- 您现在的位置：买卖IC网 > PDF目录18713 > DR-TRC105-372-EV (RFM)BOARD EVALUATION 372MHZ RFM RFIC PDF资料下载
参数资料
| 型号： | DR-TRC105-372-EV |
| 厂商： | RFM |
| 文件页数： | 27/67页 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION 372MHZ RFM RFIC |
| 标准包装： | 1 |
| 类型： | 收发器 |
| 频率： | 365MHz ~ 380MHz |
| 适用于相关产品： | TRC105 |
| 已供物品： | 2 个板，天线，电池 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页当前第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页
Figure 20 shows the timing diagram for a single byte write sequence to the TRC105 through the SPI configuration
interface. Note that nSS_CONFIG must remain low during the transmission of the two bytes (address and data). If
it goes high after the first byte, then the next byte will be considered as an address byte. When writing to more
than one register successively, nSS_CONFIG does not need to have a high-to-low transition between two write
sequences. The bytes are alternatively considered as an address byte followed by a data byte.
The read sequence through the SPI configuration interface is similar to the write sequence. The host microcon-
troller sends the address during the first SPI communication and then reads the data during a second SPI com-
munication. Note that 0 bits can be input to the SDI during the second SPI communication for a single byte read.
Figure 21 shows the timing diagram for a single byte read sequence from the TRC105 through the SPI.
Figure 21
Figure 22
Multiple configuration register reads are also possible by sending a series of register addresses into the SPI port,
as shown in Figure 22.
3.11 SPI Data FIFO Interface
When the transceiver is used in Buffered or Packet data mode, data is written to and read from the FIFO through
the SPI interface. Two interrupts, IRQ0 and IRQ1, are used to manage the transfer procedure.
When the transceiver is operating in Buffered or Packet data mode, the FIFO interface is selected when
nSS_DATA is set to 0 and nSS_CONFIG is set to 1. SPI operations with the FIFO are similar to operations with
the configuration registers with two important exceptions. First, no addresses are used with the FIFO, only data
bytes are exchanged. Second, nSS_DATA must be toggled high and back low between data bytes when writing
to the FIFO or reading from the FIFO. Toggling nSS_DATA indexes the access pointer to each byte in the FIFO in
lieu of using explicit addressing. Figure 23 shows the timing diagram for a multiple-byte write sequence to the
TRC105 during transmit, and Figure 24 shows the timing for a multi-byte read sequence.
www.RFM.com E-mail: info@rfm.com
? 2009-2013 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 27 of 67
TRC105 - 05/29/13
相关PDF资料 |
PDF描述 |
|---|---|
| DR-TRC105-345-EV | BOARD EVALUATION 345MHZ RFM RFIC |
| GSCA06S3 | SWITCH ROTARY SIDE |
| DR-TRC105-315-EV | BOARD EVALUATION 315MHZ RFM RFIC |
| DR-TRC105-304-EV | BOARD EVALUATION 304MHZ RFM RFIC |
| GSCA06S2 | SWITCH ROTARY SIDE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DR-TRC105-390-DK | 功能描述:射频开发工具 TRC105 Development Kit 382-398 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-390-EV | 功能描述:射频开发工具 TRC105 Evaluation Board 382-398 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-403-DK | 功能描述:射频开发工具 TRC105 Development Kit 402-407 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-403-EV | 功能描述:射频开发工具 TRC105 Evaluation Board 402-407 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-434-DK | 功能描述:射频开发工具 TRC105 Development Kit 416-436 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
发布紧急采购，3分钟左右您将得到回复。