参数资料
| 型号： | BD8621EFV-E2 |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 10/17页 |
| 文件大小： | 0K |
| 描述： | IC PWR SUPP 3A W/FET HTSSOP-B20 |
| 标准包装： | 2,500 |
| 应用： | 控制器，平面电视 |
| 输入电压： | 2.8 V ~ 6 V |
| 输出数： | 1 |
| 工作温度： | -10°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-VSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 20-HTSSOP-B |
| 包装： | 带卷 (TR) |
BD8621EFV
Technical Note
Under voltage lock out protection (UVLO)
As for BD8621EFV, the power-supply voltage decrease detection protection circuit is built in.
It the input voltage decrease below the UVLO voltage (2.5V typ), the device state changes to the standby mode (Moreover,
to prevent the chattering of the output) hysteresis width of 100mV(typ) has been installed in the UVLO cancel voltage.
RT terminal open/short protection function (RTO/RTS)
RT terminal opening/short protection function prevent the clock from abnormal oscillation.
If RT terminal open/short protection function is detected, output voltage changes to low level and is fixed.
Terminal RT opening/short protection function is available if the state continue for 500usec, abnormal detection operates
when the state continues about 500 μ sec(typ).
Soft start time-out function
If VSS doesn't exceed VSSTH within 64msec (typ) since a soft start began, BD8621EFV controls an off latch.
Vo is fixed in a low level.
Fig.5 Soft start time-out
Thermal shut down function
Thermal shut down circuit (TSD circuit) is built into BD8621EFV. When the temperature of the chip exceeds Tjmax=175, the
DC/DC converter is fixed in a low voltage.
TSD function is aimed to shut down IC from thermal reckless driving under an abnormal state to exceed Tjmax=175.
It aims at neither protection nor the guarantee of the set. Therefore, please do not use this function to protect the set.
Over current protection function
The over current protection function has been achieved by limiting the current that flows on high side MOSFET.
The current is controlled in every one cycle of the switching frequency. When an abnormal state continues for about
500 μ sec(typ), the output is fixed in a low level.
www.rohm.com
? 2009 ROHM Co., Ltd. All rights reserved.
10/14
2009.05 - Rev.A
相关PDF资料 |
PDF描述 |
|---|---|
| BD8622EFV-E2 | IC PWR SUPP 3A W/FET HTSSOP-B20 |
| BD8629FS-E2 | IC PWR SUPP 2A W/FET SSOP-A16 |
| BD8643FV-E2 | IC REG BUCK SYNC ADJ 3A 20SSOP |
| BD8649EFV-E2 | IC REG BUCK SYNC ADJ HTSSOPB20 |
| BD8963EFJ-E2 | IC REG BUCK SYNC ADJ 3A 8HTSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BD8622EFV | 制造商:ROHM 制造商全称:Rohm 功能描述:Built-in 1ch FET Light Load Type DC / DC converters |
| BD8622EFV_09 | 制造商:ROHM 制造商全称:Rohm 功能描述:Built-in 1ch FET Light Load Type DC / DC converters |
| BD8622EFV-E2 | 功能描述:IC PWR SUPP 3A W/FET HTSSOP-B20 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| BD8624EFV | 制造商:ROHM 制造商全称:Rohm 功能描述:Built-in 1ch FET Synchronous Rectification Type DC/DC converters |
| BD8624EFV-E2 | 制造商:ROHM Semiconductor 功能描述:POWER SUPPLY IC - Tape and Reel 制造商:ROHM Semiconductor 功能描述:IC REG BUCK SYNC 5V 3A 24-HTSSOP 制造商:ROHM Semiconductor 功能描述:IC POWER SUPPLY HTSSOP-B24 |
发布紧急采购，3分钟左右您将得到回复。