参数资料
型号: DR-TRC105-372-EV
厂商: RFM
文件页数: 49/67页
文件大小: 0K
描述: BOARD EVALUATION 372MHZ RFM RFIC
标准包装: 1
类型: 收发器
频率: 365MHz ~ 380MHz
适用于相关产品: TRC105
已供物品: 2 个板,天线,电池
Pattern of Bits 3..1
000
001
010
011
100
101
110
111
Transmitter Power
13 dBm
10 dBm
7 dBm
4 dBm
1 dBm
-2 dBm
-5 dBm
-8 dBm
Table 60
The highest power setting allowed under the governing radio regulations is usually chosen unless the application
operates at short range and minimum DC power consumption is critical.
6.3 Determining Configuration Values for OOK Modulation
6.3.1 Bit Rate Related OOK Configuration Values
The TRC105 supports RF bit rates (data rates) from 1.5625 to 33.33 kb/s for OOK modulation. As with FSK mod-
ulation, there are several considerations in choosing an OOK data rate. The sensitivity of the TRC105 decreases
with increasing bit rate. A bit rate should be chosen that is adequate but not higher than the application requires.
The exception to this rule is when the TRC105 is operated as a frequency hopping spread spectrum transceiver in
a noisy or crowded band. Running at a higher bit rate will allow a higher channel hopping rate, which provides
more robust operation in a crowded band in tradeoff for less range under quiet band conditions.
The TRC105 RF bit rate is set by the value of the bytes loaded in MCFG03 and MCFG04 . For the standard crys-
tal frequency of 12.8 MHz:
BR = 12800/(2*(C+1)*(D + 1)), with C in the range of 0 to 255, and D = 31 (default value)
Where BR is the bit rate in kb/s, F XTAL the crystal frequency in kHz, C the value in MCFG03, and D is the value in
MCFG04 . This bit rate value supports both the data and clock recovery circuit in the receiver and the bit rate
clocking in the transmitter modulator. Using the default value of D and solving the equation above for C:
C = (12800 - 64*BR)/64*BR
C must be an integer value, so BR is limited to 256 discrete values. If the value of C given in the above equation
is not an integer for your desired bit rate, round the value of C down to the nearest integer. You can then calculate
the nearest available bit rate equal to or greater than your desired bit rate.
In OOK mode, the second IF frequency F IF2 is normally set to 100 kHz. The discussion in the rest of this section
assumes F IF2 is 100 kHz.
Once BR and F IF2 has been determined, the bandwidths and related configuration values for the TRC105 filters
can be determined. The recommended 3 dB bandwidth for the transmitter anti-aliasing filters is:
F CTX = 3*F IF2 = 300 kHz
F CTX is configured with bits 7..4 in TXCFG1A . For the standard crystal frequency of 12.8 MHz:
F CTX = 200*(K + 1)/8, with K in the range of 0 to 15
Where F CTX is the 3 dB bandwidth of the transmitter anti-aliasing filters in kHz and K is the integer value of the bit
pattern in TXCFG1A bits 7..4. The equation for determining K is:
www.RFM.com E-mail: info@rfm.com
? 2009-2013 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 49 of 67
TRC105 - 05/29/13
相关PDF资料
PDF描述
DR-TRC105-345-EV BOARD EVALUATION 345MHZ RFM RFIC
GSCA06S3 SWITCH ROTARY SIDE
DR-TRC105-315-EV BOARD EVALUATION 315MHZ RFM RFIC
DR-TRC105-304-EV BOARD EVALUATION 304MHZ RFM RFIC
GSCA06S2 SWITCH ROTARY SIDE
相关代理商/技术参数
参数描述
DR-TRC105-390-DK 功能描述:射频开发工具 TRC105 Development Kit 382-398 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-390-EV 功能描述:射频开发工具 TRC105 Evaluation Board 382-398 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-403-DK 功能描述:射频开发工具 TRC105 Development Kit 402-407 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-403-EV 功能描述:射频开发工具 TRC105 Evaluation Board 402-407 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-434-DK 功能描述:射频开发工具 TRC105 Development Kit 416-436 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V