- 您现在的位置：买卖IC网 > PDF目录18713 > DR-TRC105-315-EV (RFM)BOARD EVALUATION 315MHZ RFM RFIC PDF资料下载
参数资料
| 型号： | DR-TRC105-315-EV |
| 厂商： | RFM |
| 文件页数： | 46/67页 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION 315MHZ RFM RFIC |
| 标准包装： | 1 |
| 类型： | 收发器 |
| 频率： | 310MHz ~ 319.5MHz |
| 适用于相关产品： | TRC105 |
| 已供物品： | 2 个板，天线，电池 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页当前第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页
6.1.2 Voltage Controlled Oscillator Component Values
The TRC105 VCO requires four external components for operation, two tank circuit inductors and two power sup-
ply decoupling capacitors. It is important to use high-Q chip inductors in the tank circuit. This assures low phase
noise VCO operation and minimum interference from signals near the TRC105 ’s operating frequency due
to phase noise reciprocal mixing. The two tank circuit inductors have the same value which depends on the VCO
operating band and the PCB layout. Typical values are given in Table 58 (location of L5 & L6 shown in Figure 2):
Band
300-330 MHz
330-365 MHz
365-400 MHz
400-440 MHz
440-470 MHz
470-510 MHz
L5 & L6
39 nH
27 nH
27 nH
22 nH
15 nH
TBD
Tolerance
±5%
±5%
±5%
±5%
±5%
±5%
Table 58
The tank circuit inductors should be mounted close to their IC pads with the long axis of the coil at right angles to
the edge of the IC where the pads are located. The decoupling capacitors should be positioned on each side of
the tank circuit inductors. Other RF chokes and coils should be spaced somewhat away from the tank inductors
and positioned at right angles to minimize coupling.
VCO frequency centering is checked by looking at the voltage between pads 6 and 7. The voltage should be 150
±50 mV when the TRC105 is in transmit mode at a frequency near the center of the operating band and subband.
VCO frequency centering can be adjusted by changing the value of the tuning inductors and/or adjusting the VCO
trim bits 1 and 2 in configuration register MCFG05 . The trim bits adjust the tuning voltage in increments of about
60 mV. Increasing the value of the tuning inductors increases the tuning voltage between pads 6 and 7.
6.2 Determining Configuration Values for FSK Modulation
6.2.1 Bit Rate Related FSK Configuration Values
The TRC105 supports RF bit rates (data rates) from 1.5625 to 200 kb/s for FSK modulation. There are several
considerations in choosing a bit rate. The sensitivity of the TRC105 decreases with increasing data rate. A bit rate
should be chosen that is adequate but not higher than the application requires. The exception to this rule is when
the TRC105 is operated as a frequency hopping spread spectrum transceiver in a noisy or crowded band. Run-
ning at a higher bit rate will allow a higher channel hopping rate, which provides more robust operation in a
crowded band in tradeoff for less range under quiet band conditions.
The TRC105 RF bit rate is set by the value of the bytes loaded in MCFG03 and MCFG04 . For the standard crys-
tal frequency of 12.8 MHz:
BR = 12800/(2*(C+1)*(D + 1)), with C in the range of 0 to 255, and D = 31 (default value)
Where BR is the bit rate in kb/s, F XTAL the crystal frequency in kHz, C the value in MCFG03, and D is the value in
MCFG04 . This bit rate value supports both the data and clock recovery circuit in the receiver and the bit rate
clocking in the transmitter modulator. Using the default value of D and solving the equation above for C:
C = (12800 - 64*BR)/64*BR
www.RFM.com E-mail: info@rfm.com
? 2009-2013 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 46 of 67
TRC105 - 05/29/13
相关PDF资料 |
PDF描述 |
|---|---|
| DR-TRC105-304-EV | BOARD EVALUATION 304MHZ RFM RFIC |
| GSCA06S2 | SWITCH ROTARY SIDE |
| DR-TRC103-950-EV | BOARD EVALUATION 950MHZ RFM RFIC |
| DR-TRC103-915-EV | BOARD EVALUATION 915MHZ RFM RFIC |
| DR-TRC103-868-EV | BOARD EVALUATION 868MHZ RFM RFIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DR-TRC105-345-DK | 功能描述:射频开发工具 TRC105 Development Kit 342-348 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-345-EV | 功能描述:射频开发工具 TRC105 Evaluation Board 342-348 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-372-DK | 功能描述:射频开发工具 TRC105 Development Kit 365-381 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-372-EV | 功能描述:射频开发工具 TRC105 Evaluation Board 365-381 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-390-DK | 功能描述:射频开发工具 TRC105 Development Kit 382-398 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
发布紧急采购，3分钟左右您将得到回复。