1 Accuracy
Accuracy is defined as the error between measured angle and actual angle. It is influenced by several factors:
the non-linearity of the analog-digital converters,
internal gain and mismatch errors,
non-linearity due to misalignment of the magnet
As a sum of all these errors, the accuracy with centered magnet = (Err max – Err min )/2 is specified as better than ± 0.5
degrees @ 25°C (see Figure 22 ).
Misalignment of the magnet further reduces the accuracy. Figure 21 shows an example of a 3D-graph displaying
non-linearity over XY-misalignment. The center of the square XY-area corresponds to a centered magnet (see dot in
the center of the graph). The X- and Y- axis extends to a misalignment of ± 1mm in both directions. The total
misalignment area of the graph covers a square of 2x2 mm (79x79mil) with a step size of 100μm.
For each misalignment step, the measurement as shown in is repeated and the accuracy (Err max – Err min )/2
0.25° in) is entered as the Z-axis in the 3D-graph.
(e.g.
www.austriamicrosystems.com
Revision 1.7
26 – 33
相关PDF资料 |
PDF描述 |
|---|---|
| ASFLM1-12.000MHZ-C | OSC MEMS 12.000 MHZ 3.0V SMD |
| RA202820XX | RECTIFIER 2800V 2000A |
| ASFLM1-27.000MHZ-C | OSC MEMS 27.000 MHZ 3.0V SMD |
| ASFLM1-24.576MHZ-C | OSC MEMS 24.576 MHZ 3.0V SMD |
| RA202625XX | RECTIFIER 2600V 2500A |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AS5045ASSU | 制造商:AMS 功能描述:IC MAGNETIC ROTARY ENCODER 12BIT SSOP16 制造商:AMS 功能描述:IC, MAGNETIC ROTARY ENCODER 12BIT SSOP16 制造商:AMS 功能描述:IC, MAGNETIC ROTARY ENCODER 12BIT SSOP16; IC Function:Encoder IC; Brief Features:360 Contactless High Resolution Angular Position Encoding, Two 12-bit Absolute Output; Supply Voltage Min:3V; Supply Voltage Max:3.6V; No. of Pins:16 ;RoHS Compliant: Yes |
| AS5045-ASSU | 功能描述:板机接口霍耳效应/磁性传感器 RoHS:否 制造商:Honeywell 类型:Bipolar Hall-Effect Digital Position Sensor 工作电源电压:3 V to 24 V 电源电流:3.5 mA 最大输出电流:20 mA 工作点最小值/最大值:5 G, 55 G 最小/最大释放点（Brp）:- 55 G, - 5 G 最大工作温度:+ 150 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23 |
| AS5045B | 制造商:AMSCO 制造商全称:austriamicrosystems AG 功能描述:12-Bit Programmable Magnetic Position Sensor |
| AS5045B-ASSM | 制造商:ams 功能描述:T&R / SSOP 16 |
| AS5045B-ASST | 制造商:ams 功能描述:T&R / SSOP 16 |
发布紧急采购，3分钟左右您将得到回复。