收藏本站
参数资料
型号： EFM32-TG822F32-SK
厂商： Energy Micro
文件页数： 61/136页
文件大小： 0K
描述： IC MICRO KIT GECKO 48LQFP
标准包装： 1
系列： Tiny Gecko
套件类型： 微控制器
值： 2 件 - 闪存 - 32KB
包装： 纸板盒
安装类型： 表面贴装
包括封装： 48-LQFP
其它名称： 914-1023
...the world's most energy friendly microcontrollers
2011-02-04 - d0002_Rev1.00
30
www.energymicro.com
Table 2.18. Fault status and fault address registers
Handler
Status register
name
Address register
name
Register description
Hard fault
HFSR
-
Section 4.3.12 (p. 109)
Memory management
fault
MMFSR
MMFAR
Section 4.3.11.1 (p. 105)
Section 4.3.13 (p. 110)
Bus fault
BFSR
BFAR
Section 4.3.11.2 (p. 107)
Section 4.3.14 (p. 110)
Usage fault
UFSR
-
Section 4.3.11.3 (p. 108)
2.4.4 Lockup
The processor enters a lockup state if a hard fault occurs when executing the NMI or hard fault handlers.
When the processor is in lockup state it does not execute any instructions. The processor remains in
lockup state until either:
it is reset
an NMI occurs.
Note
If lockup state occurs from the NMI handler a subsequent NMI does not cause the
processor to leave lockup state.
2.5 Power management
The Cortex-M3 processor sleep modes reduce power consumption:
Sleep mode (Energy Mode 1) stops the processor clock
Deep sleep mode (Energy Mode 2/3) stops the high frequency oscillators and HFPERCLK/
HFCORECLK as well as flash memory.
The SLEEPDEEP bit of the SCR selects which sleep mode is used, see Section 4.3.7 (p. 100) . For
more information about the behavior of the sleep modes see the EMU documentation in the reference
manual for the device.
This section describes the mechanisms for entering sleep mode, and the conditions for waking up from
sleep mode.
2.5.1 Entering sleep mode
This section describes the mechanisms software can use to put the processor into sleep mode.
The system can generate spurious wakeup events, for example a debug operation wakes up the
processor. Therefore software must be able to put the processor back into sleep mode after such an
event. A program might have an idle loop to put the processor back to sleep mode.
2.5.1.1 Wait for interrupt
The wait for interrupt instruction, WFI, causes immediate entry to sleep mode. When the processor
executes a WFI instruction it stops executing instructions and enters sleep mode. See Section 3.10.12 (p.
86) for more information.
2.5.1.2 Wait for event
The wait for event instruction, WFE, causes entry to sleep mode conditional on the value of an one-bit
event register. When the processor executes a WFE instruction, it checks this register:
相关PDF资料
PDF描述
EFM32-TG222F32-SK IC MICRO KIT GECKO 48LQFP
EFM32-TG230F32-SK IC MICRO KIT GECKO 64QFN
EFM32-TG210F32-SK IC MICRO KIT GECKO 32QFN
1267 X 6" TAPE ALUMINUM FOIL 6" X 1FT
7810 0.25MM ECAP COND PAD .25MM 7.7" X 10"
相关代理商/技术参数
参数描述
EFM32TG822F32-T 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 48TQFP
EFM32TG822F8 功能描述:ARM微控制器 - MCU 8KB Flash 2KB RAM RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
EFM32TG822F8-QFP48 制造商:Energy Micro AS 功能描述:TINY GECKO MCU - Tape and Reel 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 8KB FLASH 48TQFP
EFM32TG822F8-QFP48T 制造商:Energy Micro AS 功能描述:32 BIT ARM MPU, TINY GECKO - Trays
EFM32TG822F8-QFP48-T 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 8KB FLASH 48TQFP
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*