- 您现在的位置：买卖IC网 > PDF目录97935 > EVB3020A-IFBD GSM Multiband RF Transceiver PDF资料下载
参数资料
| 型号： | EVB3020A-IFBD |
| 英文描述： | GSM Multiband RF Transceiver |
| 中文描述： | 手机多频段射频收发器 |
| 文件页数： | 25/44页 |
| 文件大小： | 409K |
| 代理商： | EVB3020A-IFBD |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页
Advance Data Sheet
December 1999
W3020 GSM Multiband RF Transceiver
Lucent Technologies Inc.
31
Programming Information (continued)
Filter Tune and dc Offset Correction Timing
Low-Pass Filter Tuning
The W3020 has an internal calibration to improve the accuracy of the low-pass filter bandwidth. The filter tune
operation should be performed each time supply voltage is applied to the device and after restart.
The low-pass filter tuning operation is controlled by 3 bits in the control logic:
n
FTR: filter tune request, in the TR register
n
C4: low-pass filter bandwidth, in the CONFIG register
n
C6: filter tune disable, in the CONFIG register
If the filter tune disable bit (C6) is programmed high, the filter bandwidth is set to the programmed (nominal)
value (see Table 35), and any request for filter tuning from the FTR bit is ignored.
The accuracy of the filter bandwidth can be improved by performing a filter tune calibration. A filter tune can be
performed by setting the filter tune request (FTR) bit in the TR register high and the filter tune disable bit (C6) in
the CONFIG register low. This enables a 13/4 MHz (3.25 MHz) clock to the filter tuning state machine, which
then runs until the tuning is complete and the new filter tune values are stored. The filter tune operation itself
takes
16.5 cycles of the 3.25 MHz clock, or 5.1
s.
The filter tune operation should be done in receive mode. The receive mode needs to be held active for at least
20
s to allow for bias start-up.
The dc offset calibration, if requested, is performed after the filter tune is complete. The filter tune operation adds
5.1
s to the total calibration time when requested at the same time as a dc offset calibration. If a filter tune is
requested while the MOD bits are not set to 111, only the receive bias circuitry is turned on; the rest of the
receive channel remains powered down.
相关PDF资料 |
PDF描述 |
|---|---|
| EVB3030A | W3030 3 V Dual-Mode IF Cellular Receiver |
| EVB72001 | EVB72001 EValuation board for TH72001 |
| EVB72002 | EVB72002 EValuation Board for TH72002 |
| EVB72011 | EVB72011 EValuation Board for TH72011 |
| EVB72012 | EVB72012 EValuation Board for TH72012 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EVB3030A | 制造商:AGERE 制造商全称:AGERE 功能描述:W3030 3 V Dual-Mode IF Cellular Receiver |
| EVB-3250 | 功能描述:界面开发工具 Evaluation Board RoHS:否 制造商:Bourns 产品:Evaluation Boards 类型:RS-485 工具用于评估:ADM3485E 接口类型:RS-485 工作电源电压:3.3 V |
| EVB32-M8L | 制造商:Leviton Manufacturing Co 功能描述: |
| EVB-3300 | 功能描述:界面开发工具 USB3300 Hi-Speed USB Phy Evaluation Board RoHS:否 制造商:Bourns 产品:Evaluation Boards 类型:RS-485 工具用于评估:ADM3485E 接口类型:RS-485 工作电源电压:3.3 V |
| EVB-3500 | 功能描述:界面开发工具 Evaluation Board RoHS:否 制造商:Bourns 产品:Evaluation Boards 类型:RS-485 工具用于评估:ADM3485E 接口类型:RS-485 工作电源电压:3.3 V |
发布紧急采购，3分钟左右您将得到回复。