参数资料
| 型号： | AT91SAM9G20B-CFU |
| 厂商： | Atmel |
| 文件页数： | 6/42页 |
| 文件大小： | 0K |
| 描述： | IC MCU ARM9 247-LFBGA |
| 产品培训模块： | MCU Product Line Introduction |
| 标准包装： | 240 |
| 系列： | SAM9G |
| 核心处理器： | ARM9 |
| 芯体尺寸： | 16/32-位 |
| 速度： | 400MHz |
| 连通性： | EBI/EMI，以太网，I²C，IrDA，ISI，MMC，SPI，SSC，UART/USART，USB |
| 外围设备： | DMA，POR，PWM，WDT |
| 输入/输出数： | 96 |
| 程序存储器容量： | 64KB（64K x 8） |
| 程序存储器类型： | ROM |
| RAM 容量： | 96K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 0.9 V ~ 1.1 V |
| 数据转换器： | A/D 4x10b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 247-TFBGA |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
14
6384DS–ATARM–13-Jan-10
AT91SAM9G20 Summary
6.
I/O Line Considerations
6.1
JTAG Port Pins
TMS, TDI and TCK are schmitt trigger inputs and have no pull-up resistors.
TDO and RTCK are outputs, driven at up to VDDIOP, and have no pull-up resistor.
The JTAGSEL pin is used to select the JTAG boundary scan when asserted at a high level. It
integrates a permanent pull-down resistor of about 15 k
Ω to GND, so that it can be left uncon-
nected for normal operations.
The NTRST signal is described in the Reset Pins paragraph.
All the JTAG signals are supplied with VDDIOP.
6.2
Test Pin
The TST pin is used for manufacturing test purposes when asserted high. It integrates a perma-
nent pull-down resistor of about 15 k
Ω to GNDBU, so that it can be left unconnected for normal
operations. Driving this line at a high level leads to unpredictable results.
This pin is supplied with VDDBU.
6.3
Reset Pins
NRST is an open-drain output integrating a non-programmable pull-up resistor. It can be driven
with voltage at up to VDDIOP.
NTRST is an input which allows reset of the JTAG Test Access port. It has no action on the
processor.
As the product integrates power-on reset cells, which manages the processor and the JTAG
reset, the NRST and NTRST pins can be left unconnected.
The NRST and NTRST pins both integrate a permanent pull-up resistor of 100 k
Ω minimum to
VDDIOP.
The NRST signal is inserted in the Boundary Scan.
6.4
PIO Controllers
All the I/O lines are Schmitt trigger inputs and all the lines managed by the PIO Controllers inte-
grate a programmable pull-up resistor of 75 k
Ωtypical with the exception of P4 - P31. For details,
refer to the section “AT91SAM9G20 Electrical Characteristics”. Programming of this pull-up
resistor is performed independently for each I/O line through the PIO Controllers.
6.5
I/O Line Drive Levels
The PIO lines drive current capability is described in the DC Characteristics section of the prod-
uct datasheet.
6.6
Shutdown Logic Pins
The SHDN pin is a tri-state output only pin, which is driven by the Shutdown Controller. There is
no internal pull-up. An external pull-up to VDDBU is needed and its value must be higher than 1
M
Ω. The resisitor value is calculated according to the regulator enable implementation and the
SHDN level.
The pin WKUP is an input-only. It can accept voltages only between 0V and VDDBU.
相关PDF资料 |
PDF描述 |
|---|---|
| AT91SAM9N12-CU | IC MCU ARM9 217-LFBGA |
| AT91SAM9R64-CU-999 | IC MCU ARM9 32KB ROM 144LFBGA |
| AT91SAM9XE512-QU | MCU ARM9 512K FLASH 208-PQFP |
| AT97SC3204-X1A50-1 | CRYPTO TPM LPC 3.0-3.6V 28TSSOP |
| ATA6620N-TAQY | TXRX LIN BUS W/VREG SO-8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT91SAM9G20B-CU | 功能描述:ARM微控制器 - MCU 2x16K SRAM Ethernet USB Host Bus Intrfc RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
| AT91SAM9G20B-CU-999 | 功能描述:ARM微控制器 - MCU 2x16K SRAM Ethernet USB Host Bus Intrfc RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
| AT91SAM9G20-CU | 功能描述:ARM微控制器 - MCU 32-bit RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
| AT91SAM9G20-EK | 功能描述:开发板和工具包 - ARM 32-bit MCU Eval Kit RoHS:否 制造商:Arduino 产品:Development Boards 工具用于评估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口类型:DAC, ICSP, JTAG, UART, USB 工作电源电压:3.3 V |
| AT91SAM9G25-BFU | 制造商:Atmel Corporation 功能描述:VFBGA, GREEN, IND TEMP, MRLA - Trays 制造商:Atmel Corporation 功能描述:IC MCU ARM9 64KB ROM 247VFBGA |
发布紧急采购，3分钟左右您将得到回复。