- 您现在的位置：买卖IC网 > PDF目录255989 > BU-63825D0-200 (DATA DEVICE CORP) 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQIP70 PDF资料下载
参数资料
| 型号： | BU-63825D0-200 |
| 厂商： | DATA DEVICE CORP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQIP70 |
| 封装： | CERAMIC, DIP-70 |
| 文件页数： | 30/48页 |
| 文件大小： | 405K |
| 代理商： | BU-63825D0-200 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页当前第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页
36
Data Device Corporation
www.ddc-web.com
BU-63825
C-02/06-0
INTERFACE TO MIL-STD-1553 BUS
FIGURE 18 illustrates the interface from the various versions of
the Sp’ACE II series terminals to a 1553 bus. The figure also indi-
cates connections for both direct (short stub) and transformer
(long stub) coupling, plus the peak-to-peak voltage levels that
appear at various points (when transmitting).
TABLE 33 lists the characteristics of the required isolation trans-
formers for the various Sp’ACE II terminals, the DDC and Beta
Transformer Technology Corporation corresponding part num-
ber, and the MIL (DESC) drawing number (if applicable). Beta
Transformer Technology Corporation is a direct subsidiary of
DDC.
For both coupling configurations, the isolation transformer is the
transformer that interfaces directly to the Sp’ACE II component.
For the transformer (long stub) coupling configuration, the trans-
former that interfaces the stub to the bus is the coupling trans-
former. The turns ratio of the isolation transformer varies,
depending upon the peak-to-peak output voltage of the specific
Sp’ACE II terminal.
The transmitter voltage of each model of the BU-63825 varies
directly as a function of the power supply voltage. The turns
ratios of the respective transformers will yield a secondary volt-
age of approximately 28 volts peak-to-peak on the outer taps
(used for direct coupling) and 20 volts peak-to-peak on the inner
taps (used for stub coupling).
In accordance with MIL-STD-1553B, the turns ratio of the cou-
pling transformer is 1.0 to 1.4. Both coupling configurations
require an isolation resistor to be in series with each leg con-
necting to the 1553 bus; this protects the bus against short cir-
cuit conditions in the transformers, stubs, or terminal compo-
nents.
TABLE 33. ISOLATION TRANSFORMER GUIDE
B-2388
M21038/27
-13,
B-2344,
M21038/27
-18
BUS-29854
1:0.83
SURFACE
MOUNT
B-2387
M21038/27
-12,
M21038/27
-17
LPB-5002
LPB-5009
LPB-6002
LPB-6009
LPB-5001
LPB-5008
LPB-6001
LPB-6008
RECOMMENDED XFORMER
PLUG-IN
BUS-25679,
B-2203,
M21038/27
-02
B-2204,
M21038/27
-03
XFORMER
COUPLED
2:1
1:0.67
1.25:1
(Note 5)
BU-63825X2
1.4:1
BU-63825X1
DIRECT
COUPLED
SP’ACE II
PART
NUMBER
TURNS RATIO
Notes for TABLE 33 and FIGURE 18:
(1) Shown for one of two redundant buses that interface to the BU-
63825
(2) Transmitted voltage level on 1553 bus is 6 Vp-p min, 7 Vp-p nomi-
nal, 9 Vp-p max.
(3) Required tolerance on isolation resistors is 2%. Instantaneous
power dissipation (when transmitting) is approximately 0.5 W (typ),
0.8 W (max).
(4) Transformer pin numbering is correct for the DDC (e.g., BUS-
25679) transformers. For the Beta transformers (e.g., B-2203) or
the QPL-21038-31 transformers (e.g., M21038/27-02), the winding
sense and turns ratio are mechanically the same, but with reversed
pin numbering; therefore, it is necessary to reverse pins 8 and 4 or
pins 7 and 5 for the Beta or QPL transformers (Note: DDC trans-
former part numbers begin with a BUS- prefix, while Beta trans-
former part numbers begin with a B- prefix).
(5) The B-2204, B-2388, and B-2344 transformers have a slightly differ-
ent turns ratio on the direct coupled taps then the turns ratio of the
BUS-29854 direct coupled taps. They do, however, have the same
transformer coupled ratio. For transformer coupled applications,
either transformer may be used. The transceiver in the BU-63825
was designed to work with a 1:0.83 ratio for direct coupled applica-
tions. For direct coupled applications, the 1.20:1 turns ration is rec-
ommended, but the 1.25:1 may be used. The 1.25:1 turns ratio will
result in a slightly lower transmitter amplitude. (Approximately 3.6%
lower) and a slight shift in the Sp’ACE II's receiver threshold.
See TABLE 34
1:2.5
1:1.79
BU-63825
X3/X6
相关PDF资料 |
PDF描述 |
|---|---|
| BU-63825D0-301 | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQIP70 |
| BU-63825D1-191 | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQIP70 |
| BU-63825D1-200 | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQIP70 |
| BU-63825D1-201 | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQIP70 |
| BU-63825D2-190 | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQIP70 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BU-63-9 | 功能描述:测试电夹 White Insul Alligato RoHS:否 制造商:Pomona Electronics 类型:Minigrabber clip 颜色:Black |
| BU-63C-0 | 功能描述:测试电夹 Black Insul Alligato RoHS:否 制造商:Pomona Electronics 类型:Minigrabber clip 颜色:Black |
| BU-63C-2 | 功能描述:测试电夹 Red Insul Alligator RoHS:否 制造商:Pomona Electronics 类型:Minigrabber clip 颜色:Black |
| BU-63C-4 | 功能描述:测试电夹 Yellow Insul Alligat RoHS:否 制造商:Pomona Electronics 类型:Minigrabber clip 颜色:Black |
| BU-63C-5 | 功能描述:测试电夹 Green Insul Alligato RoHS:否 制造商:Pomona Electronics 类型:Minigrabber clip 颜色:Black |
发布紧急采购，3分钟左右您将得到回复。