- 您现在的位置：买卖IC网 > PDF目录381497 > AT83EB5114XXXTGRIL (ATMEL CORP) Low-pin-count 8-bit microcontroller with A/D converter PDF资料下载
参数资料
| 型号： | AT83EB5114XXXTGRIL |
| 厂商： | ATMEL CORP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | Low-pin-count 8-bit microcontroller with A/D converter |
| 中文描述： | 8-BIT, MROM, 40 MHz, MICROCONTROLLER, PDSO20 |
| 封装： | SO-20 |
| 文件页数： | 20/95页 |
| 文件大小： | 1126K |
| 代理商： | AT83EB5114XXXTGRIL |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页
20
4311A–8051–01/05
their data during Idle. The port pins hold the logical states they had at the time Idle was
activated. ALE and PSEN are held at logic high levels. The different operating modes
are summarized on Table 10 on page 21.
Exit from Idle Mode
There are two ways to terminate idle mode. Activation of any enabled interrupt will
cause PCON.0 to be cleared by hardware, terminating Idle mode. The interrupt will be
serviced, and following RETI the next instruction to be executed will be the one following
the instruction that put the device into idle. Exit from idle mode will leave the oscillators
control bits on OSCON and CKS registers unchanged.
The flag bits GF0 and GF1 can be used to give an indication if an interrupt occurred dur-
ing normal operation or during an Idle mode. For example, an instruction that activates
Idle mode can also set one or both flag bits. When Idle is terminated by an interrupt, the
interrupt service routine can examine the flag bits.
The other way of terminating the Idle mode is with a hardware reset. Since the clock
oscillator is still running, the hardware reset needs to be held active for only two
machine cycles (24 oscillator periods) to complete the reset.
In both cases, PCON.0 is cleared by hardware.
Quiet Mode
The quiet mode is a pseudo idle mode in which the CPU and all the peripherals except
the AD converter are down. For more details, See “Analog-to-Digital Converter (ADC)”
on page 57.
Power-down Mode
To save maximum power, a power-down mode can be invoked by software (refer to
Table 11 on page 22). In power-down mode, the oscillator is stopped and the instruction
that invoked power-down mode is the last instruction executed. The internal RAM and
SFRs retain their value until the power-down mode is terminated. V
CC
can be lowered to
save further power.
Entering Power-down Mode
An instruction that sets PCON.1 causes that to be the last instruction executed before
going into the power-down mode.
The ports status under power-down is the previous status before entering this power
mode.
Exit from Power-down Mode
Either a hardware reset or an external interrupt (low level) on INT0 or INT1 (if enabled)
can cause an exit from power-down. To properly terminate power-down, the reset or
external interrupt should not be executed before V
CC
is restored to its normal operating
level and must be held active long enough for the oscillator to restart and stabilize.
Exit from power-down by external interrupt does not affect the SFRs and the internal
RAM content.
Figure 6.
Power-down Exit Waveform
By a hardware Reset, the CPU will restart in the mode defined by the RST_OSC1 and
RST_OSC0 bits in HSB.
INTERRUPT
OSC
Power-down phase
Oscillator restart phase
Active phase
Active phase
相关PDF资料 |
PDF描述 |
|---|---|
| AT89EB5114 | Low-pin-count 8-bit microcontroller with A/D converter |
| AT89EB5114-TGSIL | Low-pin-count 8-bit microcontroller with A/D converter |
| AT83EB5114 | Low-pin-count 8-bit microcontroller with A/D converter |
| AT83R22OK | CardMan Smart Key |
| AT83R22OK_06 | CardMan Smart Key |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT83EB5114XXXTGRUL | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Low-pin-count 8-bit microcontroller with A/D converter |
| AT83EC5122 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:MICROCONTROLLER WITH USB AND SMART CARD READER INTERFACES |
| AT83EC5123 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:MICROCONTROLLER WITH USB AND SMART CARD READER INTERFACES |
| AT83EC5136-PLTUL | 功能描述:IC MCU 8BIT 32KB FLASH 48MLF 制造商:microchip technology 系列:- 零件状态:Digi-Key 停止供應 核心处理器:80C52 核心尺寸:8-位 速度:48MHz 连接性:EBI/EMI，I2C，SPI，UART/USART，USB 外设:LED，POR，PWM，WDT I/O 数:34 程序存储容量:32KB（32K x 8） 程序存储器类型:闪存 EEPROM 容量:512 x 8 RAM 容量:1K x 8 电压 - 电源（Vcc/Vdd）:2.7 V ~ 3.6 V 数据转换器:- 振荡器类型:内部 工作温度:-40°C ~ 85°C（TA） 基本零件编号:AT83EC5136 标准包装:260 |
| AT83EC5136XXX-PNTUL | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-bit Microcontroller with Full Speed USB Device |
发布紧急采购，3分钟左右您将得到回复。