- 您现在的位置：买卖IC网 > PDF目录17028 > DC1813A-A (Linear Technology)BOARD SAR ADC LTC2370-16 PDF资料下载
参数资料
| 型号： | DC1813A-A |
| 厂商： | Linear Technology |
| 文件页数： | 5/24页 |
| 文件大小： | 0K |
| 描述： | BOARD SAR ADC LTC2370-16 |
| 软件下载： | QuikEval II System |
| 设计资源： | DC1813A Design File DC1813A Schematic |
| 标准包装： | 1 |
| 系列： | QuikEval-II™ |
| ADC 的数量： | 1 |
| 位数： | 16 |
| 采样率（每秒）： | 2M |
| 数据接口： | 串行，SPI? |
| 输入范围： | 0 ~ VREF |
| 在以下条件下的电源（标准）： | 19mW @ 2MSPS |
| 工作温度： | 0°C ~ 70°C |
| 已用 IC / 零件： | LTC2370-16 |
| 已供物品： | 板 |
| 相关产品： | LT6202HS5#TRPBF-ND - IC OP AMP RRIO 100MHZ TSOT23-5 LT6202HS5#TRMPBF-ND - IC OP AMP RRIO 100MHZ TSOT23-5 LTC2370IMS-16#PBF-ND - IC ADC 16BIT SRL/SPI 2M 16-MSOP LTC2370CMS-16#PBF-ND - IC ADC 16BIT SRL/SPI 2M 16-MSOP LTC2370IMS-16#TRPBF-ND - IC ADC 16BIT SRL/SPI 2M 16-MSOP LTC2370IDE-16#TRPBF-ND - IC ADC 16BIT SRL/SPI 2M 16-DFN LTC2370IDE-16#PBF-ND - IC ADC 16BIT SRL/SPI 2M 16-DFN LTC2370HMS-16#TRPBF-ND - IC ADC 16BIT SRL/SPI 2M 16-MSOP LTC2370HMS-16#PBF-ND - IC ADC 16BIT SRL/SPI 2M 16-MSOP LTC2370CMS-16#TRPBF-ND - IC ADC 16BIT SRL/SPI 2M 16-MSOP 更多... |
LTC2370-16
13
237016fa
APPLICATIONS INFORMATION
code. In applications where the transient response of the
reference is important, the fast settling LTC6655-5 refer-
ence is also recommended.
In applications where power management is critical and
the external reference may be powered down, it is rec-
ommended that REF is kept greater than 2V in order to
guaranteeamaximumshutdowncurrentof140A.Insuch
applications, a Schottky diode can be placed between REF
and VDD, as shown in Figure 7.
the RMS amplitude of all other frequency components
except the first five harmonics and DC. Figure 8 shows
that the LTC2370-16 achieves a typical SNR of 94dB at a
2MHz sampling rate with a 2kHz input.
Total Harmonic Distortion (THD)
TotalHarmonicDistortion(THD)istheratiooftheRMSsum
ofallharmonicsoftheinputsignaltothefundamentalitself.
The out-of-band harmonics alias into the frequency band
between DC and half the sampling frequency (fSMPL/2).
THD is expressed as:
THD
=20log
V22
+ V32 + V42 +…+ VN
2
V1
where V1 is the RMS amplitude of the fundamental fre-
quencyandV2throughVNaretheamplitudesofthesecond
through Nth harmonics.
POWER CONSIDERATIONS
The LTC2370-16 provides two power supply pins: the
2.5V power supply (VDD), and the digital input/output
interface power supply (OVDD). The flexible OVDD supply
allows the LTC2370-16 to communicate with any digital
logic operating between 1.8V and 5V, including 2.5V and
3.3V systems.
Figure 8. 32k Point FFT with fIN = 2kHz of the LTC2370-16
FREQUENCY (kHz)
0 100 200 300 400
800 900 1000
700
600
500
–180
AMPLITUDE
(dBFS)
–60
–40
–20
–80
–100
–120
–140
–160
0
237016 F08
SNR = 94dB
THD = –112dB
SINAD = 93.9dB
SFDR = 117dB
REF
237016 F07
LTC2370-16
VDD
Figure 7. A Schottky Diode Between REF and VDD Maintains
REF > 2V for Applications Where the Reference May Be
Powered Down
DYNAMIC PERFORMANCE
Fast Fourier Transform (FFT) techniques are used to test
the ADC’s frequency response, distortion and noise at the
rated throughput. By applying a low distortion sine wave
and analyzing the digital output using an FFT algorithm,
the ADC’s spectral content can be examined for frequen-
cies outside the fundamental. The LTC2370-16 provides
guaranteed tested limits for both AC distortion and noise
measurements.
Signal-to-Noise and Distortion Ratio (SINAD)
The signal-to-noise and distortion ratio (SINAD) is the
ratio between the RMS amplitude of the fundamental input
frequency and the RMS amplitude of all other frequency
components at the A/D output. The output is band-limited
to frequencies from above DC and below half the sampling
frequency. Figure 8 shows that the LTC2370-16 achieves
a typical SINAD of 93.9dB at a 2MHz sampling rate with
a 2kHz input.
Signal-to-Noise Ratio (SNR)
The signal-to-noise ratio (SNR) is the ratio between the
RMS amplitude of the fundamental input frequency and
相关PDF资料 |
PDF描述 |
|---|---|
| EEM25DRYF | CONN EDGECARD 50POS DIP .156 SLD |
| VE-B5V-EY | CONVERTER MOD DC/DC 5.8V 50W |
| ESM10DREN | CONN EDGECARD 20POS .156 EYELET |
| EMM10DREN | CONN EDGECARD 20POS .156 EYELET |
| 0210491097 | CABLE JUMPER 1.25MM .030M 39POS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DC1813A-B | 功能描述:BOARD SAR ADC LTC2368-16 RoHS:是 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:QuikEval-II™ 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
| DC1813A-C | 功能描述:BOARD SAR ADC LTC2367-16 RoHS:是 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:QuikEval-II™ 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
| DC1813A-D | 功能描述:BOARD SAR ADC LTC2364-16 RoHS:是 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:QuikEval-II™ 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
| DC1813A-E | 功能描述:BOARD SAR ADC LTC2369-18 RoHS:是 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:QuikEval-II™ 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
| DC1813A-F | 功能描述:BOARD SAR ADC LTC2368-18 RoHS:是 类别:编程器，开发系统 >> 评估板 - 模数转换器 (ADC) 系列:QuikEval-II™ 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- ADC 的数量:1 位数:12 采样率（每秒）:94.4k 数据接口:USB 输入范围:±VREF/2 在以下条件下的电源（标准）:- 工作温度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，软件 |
发布紧急采购，3分钟左右您将得到回复。