- 您现在的位置：买卖IC网 > PDF目录1924 > IDT82V2044EPFG (IDT, Integrated Device Technology Inc)IC LIU T1/E1 QUAD SHORT 128-TQFP PDF资料下载
参数资料
| 型号： | IDT82V2044EPFG |
| 厂商： | IDT, Integrated Device Technology Inc |
| 文件页数： | 16/73页 |
| 文件大小： | 0K |
| 描述： | IC LIU T1/E1 QUAD SHORT 128-TQFP |
| 标准包装： | 15 |
| 类型： | 线路接口装置（LIU） |
| 规程： | E1 |
| 电源电压： | 3.13 V ~ 3.47 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 128-LQFP |
| 供应商设备封装： | 128-TQFP（14x20） |
| 包装： | 托盘 |
| 其它名称： | 82V2044EPFG |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页
23
INDUSTRIAL
TEMPERATURE RANGES
QUAD CHANNEL T1/E1/J1 SHORT HAUL LINE INTERFACE UNIT
3.5
LOS AND AIS DETECTION
3.5.1
LOS DETECTION
The Loss of Signal Detector monitors the amplitude of the incoming sig-
nal level and pulse density of the received signal on RTIPn and RRINGn.
LOS declare (LOS=1)
A LOS is detected when the incoming signal has “no transitions”, i.e.,
when the signal level is less than Q dB below nominal for N consecutive
pulse intervals. Here N is defined by LAC bit (MAINT0, 0AH...). LOS will be
declared by pulling LOSn pin to high (LOS=1) and LOS interrupt will be gen-
erated if it is not masked.
LOS clear (LOS=0)
The LOS is cleared when the incoming signal has “transitions”, i.e.,
when the signal level is greater than P dB below nominal and has an aver-
age pulse density of at least 12.5% for M consecutive pulse intervals, start-
ing with the receipt of a pulse. Here M is defined by LAC bit (MAINT0,
0AH...). LOS status is cleared by pulling LOSn pin to low.
Figure-13 LOS Declare and Clear
LOS detect level threshold
With the Adaptive Equalizer off, the amplitude threshold Q is fixed on
800 mVpp, while P=Q+200 mVpp (200 mVpp is the LOS level detect hys-
teresis).
With the Adaptive Equalizer on, the value of Q can be selected by
LOS[4:0] bit (RCF1, 08H...), while P=Q+4 dB (4 dB is the LOS level detect
hysteresis). Refer to Table 33, “RCF1: Receiver Configuration Register 1,”
on page 40 for LOS[4:0] bit values available.
Criteria for declare and clear of a LOS detect
The detection supports the ANSI T1.231 and I.431 for T1/J1 mode and
G.775 and ETSI 300233/I.431 for E1 mode. The criteria can be selected
by LAC bit (MAINT0, 0AH...) and T1E1 bit (GCF0, 40H).
both with and without the Adaptive Equalizer enabled.
All Ones output during LOS
On the system side, the RDPn/RDNn will reflect the input pulse “transi-
tion” at the RTIPn/RRINGn side and output recovery clock (but the quality
of the output clock can not be guaranteed when the input level is lower than
the maximum receive sensitivity) when AISE bit (MAINT0, 0AH...) is 0; or
output All Ones as AIS when AISE bit (MAINT0, 0AH...) is 1. In this case
RCLKn output is replaced by MCLK.
On the line side, the TTIPn/TRINGn will output All Ones as AIS when
ATAO bit (MAINT0, 0AH...) is 1. The All Ones pattern uses MCLK as the
reference clock.
LOS indicator is always active for all kinds of loopback modes.
signal level<Q
(observing windows= N)
(observing windows= M)
signal level>P
density=OK
LOS=1
LOS=0
Table-13 LOS Declare and Clear Criteria, Adaptive Equalizer Disabled
Control bit
LOS declare threshold
LOS clear threshold
T1E1
LAC
1=T1/J1
0=T1.231
Level < 800 mVpp
N=175 bits
Level > 1 Vpp
M=128 bits
12.5% mark density
<100 consecutive zeroes
1=I.431
Level < 800 mVpp
N=1544 bits
Level > 1 Vpp
M=128 bits
12.5% mark density
<100 consecutive zeroes
0=E1
0=G.775
Level < 800 mVpp
N=32 bits
Level > 1 Vpp
M=32 bits
12.5% mark density
<16 consecutive zeroes
1=I.431/ETSI
Level < 800 mVpp
N=2048 bits
Level > 1 Vpp
M=32 bits
12.5% mark density
<16 consecutive zeroes
相关PDF资料 |
PDF描述 |
|---|---|
| IDT82V2048DAG | IC LIU T1/E1 8CH SHORT 144-TQFP |
| IDT82V2048EDR | IC LIU T1/E1 8CH SHORT 208-TQFP |
| IDT82V2048LBBG | IC LIU T1/E1 8CH SHORT 160-BGA |
| IDT82V2048SDAG | IC LIU T1/E1 8CH SHORT 144-TQFP |
| IDT82V2051EPPG | IC LIU E1 SGL SHORT HAUL 44-TQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IDT82V2044EPFG8 | 功能描述:IC LINE INTERFC UNIT 4CH 128TQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| IDT82V2048 | 制造商:IDT 制造商全称:Integrated Device Technology 功能描述:OCTAL T1/E1 SHORT HAUL LINE INTERFACE UNIT |
| IDT82V2048BB | 功能描述:IC LIU T1/E1 8CH SHORT 160-BGA RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| IDT82V2048BBG | 功能描述:IC LIU T1/E1 8CH SHORT 160-BGA RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| IDT82V2048DA | 功能描述:IC LIU T1/E1 8CH SHORT 144-TQFP RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。