- 您现在的位置：买卖IC网 > PDF目录19910 > EPC4QC100N (Altera)IC CONFIG DEVICE 4MBIT 100-PQFP PDF资料下载
参数资料
| 型号： | EPC4QC100N |
| 厂商： | Altera |
| 文件页数： | 36/36页 |
| 文件大小： | 0K |
| 描述： | IC CONFIG DEVICE 4MBIT 100-PQFP |
| 产品培训模块： | Three Reasons to Use FPGA's in Industrial Designs |
| 标准包装： | 66 |
| 系列： | EPC |
| 可编程类型： | 系统内可编程 |
| 存储容量： | 4Mb |
| 电源电压： | 3 V ~ 3.6 V |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 100-BQFP |
| 供应商设备封装： | 100-PQFP（14x20） |
| 包装： | 托盘 |
| 产品目录页面： | 604 (CN2011-ZH PDF) |
| 其它名称： | 544-1378 EPC4QC100N-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页
Functional Description
Page 9
Enhanced Configuration (EPC) Devices Datasheet
January 2012
Altera Corporation
Finally, the configuration controller also manages errors during configuration. A
CONF
_DONE error occurs when the FPGA does not de-assert its CONF_DONE signal within
64 DCLK cycles after the last bit of configuration data is transmitted. When a CONF_DONE
error is detected, the controller pulses the OE line low, which pulls the nSTATUS signal
low and triggers another configuration cycle.
A cyclic redundancy check (CRC) error occurs when the FPGA detects corruption in
the configuration data. This corruption could be a result of noise coupling on the
board such as poor signal integrity on the configuration signals. When this error is
signaled by the FPGA (by driving the nSTATUS signal low), the controller stops
configuration. If the Auto-Restart Configuration After Error option is enabled in the
FPGA, it releases its nSTATUS signal after a reset time-out period and the controller
attempts to reconfigure the FPGA.
After the FPGA configuration process is complete, the controller drives the DCLK pin
low and the DATA[] pins high. Additionally, the controller tri-states its internal
interface to the flash memory, enables the weak internal pull-ups on the flash address
and control lines, and enables bus-keep circuits on flash data lines.
The following sections describe the different configuration schemes supported by the
EPC device—FPP, PS, and concurrent configuration schemes.
f For more information, refer to the configuration chapter in the appropriate device
handbook.
Configuration Signals
Table 4 lists the configuration signal connections between the EPC device and Altera
FPGAs.
Table 4. Configuration Signals
EPC Device Pin
Altera FPGA Pin
Description
DATA[]
Configuration data transmitted from the EPC device to the
FPGA, which is latched on the rising edge of DCLK.
DCLK
EPC device generated clock used by the FPGA to latch
configuration data provided on the DATA[] pins.
nINIT_CONF,
which
nCONFIG
Open-drain output from the EPC device that is used to
start FPGA reconfiguration using the initiate configuration
(INIT_CONF) JTAG instruction. This connection is not
needed if the INIT_CONF JTAG instruction is not needed.
If nINIT_CONF is not connected to nCONFIG, nCONFIG
must be tied to VCC either directly or through a pull-up
resistor.
OE
nSTATUS
Open-drain bidirectional configuration status signal,
which is driven low by either the EPC device or FPGA
during POR and to signal an error during configuration.
Low pulse on OE resets the EPC device controller.
nCS
CONF_DONE
Configuration done output signal driven by the FPGA.
相关PDF资料 |
PDF描述 |
|---|---|
| V24C48H100BL | CONVERTER MOD DC/DC 48V 100W |
| XCF01SVO20C | IC PROM IN SYST PRG 3.3V 20TSSOP |
| HSC36DREH-S93 | CONN EDGECARD 72POS .100 EYELET |
| EBM15DCCS | CONN EDGECARD 30POS R/A .156 SLD |
| EPC2TC32N | IC CONFIG DEVICE 1.6MBIT 32-TQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EPC4QI100 | 功能描述:FPGA-配置存储器 IC - Ser. Config Mem Flash 4Mb 66 MHz RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| EPC4QI100N | 功能描述:FPGA-配置存储器 IC - Ser. Config Mem Flash 4Mb 66 MHz RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| EPC4XXX | 制造商:ALTERA 制造商全称:Altera Corporation 功能描述:2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
| EPC50C605 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| EPC-525-0.5 | 制造商:EPIGAP 制造商全称:EPIGAP 功能描述:Photodiode-Chip |
发布紧急采购，3分钟左右您将得到回复。