参数资料
型号: IR3510MTRPBF
厂商: International Rectifier
文件页数: 10/36页
文件大小: 0K
描述: IC XPHASE CONTROL 32-MLPQ
标准包装: 1
系列: XPhase™
应用: 处理器
安装类型: 表面贴装
封装/外壳: 32-VFQFN 裸露焊盘
供应商设备封装: 32-MLPQ(5x5)
包装: 标准包装
产品目录页面: 1383 (CN2011-ZH PDF)
其它名称: IR3510MTRPBFDKR
IR3510
PIN FUNCTIONS
“VCC” (PIN#1): 12V bias voltage input for internal circuit . Connecting a 1uF decoupling cap is recommended.
“CX” (PIN#2): Charge-pump output. It is internally clamped to 27V typical and 29V max. Connecting a 0.1uF /
50V cap to GND is required.
“Enable” (PIN#3): Input FET and voltage regulator output enable input. It has two-level threshold. The lower level
threshold of 0.7V turns on the input FET. The higher level threshold of 1.2V turns on the voltage regulator output. It
has internal pull-up to 0.9V, so when it is float, it has the voltage above the lower level threshold and turns on input
FET. When it is pulled down, both input FET and voltage regulator output are turned off.
“VRRDY” (PIN#4): Open collector output indicating that the soft-start is completed and there is no fault. It requires
external pull-up.
“ORING” (PIN#5): Open collector output indicating Oring FET status. It requires external pull-up. HIGH indicates
the Oring FET is ON; LOW indicates the Oring FET is OFF.
“VSET” (PIN#6): Analog input setting the no-load output voltage. It is internally connected to the non-inverting
input of voltage error amplifier.
“OVPSET” (PIN#7): Analog input setting the Over-Voltage Protection threshold voltage. The internal OVP circuit
compares the voltage on the “OVPS” pin and the voltage on this pin to determine the OV condition.
“OCPSET” (PIN#8): Analog input setting the constant current limit. The internal constant current limit circuit limits
the “IO” pin voltage, which is the current report voltage, to be no more than the voltage set on this pin.
“SS” (PIN#9): Soft-start pin. Connect a capacitor to GND to set the soft-start time. An internal current source
flowing out of this pin charges the cap to a fixed threshold to set the soft-start time. It controls both the input FET
soft-start and the voltage regulator output voltage soft-start.
“IOCD” (PIN#10): Input FET fault indication output. Connect a capacitor to GND to program the input OCP delay
time. Any fault condition which results turning off the input FET, including input FET short, input OCP and output
OVP, will cause this pin be pulled HIGH.
“VOSNS-” (PIN#11): Negative remote sense input. It is internally connected to the inverting input of the differential
voltage sense amplifier.
“VOSNS+” (PIN#12): Positive remote sense input. It is internally connected to the non-inverting input of the
differential voltage sense amplifier.
“OVPSNS” (PIN#13): OVP sense input. It can be connected to “VO” pin if there is no feedback divider. If the
output voltage is higher than the “VSET” voltage, a feedback resistor divider is required, and this pin needs to be
connected to “VFB” pin. To disable internal OVP function, connecting this pin to GND.
“VO” (PIN#14): Remote sense voltage output. If the output voltage is higher than the “VSET” voltage, a feedback
resistor divider is required to be connected to this pin.
Page 10 of 36
IR Confidential
May 18, 2009
相关PDF资料
PDF描述
400LLE1R2MEFC8X9 CAP ALUM 1.2UF 400V 20% RADIAL
EEU-FR1C221B CAP ALUM 220UF 16V 20% RADIAL
TWR-MECH KIT TOWER ROBOT SENSOR MOTOR
NRS6012T100MMGJ INDUCTOR POWER 10UH 1.2A SMD
REC5-243.3DRWZ/H4/C CONV DC/DC 5W 9-36VIN +/-3.3V
相关代理商/技术参数
参数描述
IR3513MTRPBF 功能描述:开关变换器、稳压器与控制器 2 CH OR 2 PHASE SYNC PWM CNTRLR RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
IR3513XMTRPBF 功能描述:功率驱动器IC RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
IR3513Z 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM POL CONTROL IC
IR3513ZMPBF 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM POL CONTROL IC
IR3513ZMTRPBF 功能描述:开关变换器、稳压器与控制器 2 CH OR 2 PHASE SYNC PWM CNTRLR RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel