参数资料
型号: DR-TRC105-315-EV
厂商: RFM
文件页数: 7/67页
文件大小: 0K
描述: BOARD EVALUATION 315MHZ RFM RFIC
标准包装: 1
类型: 收发器
频率: 310MHz ~ 319.5MHz
适用于相关产品: TRC105
已供物品: 2 个板,天线,电池
2.1 RF Port
The receiver and the transmitter share the same RF pins. Figure 3 shows the implementation of the common
front-end. In transmit mode, the PA and the PA regulator are on; the voltage on VDD_PA pin is the nominal volt-
age of the regulator, about 1.8 V. The external inductances L1 and L4 are used for the PA. In receive mode, both
PA and PA regulator are off, and VDD_PA is tied to ground. The external inductances L1 and L4 are used for bi-
asing and matching the LNA, which is implemented as a common gate amplifier.
Figure 3
2.2 Transmitter
The TRC105 is set to transmit mode when MCFG00_Chip_Mode[7..5] bits are set to 100. In Continuous data
mode the transmitted data is sent directly to the modulator. The host microcontroller is provided with a bit rate
clock by the TRC105 to clock the data; using this clock to send the data synchronously is mandatory in FSK con-
figuration and optional in OOK configuration. In Buffered and Packet data modes the data is first written into the
64-byte FIFO via the SPI interface; data from the FIFO is then used by the modulator.
At the front end of the transmitter, I and Q signals are generated by the base-band circuit which contains a digital
waveform generator, two D/A converters and two anti-aliasing low-pass filters. The I and Q signals are two quad-
rature sinusoids whose frequency is the selected frequency deviation. In FSK mode, the phase shift between I
and Q is switched between +90° and -90° according to the input data. The modulation is then performed at this
stage, since the information contained in the phase shift will be converted into a frequency shift when the I and Q
signals are combined in the first mixers. In OOK mode, the phase shift is kept constant whatever the data. The
combination of the I and Q signals in the first mixers creates a fixed frequency signal at a low intermediate fre-
quency which is equal to the selected frequency deviation. After D/A conversion, both I and Q signals are filtered
by anti-aliasing filters whose bandwidth is programmed with the register TXCFG1A_TXInterpfilt[7..4] . Behind the
filters, a set of four mixers combines the I and Q signals and converts them into two I and Q signals at the second
intermediate frequency which is equal to 1/8 of the LO frequency, which in turn is equal to 8/9 of the RF frequen-
cy. These two new I and Q signals are then combined and up-converted to the desired RF frequency by two
quadrature mixers fed by the LO signals. The signal is then amplified by a driver and power amplifier stage.
MCFG05_PA_Ramp[7..6]
00
01
10
11
T PA (μs)
3
8.5
15
23
Rise/fall (μs)
2.5/2
5/3
10/6
20/10
Table 2
www.RFM.com E-mail: info@rfm.com
? 2009-2013 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 7 of 67
TRC105 - 05/29/13
相关PDF资料
PDF描述
DR-TRC105-304-EV BOARD EVALUATION 304MHZ RFM RFIC
GSCA06S2 SWITCH ROTARY SIDE
DR-TRC103-950-EV BOARD EVALUATION 950MHZ RFM RFIC
DR-TRC103-915-EV BOARD EVALUATION 915MHZ RFM RFIC
DR-TRC103-868-EV BOARD EVALUATION 868MHZ RFM RFIC
相关代理商/技术参数
参数描述
DR-TRC105-345-DK 功能描述:射频开发工具 TRC105 Development Kit 342-348 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-345-EV 功能描述:射频开发工具 TRC105 Evaluation Board 342-348 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-372-DK 功能描述:射频开发工具 TRC105 Development Kit 365-381 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-372-EV 功能描述:射频开发工具 TRC105 Evaluation Board 365-381 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-390-DK 功能描述:射频开发工具 TRC105 Development Kit 382-398 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V