参数资料
| 型号： | BD9140MUV-E2 |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 13/21页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 2A VQFN020 |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 2.5 V ~ 6 V |
| 输入电压： | 4.5 V ~ 13.2 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 500kHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 105°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | VQFN020V4040 |
BD9141MUV
3. Selection of input capacitor (Cin)
Datasheet
V CC
Cin
Input capacitor to select must be a low ESR capacitor of the capacitance
sufficient to cope with high ripple current to prevent high transient voltage. The
ripple current IRMS is given by the equation (5):
V CC
L
Co
V OUT
√ V OUT (V CC -V OUT )
I RMS =I OUT ×
< Worst case > I RMS(max.)
When Vcc is twice the V OUT , I RMS =
[A] ??? (5)
I OUT
2
Fig.30 Input capacitor
If V CC =8V, V OUT =5V, and I OUTmax.= 2A, (BD9140MUV)
I RMS =2 ×
√ 5(8-5)
3 3.3
.
=0.97[A RMS ]
3
A low ESR 22μF/25V ceramic capacitor is recommended to reduce ESR dissipation of input capacitor for better efficiency.
4. Determination of R ITH , C ITH that works as a phase compensator
As the Current Mode Control is designed to limit a inductor current, a pole (phase lag) appears in the low frequency area
due to a CR filter consisting of a output capacitor and a load resistance, while a zero (phase lead) appears in the high
frequency area due to the output capacitor and its ESR. So, the phases are easily compensated by adding a zero to the
power amplifier output with C and R as described below to cancel a pole at the power amplifier.
fp(Min.)
fp=
fz (ESR) =
Gain
[dB]
A
0
I OUT Min.
fp(Max.)
I OUT Max.
fz(ESR)
1
2 π× R O × C O
1
2 π× E SR × C O
Pole at power amplifier
Phase
[deg]
0
When the output current decreases, the load resistance Ro
increases and the pole frequency lowers.
-90
Fig.31 Open loop gain characteristics
fp (Min.) =
fp (Max.) =
1
2 π× R OMax. × C O
1
2 π× R OMin. × C O
[Hz] ← with lighter load
[Hz] ← with heavier load
fz (Amp.) =
Gain
[dB]
Phase
[deg]
A
0
0
-90
fz(Amp.)
Zero at power amplifier
Increasing capacitance of the output capacitor lowers the pole
frequency while the zero frequency does not change.
(This is
because when the capacitance is doubled, the capacitor ESR
reduces to half.)
1
2 π× R ITH × C ITH
Fig.32 Error amp phase compensation characteristics
www.rohm.com
?2012 ROHM Co., Ltd. All rights reserved.
TSZ22111 ? 15 ? 001
13/19
TSZ02201-0J3J0AJ00180-1-2
02.MAR.2012 Rev.001
相关PDF资料 |
PDF描述 |
|---|---|
| BD9300F-E2 | IC REG CTRLR BST INV PWM 14-SOP |
| BD9302FP-E2 | IC REG BUCK ADJ 2A DL HSOP25 |
| BD9305AFVM-TR | IC REG CTRLR BUCK PWM 8-MSOP |
| BD9328EFJ-E2 | IC REG BUCK SYNC ADJ 2A 8HTSOP |
| BD9329AEFJ-E2 | IC REG BUCK SYNC ADJ 3A 8HTSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BD91411GW | 制造商:ROHM 制造商全称:Rohm 功能描述:Built-in OVP Micro USB Switch with USB2.0, MHLTM and Audio |
| BD91411GW-E2 | 制造商:ROHM 制造商全称:Rohm 功能描述:Built-in OVP Micro USB Switch with USB2.0, MHLTM and Audio |
| BD9141MUV | 制造商:ROHM 制造商全称:Rohm 功能描述:4.5V to 13.2V, 2A 1ch Synchronous Buck Converter integrated FET |
| BD9141MUV_12 | 制造商:ROHM 制造商全称:Rohm 功能描述:4.5V to 13.2V, 2A 1ch Synchronous Buck Converter integrated FET |
| BD9141MUV-E2 | 功能描述:开关变换器、稳压器与控制器 High Eff. Stepdown Sw Reg 2A 4.5-13.2V RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。