参数资料
| 型号： | CS4364-CQZ |
| 厂商： | Cirrus Logic Inc |
| 文件页数： | 21/50页 |
| 文件大小： | 0K |
| 描述： | IC DAC 103DB 24BIT 6CH 48-LQFP |
| 标准包装： | 250 |
| 位数： | 24 |
| 数据接口： | 串行 |
| 转换器数目： | 8 |
| 电压电源： | 模拟和数字 |
| 功率耗散（最大）： | 520mW |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-LQFP |
| 供应商设备封装： | 48-LQFP（7x7） |
| 包装： | 托盘 |
| 输出数目和类型： | 8 电压，单极 |
| 采样率（每秒）： | 216k |
| 产品目录页面： | 757 (CN2011-ZH PDF) |
| 配用： | CDB4364-ND - EVALUATION BOARD FOR CS4364 |
| 其它名称： | 598-1059 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
28
DS619F1
CS4364
Figure 21. Recommended Mute Circuitry
4.12
Recommended Power-Up Sequence
4.12.1
Hardware Mode
1.
Hold RST low until the power supplies and configuration pins are stable, and the master and left/right
clocks are locked to the appropriate frequencies, as discussed in Section 4.1. In this state, the
registers are reset to the default settings, FILT+ will remain low, and VQ will be connected to VA/2.
If RST can not be held low long enough the SDINx pins should remain static low until all other clocks
are stable, and if possible the RST should be toggled low again once the system is stable.
2.
Bring RST high. The device will remain in a low power state with FILT+ low and will initiate the
Hardware power-up sequence after approximately 512 LRCK cycles in Single-Speed Mode (1024
LRCK cycles in Double-Speed Mode, and 2048 LRCK cycles in Quad-Speed Mode).
4.12.2
Software Mode
1.
Hold RST low until the power supply is stable, and the master and left/right clocks are locked to the
appropriate frequencies, as discussed in Section 4.1. In this state, the registers are reset to the default
settings, FILT+ will remain low, and VQ will be connected to VA/2.
2.
Bring RST high. The device will remain in a low power state with FILT+ low for 512 LRCK cycles in
Single-Speed Mode (1024 LRCK cycles in Double-Speed Mode, and 2048 LRCK cycles in Quad-
Speed Mode).
3.
In order to reduce the chances of clicks and pops, perform a write to the CP_EN bit prior to the
completion of approximately 512 LRCK cycles in Single-Speed Mode (1024 LRCK cycles in Double-
Speed Mode, and 2048 LRCK cycles in Quad-Speed Mode). The desired register settings can be
loaded while keeping the PDN bit set to 1. Set the RMP_UP and RMP_DN bits to 1, then set the
format and mode control bits to the desired settings.
If more than the stated number of LRCK cycles passes before CPEN bit is written then the chip will
enter Hardware Mode and begin to operate with the M0-M4 as the mode settings. CPEN bit may be
written at anytime, even after the Hardware sequence has begun. It is advised that if the CPEN bit
can not be set in time then the SDINx pins should remain static low (this way no audio data can be
相关PDF资料 |
PDF描述 |
|---|---|
| VI-J5W-MZ-F3 | CONVERTER MOD DC/DC 5.5V 25W |
| AD5331BRUZ | IC DAC 10BIT SNGL VOUT 20TSSOP |
| MS3120F22-21S | CONN RCPT 21POS WALL MNT W/SCKT |
| M83723/95G14076 | CONN PLUG 7POS STRAIGHT W/SCKT |
| MS3116F22-41SW | CONN PLUG 41POS STRAIGHT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CS4364-CQZR | 功能描述:数模转换器- DAC IC 24b 6Ch DAC w/DSD Supt/Lw-Ltnc DF RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| CS4364-DQZ | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:103 dB, 192 kHz 6-Channel D/A Converter |
| CS4364-DQZR | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:103 dB, 192 kHz 6-Channel D/A Converter |
| CS4365 | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:114 dB, 192 kHz 6-Channel D/A Converter |
| CS4365_07 | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:114 dB, 192 kHz 6-Channel D/A Converter |
发布紧急采购，3分钟左右您将得到回复。