- 您现在的位置：买卖IC网 > PDF目录17095 > CK-S6-SP623-G-J (Xilinx Inc)BOARD DEV S6 WITH TX PDF资料下载
参数资料
| 型号： | CK-S6-SP623-G-J |
| 厂商： | Xilinx Inc |
| 文件页数： | 6/11页 |
| 文件大小： | 0K |
| 描述： | BOARD DEV S6 WITH TX |
| 标准包装： | 1 |
| 系列： | Spartan® 6 LXT |
| 类型： | FPGA |
| 适用于相关产品： | Spartan?-6 FPGA，XC6SLX150T |
| 所含物品： | 板，线缆，文档，软件 - 不包括电源 - |
Spartan-6 Family Overview
DS160 (v2.0) October 25, 2011
Product Specification
4
The bitstream configuration information is generated by the ISE software using a program called BitGen. The configuration
process typically executes the following sequence:
Detects power-up (power-on reset) or PROGRAM_B when Low.
Clears the whole configuration memory.
Samples the mode pins to determine the configuration mode: master or slave, bit-serial or parallel.
Loads the configuration data starting with the bus-width detection pattern followed by a synchronization word, checks
for the proper device code, and ends with a cyclic redundancy check (CRC) of the complete bitstream.
Starts a user-defined sequence of events: releasing the internal reset (or preset) of flip-flops, optionally waiting for the
DCMs and/or PLLs to lock, activating the output drivers, and transitioning the DONE pin to High.
The Master Serial Peripheral Interface (SPI) and the Master Byte-wide Peripheral Interface (BPI) are two common methods
used for configuring the FPGA. The Spartan-6 FPGA configures itself from a directly attached industry-standard SPI serial
flash PROM. The Spartan-6 FPGA can configure itself via BPI when connected to an industry-standard parallel NOR flash.
Note that BPI configuration is not supported in the XC6SLX4, XC6SLX25, and XC6SLX25T nor is BPI available when using
Spartan-6 FPGAs in TQG144 and CPG196 packages.
Spartan-6 FPGAs support MultiBoot configuration, where two or more FPGA configuration bitstreams can be stored in a
single configuration source. The FPGA application controls which configuration to load next and when to load it.
Spartan-6 FPGAs also include a unique, factory-programmed Device DNA identifier that is useful for tracking purposes, anti-
cloning designs, or IP protection. In the largest devices, bitstreams can be copy protected using AES encryption.
Readback
Most configuration data can be read back without affecting the system’s operation.
CLBs, Slices, and LUTs
Each configurable logic block (CLB) in Spartan-6 FPGAs consists of two slices, arranged side-by-side as part of two vertical
columns. There are three types of CLB slices in the Spartan-6 architecture: SLICEM, SLICEL, and SLICEX. Each slice
contains four LUTs, eight flip-flops, and miscellaneous logic. The LUTs are for general-purpose combinatorial and
sequential logic support. Synthesis tools take advantage of these highly efficient logic, arithmetic, and memory features.
Expert designers can also instantiate them.
SLICEM
One quarter (25%) of Spartan-6 FPGA slices are SLICEMs. Each of the four SLICEM LUTs can be configured as either a
6-input LUT with one output, or as dual 5-input LUTs with identical 5-bit addresses and two independent outputs. These
LUTs can also be used as distributed 64-bit RAM with 64 bits or two times 32 bits per LUT, as a single 32-bit shift register
(SRL32), or as two 16-bit shift registers (SRL16s) with addressable length. Each LUT output can be registered in a flip-flop
within the CLB. For arithmetic operations, a high-speed carry chain propagates carry signals upwards in a column of slices.
SLICEL
One quarter (25%) of Spartan-6 FPGA slices are SLICELs, which contain all the features of the SLICEM except the
memory/shift register function.
SLICEX
One half (50%) of Spartan-6 FPGA slices are SLICEXs. The SLICEXs have the same structure as SLICELs except the
arithmetic carry option and the wide multiplexers.
相关PDF资料 |
PDF描述 |
|---|---|
| AP2191FMG-7 | IC PWR SW USB 1CH 1.5A 6-DFN |
| GMM11DSUI | CONN EDGECARD 22POS DIP .156 SLD |
| RCC20DREH | CONN EDGECARD 40POS .100 EYELET |
| DK-V6-BCCN-G | VIRTEX-6 FPGA CONNECTIVITY KIT |
| VE-J6D-EZ | CONVERTER MOD DC/DC 85V 25W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CKS-820 | 制造商:Sunhayato 功能描述: 制造商:Sunhayato 功能描述:PCB DOUBLE SIDED PROTOTYPING F |
| CKS-CCEA50OO | 制造商:Lorlin Electronics Ltd 功能描述: |
| CKSF03 | 制造商:ILME 功能描述:INSERT FEMALE 26-14 AWG 3P+E 制造商:ILME 功能描述:INSERT, FEMALE, 26-14 AWG, 3P+E 制造商:ILME 功能描述:INSERT, FEMALE, 26-14 AWG, 3P+E, Series:CKS, No. of Contacts:3, No. of Rows:2, G |
| CKSF04 | 制造商:ILME 功能描述:INSERT FEMALE 26-14 AWG 4P+E 制造商:ILME 功能描述:INSERT, FEMALE, 26-14 AWG, 4P+E 制造商:ILME 功能描述:INSERT, FEMALE, 26-14 AWG, 4P+E, Series:CKS, No. of Contacts:4, No. of Rows:2, G |
| CKSM03 | 制造商:ILME 功能描述:INSERT MALE 26-14 AWG 3P+E 制造商:ILME 功能描述:INSERT, MALE, 26-14 AWG, 3P+E 制造商:ILME 功能描述:INSERT, MALE, 26-14 AWG, 3P+E, Series:CKS, No. of Contacts:3, No. of Rows:2, Gen |
发布紧急采购，3分钟左右您将得到回复。