- 您现在的位置：买卖IC网 > PDF目录371784 > HCS473PQTP (Microchip Technology Inc.) IC EEPROM SPI BUS 8KBIT 8-SOIC PDF资料下载
参数资料
| 型号： | HCS473PQTP |
| 厂商： | Microchip Technology Inc. |
| 英文描述： | IC EEPROM SPI BUS 8KBIT 8-SOIC |
| 中文描述： | 跳码编码器和转发器 |
| 文件页数： | 16/68页 |
| 文件大小： | 1629K |
| 代理商： | HCS473PQTP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页
HCS473
DS40035C-page 14
Preliminary
2002 Microchip Technology Inc.
3.1.4
ENCODER MODE OPTIONS
The following HCS473 configuration options configure
transmission characteristics of the information exiting
the DATA pin:
Modulation select (MSEL)
Header select (HSEL)
Extended serial number (XSER)
Queue counter enable (QUEN)
Counter select (CNTSEL)
Low voltage trip point (VLOWSEL)
PLL interface select (AFSK)
RF enable output (RFEN)
Seed button code (SDBT)
Time before Seed (SDTM)
Limited Seed (SDLM)
Seed mode (SDMD)
RF baud rate select (RFBSL)
Guard time select (GSEL)
Minimum code words (MTX)
Timeout select (TSEL)
Long preamble enable (LPRE)
Long preamble length (LPRL)
Preamble duty cycle (PRD)
The following sections detail each configuration’s avail-
able options. All timing values specified are subject to
the specified oscillator variation.
3.1.4.1
Modulation Format (MSEL)
The Modulation format option selects the modulation
format for data output from the DATA pin; most often
transmitted via RF.
MSEL options:
Pulse Width Modulation (PWM), Figure 3-3
Manchester Modulation, Figure 3-4
3.1.4.2
Header Select (HSEL)
The synchronization header is typically used by the
receiver to adjust bit sampling appropriate to the trans-
mitter’s current speed; as the transmitter’s RC oscilla-
tor varies with temperature and voltage, so will the
transmission’s timing.
HSEL options:
4 RF
TE
10 RF
TE
3.1.4.3
Extended Serial Number (XSER)
The Extended Serial Number option determines
whether the HCS473 transmits a 28 or 32-bit serial
number.
When configured for a 28-bit serial number, the Most
Significant nibble of the 32 bits reserved for the serial
number is replaced with a copy of the 4-bit button sta-
tus, Figure 3-2.
XSER options:
28-bit serial number
32-bit serial number
3.1.4.4
Queue Counter (QUEN)
The QUE counter can be used to request secondary
decoder functions using only a single transmitter but-
ton. Typically a decoder must keep track of incoming
transmissions to determine when a double button press
occurs, perhaps an unlock all doors request. The QUE
counter removes this burden from the decoder by
counting multiple button presses and including the
QUE counter value in the last two bits of the 69-bit code
word, (Figure 3-2). If QUEN is disabled, the transmis-
sion will consist only of 67 bits as the QUE bits field is
not transmitted.
Que counter functionality is enabled with the QUEN
configuration option. The 2-bit QUE counter is incre-
mented each time an active button input is released for
at least the Debounce Time (T
DB
), then re-activated
(button pressed again) within the Queue Time (T
QUE
),
Figure 3-5. The counter increments up from 0 to a max-
imum of 3, returning to 0 only after a different button
activation or after button activations spaced greater
than the Queue Time (T
QUE
) apart.
The current transmission aborts, after completing the
minimum number of code words (Section 3.1.4.15),
when the active button inputs are released. A button re-
activation within the queue time (T
QUE
) then initiates a
new transmission (new synchronization counter,
encrypted data) using the updated QUE value. Button
combinations are queued the same as individual but-
tons.
相关PDF资料 |
PDF描述 |
|---|---|
| HCS473PROM | IC EEPROM SPI BUS 32KBIT 8-SOIC |
| HCS473PSQTP | Code Hopping Encoder and Transponder |
| HCS473SLQTP | Code Hopping Encoder and Transponder |
| HCS473SLROM | Code Hopping Encoder and Transponder |
| HCS473SLSQTP | Code Hopping Encoder and Transponder |
相关代理商/技术参数 |
参数描述 |
|---|---|
| HCS473-PQTP | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Code Hopping Encoder and Transponder |
| HCS473PROM | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Code Hopping Encoder and Transponder |
| HCS473-PROM | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Code Hopping Encoder and Transponder |
| HCS473PSQTP | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Code Hopping Encoder and Transponder |
| HCS473-PSQTP | 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Code Hopping Encoder and Transponder |
发布紧急采购，3分钟左右您将得到回复。