参数资料
型号: CME8000-DDTB
厂商: C-Max
文件页数: 4/22页
文件大小: 0K
描述: IC RECEIVER RC BICMOS DIE
标准包装: 1,000
功能: 接收器
C-MAX Time Solutions
Data Sheet
CME8000
IN1, IN2
A ferrite antenna is connected between IN1 and
IN2. For high sensitivity, the Q factor of the
antenna circuit should be as high as possible.
Please note that a high Q factor requires
temperature compensation of the resonant
frequency in most cases. We recommend a Q
factor between 40 and 150, depending on the
application. An optimal signal-to-noise ratio will be
achieved by a resonator resistance of 40 kOhm to
100 kOhm.
ANT1, ANT2
To realize a reception at different frequencies with
one antenna, it is possible to connect additional
capacitors between the inputs. An internal MOS-
switch is closed when a 60kHz protocol is
activated. A second internal switch is closed
choosing the JJY40 protocol (see table page 9).
The capacitors have to be connected between
ANT2 and IN1 for adjusting the 60kHz frequency,
and between ANT1 and IN2 to adjust the
frequency to 40kHz. Note in this case both
switches are closed.
In order to achieve a high selectivity, a crystal is
connected between the Pins QOUT and QIN. It is
used with the serial resonant frequency according
to the time-code transmitter and acts as a serial
resonator. Up to 3 crystals could be connected
from QLOUT, QMOUT and QHOUT to the
common input QIN. The outputs will be
automatically selected by the pin SS1 and SS2
(see table). Only one of the outputs is active. Note
that the output QLOUT is active if JJY40 is
selected. QMOUT is active if a 60kHz protocol is
selected, and QHOUT is only active for DCF or
HBG.
In applications with less than 3 different
frequencies, leave the unused output pins open.
The given parallel capacitor of the filter crystal
(about 1.4 pF) is internally compensated so that
the bandwidth of the filter is about 10 Hz. The
impedance of QIN is high. Parasitic loads have to
be avoided.
VCC
Pad 5
Pin 5
In applications with supply voltages below 2.5V
the impedance of the switches is probably too
high for a good Q-factor.
In applications with less than 3 frequencies leave
Q
110k
110k
the unused pins open
QHOUT PIN6
QMOUT PIN7
Pad6
Pad7
QLOUT
PIN8
Pad8
VCC
Pad 5
Pin 5
GND
ANT1
Pad 4
Pin 4
200k
200k
RF - AMP
Pad 9
Pin 9
Figure 5.
QIN
IN1
VCC
Pad 3
Pin 3
IN2
Pad 2
Pin 2
Pad 5
Pin 5
200k
ANT2
Pad 1
from
AGC
QIN
Pin 1
GND
Pad 9
Pin 9
Figure 4.
Pad 10
Pin 10
GND
Pad 9
Pin 9
1k
Figure 6.
QHOUT, QMOUT, QLOUT
DEM
SPEC No.
CME8000
Revision
B.15
State
09.03.07
C-MAX printed
03.05.2007
Version
English
Page
4 of 22
相关PDF资料
PDF描述
CMF20120D SIC MOSFET N-CH 1200V TO-247-3
CMFB3950103FNT THERMISTOR NTC 10K OHM 1% 0805
CMI01S LED T1-3/4 CBI RED RED DIFF
CMMC-8I-DB BOARD DEMO FOR CME8000
CMMR-8P-MF MODULE RCVR CME8000 WO/CPU
相关代理商/技术参数
参数描述
CME8000-EK 功能描述:KIT EVAL TSG200/CME8000 MOD&SMPL RoHS:是 类别:RF/IF 和 RFID >> RF 评估和开发套件,板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
CME8000-TLPH 功能描述:IC RECEIVER RC BICMOS 28-SSOP RoHS:是 类别:RF/IF 和 RFID >> RF 接收器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS 产品变化通告:Product Discontinuation 09/Jan/2012 标准包装:50 系列:* 频率:850MHz ~ 2.175GHz 灵敏度:- 数据传输率 - 最大:- 调制或协议:- 应用:* 电流 - 接收:* 数据接口:PCB,表面贴装 存储容量:- 天线连接器:PCB,表面贴装 特点:- 电源电压:4.75 V ~ 5.25 V 工作温度:0°C ~ 85°C 封装/外壳:40-WFQFN 裸露焊盘 供应商设备封装:40-TQFN-EP(6x6) 包装:托盘
CME8000-TLSH 功能描述:IC RECEIVER RC BICMOS 28-SSOP RoHS:是 类别:RF/IF 和 RFID >> RF 接收器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS 产品变化通告:Product Discontinuation 09/Jan/2012 标准包装:50 系列:* 频率:850MHz ~ 2.175GHz 灵敏度:- 数据传输率 - 最大:- 调制或协议:- 应用:* 电流 - 接收:* 数据接口:PCB,表面贴装 存储容量:- 天线连接器:PCB,表面贴装 特点:- 电源电压:4.75 V ~ 5.25 V 工作温度:0°C ~ 85°C 封装/外壳:40-WFQFN 裸露焊盘 供应商设备封装:40-TQFN-EP(6x6) 包装:托盘
CME-8GB60 制造商:AXIOM 功能描述:Microprocessor Development Too 制造商:AXIOM 功能描述:MC9S08GB60, CAN, RS232, SPI, LCD, DEV BOARD, Silicon Manufacturer:Freescale, Cor
CMEB 制造商:CamdenBoss Ltd, 功能描述:Bulk 制造商:CAMDENBOSS 功能描述:ENCLOSURE DIN RAIL EXTENDABLE 制造商:CAMDENBOSS 功能描述:ENCLOSURE, DIN RAIL, EXTENDABLE 制造商:CAMDENBOSS 功能描述:ENCLOSURE, DIN RAIL, EXTENDABLE; Enclosure Type:DIN Rail; Enclosure Material:-; Body Colour:Grey; External Height - Imperial:3.41"; External Height - Metric:86.7mm; External Width - Imperial:0.69"; External Width - Metric:17.5mm; IP ;RoHS Compliant: Yes