- 您现在的位置：买卖IC网 > PDF目录18734 > EM260-RTY (Silicon Laboratories Inc)IC ZIGBEE SYSTEM-ON-CHIP 40-QFN PDF资料下载
参数资料
| 型号： | EM260-RTY |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 24/50页 |
| 文件大小： | 0K |
| 描述： | IC ZIGBEE SYSTEM-ON-CHIP 40-QFN |
| 标准包装： | 429 |
| 频率： | 2.4GHz |
| 数据传输率 - 最大： | 250kbps |
| 调制或协议： | 802.15.4 |
| 应用： | ZigBee? |
| 功率 - 输出： | -32dBm ~ 3dBm |
| 灵敏度： | -97dBm |
| 电源电压： | 2.1 V ~ 3.6 V |
| 电流 - 接收： | 30mA |
| 电流 - 传输： | 34mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 40-VFQFN 裸露焊盘 |
| 包装： | 托盘 |
| 其它名称： | 636-1003 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
EM260
5.2.5
Spacing
To ensure that the EM260 is always able to deal with incoming commands, a minimum inter-command spacing
is defined at 1ms. After every transaction, the Host must hold the Slave Select high for a minimum of 1ms.
The Host must respect the inter-command spacing requirement, or the EM260 will not have time to operate on
the command; additional commands could result in error conditions or undesired behavior. If the nHOST_INT
signal is not already asserted, the Host is allowed to use the Wake handshake instead of the inter-command
spacing to determine if the EM260 is ready to accept a command.
5.2.6
Waking the EM260 from Sleep
Waking up the EM260 involves a simple handshaking routine as illustrated in Figure 6. This handshaking insures
that the Host will wait until the EM260 is fully awake and ready to accept commands from the Host. If the
EM260 is already awake when the handshake is performed (such as when the Host resets and the EM260 is
already operating), the handshake will proceed as described below with no ill effects.
Note: A wake handshake cannot be performed if nHOST_INT is already asserted.
Note: nWAKE should not be asserted after the EM260 has been reset until the EM260 has fully booted, as
indicated by the EM260 asserting nHOST_INT. If nWAKE is asserted during this boot time, the EM260 may enter
bootloader mode. See section 5.6.1, Bootloading the EM260.
nWAKE
nHOST_INT
Figure 6. EM260 Wake Sequence
Waking the EM260 involves the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
Host asserts nWAKE.
EM260 interrupts on nWAKE and exits sleep.
EM260 performs all operations it needs to and will not respond until it is ready to accept commands.
EM260 asserts nHOST_INT within 300ms of nWAKE asserting. If the EM260 does not assert nHOST_INT
within 300ms of nWAKE, it is valid for the Host to consider the EM260 unresponsive and to reset the
EM260.
Host detects nHOST_INT assertion. Since the assertion of nHOST_INT indicates the EM260 can accept SPI
transactions, the Host does not need to hold Slave Select high for the normally required minimum 1ms of
inter-command spacing.
Host deasserts nWAKE after detecting nHOST_INT assertion.
EM260 will deassert nHOST_INT within 25 μ s of nWAKE deasserting.
After 25 μ s, any change on nHOST_INT will be an indication of a normal asynchronous (callback) event.
5.2.7
Error Conditions
If two or more different error conditions occur back to back, only the first error condition will be reported to
the Host (if it is possible to report the error). The following are error conditions that might occur with the
EM260.
Unsupported SPI Command: If the SPI Byte of the command is unsupported, the EM260 will drop the incoming
command and respond with the Unsupported SPI Command Error Response. This error means the SPI Byte is
120-0260-000M Rev 1.1
Page 24
相关PDF资料 |
PDF描述 |
|---|---|
| DP1205C915 | MODULE DROP IN FOR XE1205 915MHZ |
| DP1205C868 | MODULE DROP IN FOR XE1205 868MHZ |
| DP1205C433 | MODULE DROP IN FOR XE1205 433MHZ |
| LP0603A1747ANTR | FILTER LOW PASS 1747MHZ 0603 SMD |
| DP1203C9153LF | MODULE DROP IN FOR XE1203 915MHZ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EM260-USART-JMP-R | 功能描述:KIT JUMP START FOR EM260 RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件，板 系列:JumpStart 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796 |
| EM2630-12# | 制造商:Fluke Electronics 功能描述:BNC (F) TO ALLIGATOR CLIPS 12 INCHES 制造商:Pomona Electronics 功能描述: |
| EM-26392-C36 | 功能描述:麦克风 3.61 X 3.61 X 2.21MM -51 SENS, 12SL PORT RoHS:否 制造商:Knowles Acoustics 方向性:Omnidirectional 阻抗:4.4 K Ohms 工作电压:0.9 V to 10 V 灵敏度:- 53 dB 端接类型:Wire Leads 长度:5.56 mm 宽度:3.98 mm 深度:2.21 mm |
| EM-26596-C36 | 功能描述:麦克风 3.61 X 3.61 X 2.21MM -52 SENS, 12B PORT RoHS:否 制造商:Knowles Acoustics 方向性:Omnidirectional 阻抗:4.4 K Ohms 工作电压:0.9 V to 10 V 灵敏度:- 53 dB 端接类型:Wire Leads 长度:5.56 mm 宽度:3.98 mm 深度:2.21 mm |
| EM-26596-D58 | 功能描述:麦克风 3.61 X 3.61 X 2.21MM -52 SENS, 12B PORT RoHS:否 制造商:Knowles Acoustics 方向性:Omnidirectional 阻抗:4.4 K Ohms 工作电压:0.9 V to 10 V 灵敏度:- 53 dB 端接类型:Wire Leads 长度:5.56 mm 宽度:3.98 mm 深度:2.21 mm |
发布紧急采购，3分钟左右您将得到回复。