参数资料
型号: FT245RL-REEL
厂商: FTDI, Future Technology Devices International Ltd
文件页数: 15/37页
文件大小: 0K
描述: IC USB TO PARALLEL FIFO 28-SSOP
产品培训模块: USB Introduction
标准包装: 1
应用: USB 至 FIFO 控制器
接口: USB,FIFO,(同步/异步)
电源电压: 1.8 V ~ 5.25 V
封装/外壳: 28-SSOP(0.209",5.30mm 宽)
供应商设备封装: 28-SSOP
包装: 标准包装
安装类型: 表面贴装
产品目录页面: 634 (CN2011-ZH PDF)
配用: 768-1020-ND - MOD USB PARALLEL FIFO DEV FT245R
其它名称: 768-1011-6
Copyright 2010 Future Technology Devices International Limited
22
Document No.: FT_000052
FT245R USB FIFO IC Datasheet Version 2.12
Clearance No.: FTDI# 39
7 USB Power Configurations
The following sections illustrate possible USB power configurations for the FT245R. The illustrations have
omitted pin numbers for ease of understanding since the pins differ between the FT245RL and FT245RQ
package options.
All USB power configurations illustrated apply to both package options for the FT245R device. Please refer
to Section 3 for the package option pin-out and signal descriptions.
7.1 USB Bus Powered Configuration
FT245R
GND
100nF
VCC
USBDM
USBDP
VCCIO
NC
RESET#
NC
OSCI
OSCO
3V3OUT
A
G
N
D
G
N
D
G
N
D
G
N
D
T
E
S
T
Vcc
1
2
3
4
GND
SHIELD
GND
VCC
100nF
4.7uF
+
5
10nF
Ferrite
Bead
D0
D1
D2
D3
D4
D5
D6
D7
RXF#
TXE#
RD#
WR
PWREN#
Vcc
10K
Figure 7.1 Bus Powered Configuration
Figure 7.1 illustrates the FT245R in a typical USB bus powered design configuration. A USB bus powered
device gets its power from the USB bus. Basic rules for USB bus power devices are as follows –
i)
On plug-in to USB, the device should draw no more current than 100mA.
ii)
In USB Suspend mode the device should draw no more than 2.5mA.
iii)
A bus powered high power USB device (one that draws more than 100mA) should use the
PWREN# to keep the current below 100mA on plug-in and 2.5mA on USB suspend.
iv)
A device that consumes more than 100mA cannot be plugged into a USB bus powered hub.
v)
No device can draw more than 500mA from the USB bus.
The power descriptors in the internal EEPROM of the FT245R should be programmed to match the current
drawn by the device.
A ferrite bead is connected in series with the USB power supply to reduce EMI noise from the FT245R and
associated circuitry being radiated down the USB cable to the USB host. The value of the Ferrite Bead
depends on the total current drawn by the application. A suitable range of Ferrite Beads is available from
Steward (www.steward.com), for example Steward Part # MI0805K400R-10.
Note: If using PWREN#, the pin should be pulled to VCCIO using a 10kΩ resistor.
相关PDF资料
PDF描述
FT4232HQ-REEL IC USB HS QUAD UART/SYNC 64-QFN
FUSB1500MHX IC USB 2.0 TRANSCEIVER 16-MLP
FUSB2805MLX TXRX USB2.0 HS OTG ULPI 32MLP
FXLA2203UMX TRANSLATOR LEVEL DUAL 24UMLP
GAL16V8D-15LJN SPLD 62.5MHZ EECMOS 20 PLCC
相关代理商/技术参数
参数描述
FT245RL-TUBE 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB FIFO IC 28-Pin SSOP Tube
FT245RQ 制造商:Future Technology Devices International 功能描述:Single Chip USB 32-Pin QFN 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB TO FIFO SMD QFN-32 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB TO FIFO, SMD, QFN-32, 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB Full Speed to Parallel FIFO IC, Includes Oscillator and EEPROM - QFN-32 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB FIFO INTERFACE, QFN-32; USB Type:USB FIFO; USB Version:2.0; Supply Voltage Min:1.8V; Supply Voltage Max:5.25V; Digital IC Case Style:QFN; No. of Pins:32; Data Rate:1Mbps; No. of Ports:2; Operating Temperature Min:-40C ;RoHS Compliant: Yes
FT245RQ-6000 制造商:FTDI 制造商全称:FTDI 功能描述:USB FIFO IC - Single chip USB to parallel FIFO bidirectional data transfer interface
FT245RQ-REEL 功能描述:USB 接口集成电路 USB to Parallel FIFO Enhanced IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20
FT245RQ-TRAY 制造商:Future Technology Devices International (FTDI Chip) 功能描述:Single Chip USB Tray