参数资料
型号: IRS2530DSPBF
厂商: International Rectifier
文件页数: 17/23页
文件大小: 0K
描述: IC BALLAST CTRL DIM 600V 8-SOIC
标准包装: 95
系列: DIM8™
类型: 镇流器控制器
频率: 34.2 ~ 115 kHz
电流 - 电源: 5mA
电流 - 输出: 260mA
电源电压: 12.5 V ~ 15.6 V
工作温度: -40°C ~ 125°C
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SOIC
包装: 管件
配用: IRPLDIM5E-ND - KIT DES BALLAST 4LEVEL DIM FLUOR
IRPLDIM4E-ND - KIT DES BALLAST 26W IRS2530D
IRPLCFL8U-ND - KIT DES FLUOR BALLAST IRS2530D
IRS2530D(S)
Component Selection
Proper design of the circuit schematic (see Typical Application Diagram, Page 1) and component selection is
important for achieving proper ballast functionality and preventing problems. The following design procedure
should be followed for determining the various programming and filtering component values:
1) Capacitor CPH programs the desired preheat/ignition time. CPH is charged up by an internal 1 μ A
current source at the VCO pin. The value of CPH is determined by:
C PH =
I VCO ? t PH / IGN
V VCOFLT
=
1 μ A ? t PH / IGN
4 V
2) Capacitor CVCO programs the speed of the dimming feedback loop. To ensure smooth and stable
dimming, CVCO should be small enough such that the dimming loop reacts to lamp current changes
each switching cycle. The value of CVCO is typically fixed for most lamp types and is given as:
C VCO = 2 . 2 nF
3) Resistor RVCO and capacitor CPH provide additional compensation of the dimming loop to prevent
the VCO voltage from changing too much over a given switching cycle. The value of RVCO is
typically fixed for most lamp types and is given as:
R VCO = 1 . 5 k Ω
4) Resistor RCS measures the lamp current for dimming. RCS should be kept small to minimize power
losses but the peak voltage across RCS at the lowest lamp current dimming level should be above a
minimum level to avoid noise problems. Using the minimum rms lamp current during dimming, a
minimum allowable peak voltage level across RCS of 100 mV, and an additional factor of 5 (signal
attenuation due to RFB and CDIM), the value of RCS is determined by:
R CS =
100 mV
I LAMP _ RMS _ MIN ? 2
× 5
Using the maximum rms lamp current, the power loss in resistor RCS is then determined by:
P LOSS _ RCS = ( I LAMP _ RMS _ MAX ) 2 × R CS
5) The additional feedback components include RFB for current limiting and noise filtering, CFB for DC
blocking, and CDIM for noise filtering. The value of these components are typically fixed for most
lamp types and are given as:
R FB = 1 k Ω
C FB = 0 . 1 μ F
C DIM = 10 nF
6) Capacitors CVCC2 and CBS are the low-side and high-side supply capacitors for maintaining their
respective supply voltages and providing high-frequency noise filtering. These capacitors are
typically fixed and are given as:
C VCC 2 = C BS = 0 . 1 μ F
www.irf.com
17
? 2008 International Rectifier
相关PDF资料
PDF描述
IRS2552DSPBF IC BALLAST CTLR CCFL/EEFL 16SOIC
IRS2573DSPBF IC BALLAST CNTRLLER 600V 28-SOIC
IRS27952SPBF IC DRIVER HALF-BRIDGE 8SOIC
IRSF3010S IC FET SMART SW 50V 11A D2PAK
IRSF3011LTR IC DRIVER LO SIDE 50V 5A SOT-223
相关代理商/技术参数
参数描述
IRS2530DSTRPBF 功能描述:功率驱动器IC Ballast Cntrl IC 600V .500A RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
IRS2530S 制造商:IRF 制造商全称:International Rectifier 功能描述:DIM8TM DIMMING BALLAST CONTROL IC
IRS2538DSPBF 制造商:IRF 制造商全称:International Rectifier 功能描述:Magnetic Replacement Ballast IC
IRS2538DSTRPBF 制造商:International Rectifier 功能描述:MAGNETIC REPLACEMENT BALLAST CONTROL PLUS HALF-BRIDGE DRIVER - Tape and Reel 制造商:International Rectifier 功能描述:IC DIMMING BALLAST CTRL 8-SOIC 制造商:International Rectifier 功能描述:T&R / Magnetic Replacement Ballast Control Plus Half-Bridge Driver
IRS2540 制造商:IRF 制造商全称:International Rectifier 功能描述:IRPLLED1 High Voltage LED Driver using the IRS2540