- 您现在的位置：买卖IC网 > Datasheet目录316 > BR34L02FV-WE2 (Rohm Semiconductor)IC EEPROM 2KBIT 400KHZ 8SSOP Datasheet资料下载
参数资料
| 型号： | BR34L02FV-WE2 |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 11/18页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 2KBIT 400KHZ 8SSOP |
| 标准包装： | 1 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 2K (256 x 8) |
| 速度： | 400kHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 1.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-LSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-SSOPB |
| 包装： | 标准包装 |
| 产品目录页面： | 1379 (CN2011-ZH PDF) |
| 其它名称： | BR34L02FV-WE2DKR |
BR34L02FV-W
Technical Note
● WP effective timing
WP is normally fixed at "H" or "L". However, in case WP needs to be controlled in order to cancel the Write command, pay
attention to “WP effective timing” as follows:
The Write command is canceled by setting WP to "H" within the WP cancellation effective period.
The period from the START condition to the rising edge of the clock (which takes in the data DO - the first byte of the Page Write
data) is the ‘invalid cancellation period’. WP input is considered inconsequential during this period. The setup time for the rising
edge of the SCL, which takes in DO, must be more than 100ns.
The period from the rising edge of SCL (which takes in the data D0) to the end of internal write cycle (tWR) is the ‘effective
cancellation period’. When WP is set to "H" during tWR, Write operation is stopped, making it necessary to rewrite the data.
It is not necessary to wait for tWR (5ms max.) after stopping the Write command by WP because the device is in standby mode.
? The
rising edge of the clock
which take in D0
SCL
? The rising edge
? of SDA
SCL
SDA
D1
D0
ACK
SDA
D0
ACK
AN ENLARGEMENT
AN
ENLARGEMENT
A
T
C WORD
K
SDA
S
SLAVE
A
R ADDRESS L ADDRESS
T
A
C
K
L
A
C
D7 D6 D5 D4 D3 D2 D1 D0 K
L
DATA
A
C
K
L
S
T
O
P
tWR
WP cancellation
WP cancellation
Stop of the write
WP
invalid period
effective period
operation
Data is not
No
data
will
be
guaranteed
Fig.41 WP effective timing
● Command cancellation from the START and STOP conditions
Command input is canceled by successive inputs of START and STOP conditions. (Refer to Fig.42)
However, during ACK or data output, the device may set the SDA line to Low, making operation of the START and STOP
conditions impossible, and thus preventing reset. In this case execute reset by software. (Refer to Fig.39)
The internal address counter will not be determined when operating the Cancel command by the START and STOP
conditions during Random, Sequential or Current Read. Operate a Random Read in this case.
SCL
SDA
1
0
1
0
START
CONDITION
STOP
CONDITION
Fig.42 Command cancellation by the START and STOP conditions during input of the Slave Address
www.rohm.com
? 2009 ROHM Co., Ltd. All rights reserved.
11/17
2009.04 - Rev.A
相关PDF资料 |
PDF描述 |
|---|---|
| BR93L76RFVJ-WE2 | IC EEPROM 8KBIT 2MHZ 8TSSOP |
| BS08D-112 | TRIGGER BILTRL SW 175MA TO-92 |
| BU04P-TZ-S | TZ CONN 4 POS SINGLE ROW |
| BU9829GUL-WE2 | IC EEPROM 16KBIT SPI 9VCSP |
| BU9832GUL-WE2 | IC EEPROM 8KBIT SPI VCSP50L2 TR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BR34L02-W | 制造商:ROHM 制造商全称:Rohm 功能描述:2Kbit Serial I2C BUS EEPROM For SPD DRAM Memory Module |
| BR34-UPC | 制造商:Thomas & Betts 功能描述:GROUND ROD CLAMP 3/4 BRONZE |
| BR35 | 制造商:PANJIT 制造商全称:Pan Jit International Inc. 功能描述:MINI SURFACE MOUNT SCHOTTKY BARRIER RECTIFIER |
| BR-35 | 制造商:LUGUANG 制造商全称:Shenzhen Luguang Electronic Technology Co., Ltd 功能描述:Single-phase Silicon Bridge Rectifier |
| BR350 | 制造商:Eaton Corporation 功能描述:Type BR Breaker 50A/3 Pole 240V 10K |
发布紧急采购，3分钟左右您将得到回复。