- 您现在的位置：买卖IC网 > Datasheet目录60 > BU52040HFV-TR (Rohm Semiconductor)IC HALL EFFECT BIPO LATCH HVSOF5 Datasheet资料下载
参数资料
| 型号： | BU52040HFV-TR |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 7/15页 |
| 文件大小： | 465K |
| 描述： | IC HALL EFFECT BIPO LATCH HVSOF5 |
| 特色产品： | ROHM Hall Effect Sensor ICs |
| 标准包装： | 1 |
| 传感范围： | 5mT 跳闸，-5mT 释放 |
| 类型： | 双极卡锁 |
| 电源电压： | 1.65 V ~ 3.3 V |
| 电流 - 电源： | 300µA |
| 电流 - 输出（最大）： | ±0.5mA |
| 输出类型： | 数字，开路集电极 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | SOT-665 |
| 供应商设备封装： | 5-HVSOF |
| 包装： | 标准包装 |
| 其它名称： | BU52040HFV-DKR BU52040HFV-DKR-ND BU52040HFVDKR |
BU52040HFV
Technical Note
7/12
www.rohm.com
2010.01 - Rev.B
?2010 ROHM Co., Ltd. All rights reserved.
?SPAN class="pst BU52040HFV-TR_2601631_6">Intermittent Operation at Power ON
Fig.17
The Hall Effect IC for wheel keys / trackballs adopts an intermittent operation method in detecting the magnetic field during
startup, as shown in Fig. 17. It outputs to the appropriate terminal based on the detection result and maintains the output
condition during the standby period. The time from power ON until the end of the initial startup period is an indefinite interval,
but it cannot exceed the maximum period, 1200約. To accommodate the system design, the Hall IC output read should be
programmed within 1200約 of power ON, but after the time allowed for the period ambient temperature and supply voltage.
Additionally, if a magnetic flux density (B) of magnitude greater than B
rp
but less than B
op
is applied at power ON, the output
from the IC remains undefined and will be either high or low until a flux density exceeding the B
op
or B
rp
threshold is applied.
?SPAN class="pst BU52040HFV-TR_2601631_6">Application Example
Wheel Key
Two Hall ICs can enable detection of rotation direction of a magnetic zero-contact wheel key.
Circular magnet
BU52040HFV: 2pcs
Mounting Position of Hall IC Inside Wheel Key
The angular separation of the two Hall ICs within the footprint of the wheel key depends on N/S division angle of the internal
magnet (?, and can be set to either ?4 or 睛. Mounting the two ICs in this position causes the magnetic phase
difference between the ICs to equal ?/4, and the direction of rotation can be detected by measuring the change in this
difference. An example of the magnetic field characteristics for this application is shown in the figure below.
S
N
S
N
S
N
S
N
N/S division angle of circular magnet = ?
Circular Magnet
S
N
N
S
Clockwise
rotation
N
S
N
S
S
S
S
S
N
N
N
N
?
Center of magnet
2) Mounting angle of Hall IC = 睛
Mounting Angle of Hall IC
Hall IC A
?
Hall IC B
3/4 ?
Hall IC A
?
Hall IC B
Center of magnet
1) Mounting angle of Hall IC = ?4
Counterclockwise
rotation
VDD
Startup time
Standby time
Standby time
Startup time
(Intermittent operation)
Indefinite
OUT
N ma netic field resent
Indefinite interval
OUT
(S magnetic field present)
Low
High
Supply current
Indefinite interval
No ma netic field resent
(B
rp
)
(B
op
<B)
(B
rp
<B< B
op
)
OUT
相关PDF资料 |
PDF描述 |
|---|---|
| D6B-2P | SENSR TILT 35-65DEG 1MA SMD GUL |
| D7E-3 | SENSOR TILT 50-80DEG 0.1A GRY |
| DSBA1H | SENSOR TILT SW 30-60DEG 20MA TH |
| EE-SA103 | SENSOR OPTO SLOT 3MM TRANS THRU |
| EE-SA107-P2 | OPTO SENSOR 3.6MM TRANS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BU52051NVX | 制造商:ROHM 制造商全称:Rohm 功能描述:Omnipolar Detection Hall ICs |
| BU52051NVX-TR | 功能描述:板机接口霍耳效应/磁性传感器 1.65-5.5V CMOS Out Bipolar Detect Latch RoHS:否 制造商:Honeywell 类型:Bipolar Hall-Effect Digital Position Sensor 工作电源电压:3 V to 24 V 电源电流:3.5 mA 最大输出电流:20 mA 工作点最小值/最大值:5 G, 55 G 最小/最大释放点（Brp）:- 55 G, - 5 G 最大工作温度:+ 150 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23 |
| BU52053NVX | 制造商:ROHM 制造商全称:Rohm 功能描述:Omnipolar Detection Hall ICs |
| BU52053NVX-TR | 功能描述:板机接口霍耳效应/磁性传感器 Omnipolar Detection Hall IC RoHS:否 制造商:Honeywell 类型:Bipolar Hall-Effect Digital Position Sensor 工作电源电压:3 V to 24 V 电源电流:3.5 mA 最大输出电流:20 mA 工作点最小值/最大值:5 G, 55 G 最小/最大释放点（Brp）:- 55 G, - 5 G 最大工作温度:+ 150 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23 |
| BU52054GWZ | 制造商:ROHM 制造商全称:Rohm 功能描述:Omnipolar Detection Hall ICs |
发布紧急采购，3分钟左右您将得到回复。