- 您现在的位置：买卖IC网 > PDF目录68996 > FTF1100MF1 (INFINEON TECHNOLOGIES AG) SPECIALTY ANALOG CIRCUIT, XMA PDF资料下载
参数资料
| 型号： | FTF1100MF1 |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 模拟信号调理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, XMA |
| 文件页数： | 17/39页 |
| 文件大小： | 400K |
| 代理商： | FTF1100MF1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页
FingerTIP
Infineon Technologies
24/38
FTF 1100 MF1 V2.0 databook 3.3 (05.00)
4.3 SPI Protocol and Timing
The following figures 11a and 11b show the SPI protocol and timing for sending a
command and receiving the response. The timing parameters are shown in table 7 .
The FingerTIP must be selected, otherwise no commands will be accepted. To select
the sensor, first set SCK to low and than set Chip Select (/CS, low active) to low.
With the rising edge of the SCK, the sensor reads in the command data on the Serial Input
(SI). The command data format is 8-bit, starting with the LSB. With the 8
th clock cycle, the
MSB of the command data will be read in and the first bit (LSB) of the response will be
output with the falling edge. Every new clock cycle outputs a new bit of the response (8
bits long) with the falling edge of SCK. If the MSB is output, SO is set to low. After /CS is
set to high, Serial Output (SO) is set to tristate. Between a command and its response it is
not allowed to deselect the sensor. Deselecting the FingerTIP interrupts the
command/response sequence.
Before a new command can be sent by the master, the sensor must be deselected and
then selected again.
Figure 11: SPI Protocol and Timing: (a) Send a Command (b) Receive the Response
MSB OUT
LSB OUT
t
CYC
t
HO
t
WL
t
WH
SCK
(Master)
SO
(Sensor)
SI
(Master)
CS
(Master)
MSB IN
tristate
8
9
16
t
SO
t
CS
t
LAG
t
TRI
low
Receive Response
b)
SCK
SO
SI
CS
tristate
LSB IN
MSB IN
t
LEAD
t
SU
t
RI
t
FI
t
H
t
LCS
LSB OUT
(Master)
(Sensor)
(Master)
1
2
8
Send Command
a)
相关PDF资料 |
PDF描述 |
|---|---|
| FW100H9 | 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE |
| FW050H9 | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| FW150H | 1-OUTPUT 150 W DC-DC REG PWR SUPPLY MODULE |
| FW050H | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| FW100H | 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FTF1100MF1V2.0 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| FTF1100MF1V2.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| FTF3020-C | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Full Frame CCD Image Sensor |
| FTF3020-C/EG | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Full Frame CCD Image Sensor |
| FTF3020-C/HG | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Full Frame CCD Image Sensor |
发布紧急采购，3分钟左右您将得到回复。