参数资料
型号: DS2450S+
厂商: Maxim Integrated Products
文件页数: 3/25页
文件大小: 0K
描述: IC CONVERTER A/D QUAD 1-W 8-SOIC
产品培训模块: 1-Wire Communications
Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
产品变化通告: Product Discontinuation 27/Jul/12
标准包装: 88
位数: 16
采样率(每秒): 1k
数据接口: 串行
转换器数目: 1
功率耗散(最大): 2.5mW
电压电源: 单电源
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.209",5.30mm 宽)
供应商设备封装: 8-SOIC
包装: 管件
输入数目和类型: 4 个单端,单极
产品目录页面: 1429 (CN2011-ZH PDF)
DS2450
11 of 24
With VCC power supply the bus master may either send a reset pulse to exit the Convert command or
continuously generate read data time slots. As long as the DS2450 is busy with conversions the bus
master will read 0’s. After the conversion is completed the bus master will receive 1’s instead. Since in a
open-drain environment a single 0 overwrites multiple 1’s the bus master can monitor multiple devices
converting simultaneously and immediately knows when the last one is ready. As in the parasitically
powered scenario the bus master finally has to exit the Convert command by issuing a rest pulse.
1-WIRE BUS SYSTEM
The 1-Wire bus is a system which has a single bus master and one or more slaves. In all instances the
DS2450 is a slave device. The discussion of this bus system is broken down into three topics: hardware
configuration, transaction sequence, and 1-Wire signaling (signal types and timing). A 1-Wire protocol
defines bus transactions in terms of the bus state during specific time slots that are initiated on the falling
edge of sync pulses from the bus master. For a more detailed protocol description, refer to Chapter 4 of
the Book of DS19xx iButton Standards.
HARDWARE CONFIGURATION
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain or 3-state outputs. The 1-Wire port of the DS2450 is open drain with an internal circuit equivalent
to that shown in Figure 8. A multidrop bus consists of a 1-Wire bus with multiple slaves attached. At
regular speed the 1-Wire bus has a maximum data rate of 16.3k bits per second. The speed can be
boosted to 142k bits per second by activating the Overdrive Mode. The 1-Wire bus requires a pullup
resistor of approximately 5kΩ at regular speed or maximum 2.2kΩ at Overdrive speed for
communication. During A/D conversions the bus master must provide a strong pullup to 5V to supply
sufficient energy if the DS2450 is powered entirely from the 1-Wire bus.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus
MUST be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low
for more than 16 μs (Overdrive Speed) or more than 120 μs (regular speed), one or more devices on the
bus may be reset.
HARDWARE CONFIGURATION
Figure 8
SEE TEXT
相关PDF资料
PDF描述
MC100LVEP16DTG IC RECEIVER/DRVR ECL DIFF 8TSSOP
DS3150Q IC LIU T3/E3/STS-1 28-PLCC
VE-26W-IU-F1 CONVERTER MOD DC/DC 5.5V 200W
NB7VPQ16MMNTXG IC COPPER/CABLE DVR PROG 16-QFN
MS27473E12F98PB CONN PLUG 10POS STRAIGHT W/PINS
相关代理商/技术参数
参数描述
DS2450S/T&R 功能描述:模数转换器 - ADC RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32
DS2450S+ 功能描述:模数转换器 - ADC Quad 1-Wire RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32
DS2450S+ 制造商:Maxim Integrated Products 功能描述:SEMICONDUCTOR ((NW))
DS2450S+T&R 制造商:Maxim Integrated Products 功能描述:IC CONVERTER A/D QUAD 1-W 8-SOIC
DS2450S+T&R 功能描述:模数转换器 - ADC Quad 1-Wire RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32