参数资料
型号: BR24L01AFVJ-WE2
厂商: Rohm Semiconductor
文件页数: 17/41页
文件大小: 0K
描述: IC EEPROM SER 1KBIT I2C 8TSSOP
标准包装: 2,500
格式 - 存储器: EEPROMs - 串行
存储器类型: EEPROM
存储容量: 1K (128 x 8)
速度: 400kHz
接口: I²C,2 线串口
电源电压: 1.8 V ~ 5.5 V
工作温度: -40°C ~ 85°C
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
供应商设备封装: 8-TSSOP-BJ
包装: 带卷 (TR)
BR24L □□ -W Series,BR24S □□□ -W Series
Technical Note
In I C BUS, it is recommended that SDA port is of open drain input/output. However, when to use CMOS input / output of
● Cautions on microcontroller connection
Rs
2
tri state to SDA port, insert a series resistance Rs between the pull up resistance Rpu and the SDA terminal of EEPROM.
This is controls over current that occurs when PMOS of the microcontroller and NMOS of EEPROM are turned ON
simultaneously. Rs also plays the role of protection of SDA terminal against surge. Therefore, even when SDA port is
open drain input/output, Rs can be used.
ACK
SCL
R PU
R S
SDA
'H' output of microcontroller
'L' output of EEPROM
Microcontroller
EEPROM
Over current flows to SDA line by 'H'
output of microcontroller and 'L'
output of EEPROM.
Fig.53 I/O circuit diagram
Fig.54 Input / output collision timing
○ Maximum value of Rs
The maximum value of Rs is determined by the following relations.
(1)SDA rise time to be determined by the capacity (CBUS) of bus line of Rpu and SDA should be tR or below.
And AC timing should be satisfied even when SDA rise time is late.
(2)The bus electric potential A to be determined by Rpu and Rs the moment when EEPROM outputs 'L' to SDA bus
should sufficiently secure the input 'L' level (V IL ) of microcontroller including recommended noise margin 0.1Vcc.
V CC
R PU
A
(V CC - V OL )×R S
R PU +R S
+
V OL +0.1V CC ≦ V IL
R S
I OL
V OL
R S
V IL - V OL - 0.1V CC
1.1V CC - V IL
×
R PU
Bus line
capacity CBUS
Example) When V CC =3V, VIL=0.3V CC , V OL =0.4V, R PU =20k ?
V IL
Microcontroller
EEPROM
from(2),
R S
0.3×3 - 0.4 - 0.1×3
1.1×3 - 0.3×3
1.67 [ k ? ]
×
20×10 3
Fig.55 I/O circuit diagram
○ Minimum value of Rs
The minimum value of Rs is determined by over current at bus collision. When over current flows, noises in power source
line, and instantaneous power failure of power source may occur. When allowable over current is defined as I, the
following relation must be satisfied. Determine the allowable current in consideration of impedance of power source line
in set and so forth. Set the over current to EEPROM 10mA or below.
R PU
R S
'L' output
V CC
R S
R S
I
V CC
I
Over current Ⅰ
Example)When V CC =3V, I=10mA
10×10
'H' output
Microcontroller
EEPROM
R S
3
-3
300 [ ? ]
Fig.56 I/O circuit diagram
www.rohm.com
? 2009 ROHM Co., Ltd. All rights reserved.
17/40
2009.09 - Rev.D
相关PDF资料
PDF描述
FMC15DRES-S93 CONN EDGECARD 30POS .100 EYELET
XC4VLX60-10FFG668C IC FPGA VIRTEX-4 60K 668-FCBGA
RSC65DRYN-S734 CONN EDGECARD 130PS DIP .100 SLD
XC5VLX50-1FF676I IC FPGA VIRTEX-5 50K 676FBGA
BR93L46-W IC EEPROM 1KBIT 2MHZ 8DIP
相关代理商/技术参数
参数描述
BR24L01AFVM-W 制造商:ROHM 制造商全称:Rohm 功能描述:128】8 bit electrically erasable PROM
BR24L01AFVM-WTR 功能描述:电可擦除可编程只读存储器 IC 电可擦除可编程只读存储器 SRL 128X8BIT RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8
BR24L01AFVT-W 制造商:ROHM Semiconductor 功能描述:Memory,EEPROM,1kb(X8),I2C BUS,TSSOP8
BR24L01AFVT-WE2 功能描述:电可擦除可编程只读存储器 I2C BUS 1Kbit 1.8-5.5V Supply RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8
BR24L01AFV-W 制造商:ROHM Semiconductor 功能描述:EEPROM,1kb,128Wx8b,I2C Bus,SSOP8