- 您现在的位置：买卖IC网 > PDF目录20625 > CS5461A-ISZR (Cirrus Logic Inc)IC ENERGY METERING 1PHASE 24SSOP PDF资料下载
参数资料
| 型号： | CS5461A-ISZR |
| 厂商： | Cirrus Logic Inc |
| 文件页数： | 16/44页 |
| 文件大小： | 0K |
| 描述： | IC ENERGY METERING 1PHASE 24SSOP |
| 标准包装： | 1,000 |
| 输入阻抗： | 30 千欧 |
| 测量误差： | 0.1% |
| 电压 - 高输入/输出： | 0.8V |
| 电压 - 低输入/输出： | 0.2V |
| 电流 - 电源： | 2.9mA |
| 电源电压： | 4.75 V ~ 5.25 V |
| 测量仪表类型： | 单相 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 24-SSOP |
| 包装： | 带卷 (TR) |
| 配用： | 598-1552-ND - BOARD EVAL & SOFTWARE CS5461A |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页
CS5461A
INT pin will become active if the DRDY bit is unmasked
in the Mask Register . When these bits are set, they
FREQ E = ------------------------------------------------------------------------------------------------------------------------------------------------
must be cleared (logic 0) by the user before they can be
asserted again.
If the Cycle Count Register (N) is set to 1, all output cal-
culations are instantaneous, and DRDY, like CRDY, will
indicate when instantaneous measurements are fin-
ished. Some calculations are inhibited when the cycle
count is less than 2.
5.4 Energy Pulse Output
The CS5461A provides three output pins for energy reg-
istration. The E1 and E2 pins provide a simple interface
which energy can be registered. These pins are de-
signed to directly connect to a stepper motor or electro-
mechanical counter. E1 and E2 pins can be set to one
of four pulse output formats, Normal, Alternate, Stepper
Motor, or Mechanical Counter. Table 2 defines the
pulse output format, which is controlled by bits ALT in
the Configuration Register , and MECH and STEP in the
Control Register.
VIN ? VGAIN ? IIN ? IGAIN ? PF ? PulseRateE 1 , 2
2
VREFIN
FREQ E = Average frequency of E1 and E2 pulses [Hz]
VIN = rms voltage across VIN+ and VIN- [V]
VGAIN = Voltage channel gain
IIN = rms voltage across IIN+ and IIN- [V]
IGAIN = Current channel gain
PF = Power Factor
PulseRateE1,2 = Maximum frequency on E1 and E2 [Hz]
VREFIN = Voltage at VREFIN pin [V]
With MCLK = 4.096 MHz, PF = 1, and default settings,
the pulses will have an average frequency equal to the
frequency setting in the PulseRateE 1,2 Register when
the input signals applied to the voltage and current
channels cause full-scale readings in the instantaneous
voltage and current registers. When MCLK/K is not
equal to 4.096 MHz, the user should scale the
ALT
0
0
0
1
STEP
0
X
1
X
MECH
0
1
0
1
FORMAT
Normal
Mechanical Counter
Stepper Motor
Alternate Pulse
PulseRateE 1,2 Register by a factor of
4.096 MHz/(MCLK/K) to get the actual pulse rate out-
put.
5.4.1 Normal Format
The Normal format is th e default. Figure 3 illustrates the
output format on pins E1 and E2. The E1 pin outputs ac-
Table 2. E1 and E2 Pulse Output Format
The E3 pin is designated for system calibration, the
pulse rate can be selected to reach a frequency of
512 kHz.
The pulse output frequency of E1 and E2 is directly pro-
portional to the active power calculated from the input
signals. To calculate the output frequency on E1 and
E2, the following transfer function can be utilized:
tive-low pulses with a frequency proportional to the ac-
tive power. The E2 pin is the energy direction indicator.
Positive energy is represented by a pulse on the E1 pin
while the E2 pin remains high. Negative energy is rep-
resented by synchronous pulses on both the E1 pin and
the E2 pin.
The PulseRateE 1,2 Register defines the average fre-
quency on output pin E1, when full-scale input signals
are applied to the voltage and current channels. The
maximum pulse frequency from the E1
pin
P o s itiv e E n e rg y B u rs t
t d ur
N e g a tiv e E n e rg y B u rs t
16
E1
E2
. . .
. . .
Figure 3. Normal Format on pulse outputs E1 and E2
. . .
. . .
DS661F3
相关PDF资料 |
PDF描述 |
|---|---|
| 591D337X0010R2T20H | CAP TANT 330UF 10V 20% 2824 |
| MCP1416T-E/OT | IC MOSFET DVR 1.5A HS TSOT23-5 |
| LT3694EUFD-1#TRPBF | IC REG TRPL BUCK/LINEAR 28QFN |
| LT3694EUFD#TRPBF | IC REG TRPL BUCK/LINEAR 28QFN |
| LT1939EDD#PBF | IC REG DL BUCK/LINEAR 12DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CS5461-IS | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:Single Phase Bi-Directional Power/Energy IC |
| CS5461-ISZ | 制造商:Cirrus Logic 功能描述:PWR MEASUREMENT 24SSOP - Rail/Tube |
| CS5461-ISZR | 制造商:Cirrus Logic 功能描述:PWR MEASUREMENT 24SSOP - Tape and Reel |
| CS5462 | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:LOW COST POWER ENERGY IC WITH PULSE OUTPUT |
| CS5462-IS | 功能描述:电流和电力监控器、调节器 Low-Cost Pwr/Energy w/Pulse Output IC RoHS:否 制造商:STMicroelectronics 产品:Current Regulators 电源电压-最大:48 V 电源电压-最小:5.5 V 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:HPSO-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。