- 您现在的位置：买卖IC网 > PDF目录1994 > DS2415P+T&R (Maxim Integrated Products)IC TIME CHIP 1-WIRE 6-TSOC PDF资料下载
参数资料
| 型号： | DS2415P+T&R |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 12/14页 |
| 文件大小： | 0K |
| 描述： | IC TIME CHIP 1-WIRE 6-TSOC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 4,000 |
| 类型： | 二进制计数器 |
| 特点： | 唯一 ID |
| 时间格式： | 二进制 |
| 数据格式： | 二进制 |
| 接口： | 1 线 串行 |
| 电源电压： | 2.5 V ~ 5.5 V |
| 电压 - 电源，电池： | 2.5 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-LSOJ |
| 供应商设备封装： | 6-TSOC |
| 包装： | 带卷 (TR) |
DS2415
7 of 14
HARDWARE CONFIGURATION Figure 6
1-WIRE BUS SYSTEM
The 1-Wire bus is a system that has a single bus master and one or more slaves. In all instances the
DS2415 behaves as a slave. The discussion of this bus system is broken down into three topics: hardware
configuration, transaction sequence, and 1-Wire signaling (signal types and timing). A 1-Wire protocol
defines bus transactions in terms of the bus state during specified time slots that are initiated on the falling
edge of sync pulses from the bus master. For a more detailed protocol description, refer to Chapter 4 of
the Book of DS19xx iButton Standards.
Hardware Configuration
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain or 3-state outputs. The 1-Wire input of the DS2415 is open drain with an internal circuit equivalent
to that shown in Figure 6. A multidrop bus consists of a 1-Wire bus with multiple slaves attached. The 1-
Wire bus has a maximum data rate of 16.3kbits per second and requires a pullup resistor of approximately
5k
W.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus
must be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low
for more than 120
ms, one or more of the devices on the bus may be reset. Since the DS2415 gets all its
energy for operation through its VBAT pin it will not perform a power-on reset if the 1-Wire bus is low for
an extended time period.
Transaction Sequence
The protocol for accessing the DS2415 via the 1-Wire port is as follows:
§ Initialization
§ ROM Function Command
§ Clock Function Command
相关PDF资料 |
PDF描述 |
|---|---|
| DS2417X/T&R | IC TIMECHIP W/INTRPT 1WIRE CSP |
| DS26502LN+ | IC T1/E1/J1 64KCC ELEMENT 64LQFP |
| DS26503LN+ | IC T1/E1/J1 BITS ELEMENT 64-LQFP |
| DS3105LN+ | IC TIMING LINE CARD 64-LQFP |
| DS3106LN+ | IC TIMING LINE CARD 64-LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2415P-W | 功能描述:实时时钟 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| DS2415V | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:1-Wire Time Chip |
| DS2415X | 功能描述:IC TIME CHIP 1-WIRE CSP RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 实时时钟 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- 类型:时钟/日历 特点:警报器，闰年，SRAM 存储容量:- 时间格式:HH:MM:SS（12/24 小时） 数据格式:YY-MM-DD-dd 接口:SPI 电源电压:2 V ~ 5.5 V 电压 - 电源，电池:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-WDFN 裸露焊盘 供应商设备封装:8-TDFN EP 包装:管件 |
| DS2416FP00K | 制造商:Thomas & Betts 功能描述:200A,CON,3P4W,MG,416,3P208V,CC |
| DS2416FR000 | 制造商:Thomas & Betts 功能描述:200A,REC,3P4W,MG,416,3P208V,SC |
发布紧急采购，3分钟左右您将得到回复。