参数资料
型号: CS8406-DZZ
厂商: Cirrus Logic Inc
文件页数: 19/28页
文件大小: 0K
描述: IC XMITTER DGTL 192KHZ 28TSSOP
标准包装: 50
类型: 数字音频接口发射器
应用: 车载音频
安装类型: 表面贴装
封装/外壳: 28-TSSOP(0.173",4.40mm 宽)
供应商设备封装: 28-TSSOP
包装: 管件
产品目录页面: 759 (CN2011-ZH PDF)
配用: 598-1017-ND - BOARD EVAL FOR CS8416 RCVR
其它名称: 598-1722
26
DS580F6
CS8406
SDA/CDOUT
1
Serial Control Data I/O (IC Mode) / Data Out (SPI) (Input/Output) - In IC Mode, SDA is the control I/O
data line. SDA is open drain and requires an external pull-up resistor to VL. In SPI Mode, CDOUT is the
output data from the control port interface on the CS8406
SCL/CCLK
28 Control Port Clock (
Input
) - Serial control interface clock and is used to clock control data bits into and
out of the CS8406. In IC Mode, SCL requires an external pull-up resistor to VL.
AD0/CS
2
Address Bit 0 (IC Mode) / Control Port Chip Select (SPI) (Input) - A falling edge on this pin puts the
CS8406 into SPI Control Port Mode. With no falling edge, the CS8406 defaults to IC Mode. In IC
Mode, AD0 is a chip address pin. In SPI Mode, CS is used to enable the control port interface on the
CS8406
AD1/CDIN
27 Address Bit 1 (IC Mode) / Serial Control Data in (SPI) (
Input
) - In IC Mode, AD1 is a chip address
pin. In SPI Mode, CDIN is the input data line for the control port interface.
AD2
3
Address Bit 2 (IC Mode) (Input) - Determines the AD2 address bit for the control port in IC Mode, and
should be connected to GND or VL. If SPI Mode is used, the AD2 pin should be connected to either
GND or VL.
RXP
4
Auxiliary AES3 Receiver Port (Input) - Input for an alternate, already AES3 coded, audio data source.
INT
19
Interrupt (Output) - Indicates key events during the operation of the CS8406. All bits affecting INT may
be unmasked through bits in the control registers. Indication of the condition(s) that initiated an interrupt
are readable in the control registers. The polarity of the INT output, as well as selection of a standard or
open drain output, is set through a control register. Once set true, the INT pin goes false only after the
interrupt status registers have been read and the interrupt status bits have returned to zero.
TCBL
15
Transmit Channel Status Block Start (Input/Output) - When operated as output, TCBL is high during
the first sub-frame of a transmitted channel status block, and low at all other times. When operated as
input, driving TCBL high for at least three OMCK clocks will cause the next transmitted sub-frame to be
the start of a channel status block.
U
20
User Data (Input) - May optionally be used to input User data for transmission by the AES3 transmitter,
see Figure 4 for timing information. If not driven, a 47 k pull-down resistor is recommended for the U
pin. If the U pin is driven by a logic level output, a 100 series resistor is recommended.
TSTN
5
Test In (Input) - This pin is an input used for test purposes. It must be tied to ground for normal operation.
TEST
7
8
10
11
16
17
18
Test Pins - These pins are unused inputs. It is recommended that these pins be tied to a supply (VL or
GND) to minimize leakage current. The CS8406 will operate correctly if these pins are left floating, how-
ever current consumption from VL will increase by 25 A per TEST pin that is left floating.
相关PDF资料
PDF描述
CS8415A-CZZ IC 96KHZ DGTL RCVR 28-TSSOP
CS8416-DZZ IC RCVR DGTL 192KHZ 28TSSOP AUTO
CS8420-DSZ IC CONV S/R DGTL AUDIO 28-SOIC
CS8421-CNZ IC SAMPLE RATE CONVERTER 20QFN
CS8427-DZZ IC TXRX DGTL AUDIO 96KHZ 28TSSOP
相关代理商/技术参数
参数描述
CS8406-DZZR 功能描述:音频发送器、接收器、收发器 IC 192 kHz Digital Audio Transmitter RoHS:否 制造商:Cirrus Logic 工作电源电压:3.3 V, 5 V 电源电流:11.8 mA 通道数量:1 最大工作温度:+ 70 C 接口类型:I2C, SPI 安装风格:SMD/SMT 封装 / 箱体:TSSOP-28 封装:
CS8406-IS 制造商:Rochester Electronics LLC 功能描述:- Bulk
CS8406-IZ 制造商:Rochester Electronics LLC 功能描述:- Bulk
CS841 制造商:HVPSI 制造商全称:High Voltage Power Solutions, Inc. 功能描述:MOV Modules
CS8411 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:DIGITAL AUDIO INTER FACE RECEIVER